freebsd-dev/sys/mips/conf/AP135

#
# AP135 - the QCA955x SoC reference design
#
# This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi,
# 128MiB RAM, an AR8327 5-port gigabit ethernet switch and
# a QCA 11ac 5GHz AP NIC.
#
# The to things not currently support are the QCA 11ac NIC and
# PCIe host controllers - there's two of them, and the existing
# PCIe code here doesn't support that just yet.
#
# $FreeBSD$
#

#NO_UNIVERSE

# Include the default QCA955x parameters
include         "std.QCA955X"

ident           AP135

# Override hints with board values
hints           "AP135.hints"

# Force the board memory - the base AP135 has 128MB RAM
options         AR71XX_REALMEM=(128*1024*1024)

# i2c GPIO bus
#device		gpioiic
#device		iicbb
#device		iicbus
#device		iic

# Options required for miiproxy and mdiobus
options 	ARGE_MDIO	# Export an MDIO bus separate from arge
device		miiproxy	# MDIO bus <-> MII PHY rendezvous

device		etherswitch
device		arswitch

# read MSDOS formatted disks - USB
#options 	MSDOSFS

# Enable the uboot environment stuff rather then the
# redboot stuff.
options 	AR71XX_ENV_UBOOT

# uzip - to boot natively from flash
device		xz
options 	GEOM_UZIP

# Used for the static uboot partition map
device          geom_map

# yes, this board has a PCIe connected atheros device
# add ath_pci so it can at least attach things when there's a
# ath(4) in there, rather than the 11ac chip we don't support.
device		pci
device		qca955x_pci

device		firmware		# Used by the above
options 	AR71XX_ATH_EEPROM
options 	ATH_EEPROM_FIRMWARE

# Boot off of the rootfs, as defined in the geom_map setup.
options 	ROOTDEVNAME=\"ufs:map/rootfs.uzip\"