freebsd-dev/etc/rc.d/atm2

98 lines
2.5 KiB
Plaintext
Raw Normal View History

#!/bin/sh
#
# Copyright (c) 2000 The FreeBSD Project
# All rights reserved.
#
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
# 1. Redistributions of source code must retain the above copyright
# notice, this list of conditions and the following disclaimer.
# 2. Redistributions in binary form must reproduce the above copyright
# notice, this list of conditions and the following disclaimer in the
# documentation and/or other materials provided with the distribution.
#
# THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
# ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
# IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
# ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
# FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
# DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
# OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
# HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
# LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
# OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
# SUCH DAMAGE.
#
1999-08-27 23:37:10 +00:00
# $FreeBSD$
#
# PROVIDE: atm2
# REQUIRE: atm1 netif
# BEFORE: routing
# KEYWORD: nojail
#
# Additional ATM interface configuration
#
. /etc/rc.subr
name="atm2"
rcvar="atm_enable"
start_cmd="atm2_start"
stop_cmd=":"
atm2_start()
{
# Configure network interfaces
# get a list of physical interfaces
atm_phy=`atm show stat int | { read junk ; read junk ; \
while read dev junk ; do
case ${dev} in
en[0-9] | en[0-9][0-9])
;;
*)
echo "${dev} "
;;
esac
done ; }`
for phy in ${atm_phy}; do
eval netif_args=\$atm_netif_${phy}
set -- ${netif_args}
# skip unused physical interfaces
if [ $# -lt 2 ] ; then
continue
fi
netname=$1
netcnt=$2
netindx=0
while [ ${netindx} -lt ${netcnt} ]; do
net="${netname}${netindx}"
netindx=$((${netindx} + 1))
echo -n " ${net}"
# Configure atmarp server
eval atmarp_args=\$atm_arpserver_${net}
if [ -n "${atmarp_args}" ]; then
atm set arpserver ${net} ${atmarp_args} ||
continue
fi
done
done
echo '.'
# Define any permanent ARP entries.
if [ -n "${atm_arps}" ]; then
for i in ${atm_arps}; do
eval arp_args=\$atm_arp_${i}
atm add arp ${arp_args}
done
fi
}
load_rc_config $name
run_rc_command "$1"