diff --git a/sbin/camcontrol/camcontrol.8 b/sbin/camcontrol/camcontrol.8 index 94b96c5c977d..cf7aec25022d 100644 --- a/sbin/camcontrol/camcontrol.8 +++ b/sbin/camcontrol/camcontrol.8 @@ -2276,7 +2276,6 @@ These zones must be written sequentially. If they are not written sequentially, starting at the write pointer, the command will fail. .El -.Pp .Bl -tag -width 12n .It Fl c Ar cmd Specify the zone subcommand: @@ -2831,7 +2830,6 @@ This will read and decode the attribute values from partition 1 on the tape in tape drive sa0, and will display any .Tn SCSI errors that result. -.Pp .Bd -literal -offset indent camcontrol zone da0 -v -c rz -P summary .Ed @@ -2842,7 +2840,6 @@ summary of the zone parameters, and display any or .Tn ATA errors that result. -.Pp .Bd -literal -offset indent camcontrol zone da0 -v -c rz -o reset .Ed @@ -2853,7 +2850,6 @@ pointer reset from the disk da0, and display any or .Tn ATA errors that result. -.Pp .Bd -literal -offset indent camcontrol zone da0 -v -c rwp -l 0x2c80000 .Ed @@ -2864,7 +2860,6 @@ that starts at LBA 0x2c80000 and display any or .Tn ATA errors that result. -.Pp .Bd -literal -offset indent camcontrol epc ada0 -c timer -T 60.1 -p Idle_a -e -s .Ed @@ -2873,7 +2868,6 @@ Set the timer for the Idle_a power condition on drive .Pa ada0 to 60.1 seconds, enable that particular power condition, and save the timer value and the enabled state of the power condition. -.Pp .Bd -literal -offset indent camcontrol epc da4 -c goto -p Standby_z -H .Ed @@ -2885,7 +2879,6 @@ the drive's lowest power state) and hold in that state until it is explicitly released by another .Cm goto command. -.Pp .Bd -literal -offset indent camcontrol epc da2 -c status -P .Ed @@ -2903,7 +2896,6 @@ to only send the .Tn ATA CHECK POWER MODE command, which should not trigger a change in the drive's power state. -.Pp .Bd -literal -offset indent camcontrol epc ada0 -c list .Ed @@ -2911,7 +2903,6 @@ camcontrol epc ada0 -c list Display the ATA Power Conditions log (Log Address 0x08) for drive .Pa ada0 . -.Pp .Bd -literal -offset indent camcontrol timestamp sa0 -s -f "%a, %d %b %Y %T %z" \e -T "Wed, 26 Oct 2016 21:43:57 -0600"