determine IRQ and DRQ information.
Fix a bug that would cause us to attempt to retrieve extended sync
rate information on cards/firmware revs that do not support that command.
config info. On early revision cards (742a), the EISA register space,
other than the location used to determine the address of the card's main
command ports, is write only.
This code is backwards compatible with the older "microkernel" PLL, but
allows ntpd v4 to use nanosecond resolution. Many other improvements.
PPS_SYNC and hardpps() are NOT supported yet.
Also, unbreak the breakage introduced at the last revision of module.c.
This changes the semantics of mod_searchfile() (and mod_searchmodule())
to make the caller's responsibility freeing the buffer returned. This
is different from other functions in loader's code, and was done as a
fix for kern/9631. If someone wants to revert this to the original
behavior, don't forget to fix kern/9631 in another way.
This should also fix bin/10462, which was introduced as a result of the
first try at kern/9631 (module.c last revision).
PR: bin/10462
Submitted by: Takanori Saneto <sanewo@ba2.so-net.ne.jp>
trouble with tagged queueing as the 6.5 gig version.
So, I've added a quirk entry for it to limit it to two outstanding
transactions at a time, just like the 6.5G version. While I'm at it, add a
quirk for the 9G version of the drive, since it most likely has the same
problem.
Submitted by: Jeremy Lea <reg@shale.csir.co.za>
reports on those most welcome!
Fixed problems:
Hang on probe on "fantom" devices.
The probe now use a timeout to avoid hangs if no interrupt
is recevied.
There has also been more general code clenaups, and some reorgs.
lock) until it actually needs to modify the vm_map.
Note: it is legal to modify vm_map::hint without holding a write lock.
Submitted by: "Richard Seaman, Jr." <dick@tar.com> with minor changes
by myself.
unregister them after sysuninits when unloading.
* Add code to vfs_register() to set the oid number of vfs sysctls to
the type number of the filesystem.
Reviewed by: bde
type may become necessary soon. :)
Also add a couple of additional macros that NetBSD has which we don't.
Nothing in FreeBSD uses these (yet) so adding them in shouldn't hurt
anything.
to manage their own memory. Tested on my machine (make buildworld).
I've made analogous changes on the alpha, but don't have a machine
to test.
Not-objected-to by: dg, gibbs
connection.
Clean up support for devices featuring the multiple target SCSI ID feature.
On aic7890/91/96/97 chips, we can now assume the target role on multiple
target ids simultaneously. Although these chips also have sufficient
instruction space to hold to support the initiator and target role at the
same time, the initiator role is currently disabled as it will conflict
(chip design restriction) with the multi-tid feature. I'll probably add
a nob to enable the initiator (there-by disabling multi-tid) some time
in the future.
Return queue full or busy, depending on the tagged nature of the incoming
request, if our command input queue fills up in host memeory.
Deal with accept target I/O resource shortages.
If we get an underrun on a transaction that wasn't supposed to transmit
any data, don't attempt to print out the S/G list. The code would
run until hitting a non-present page. (oops)
emulator so that instances can be dynamically added and removed from the
system.
Properly reference count peripheral instances so they are cleaned up when
destroyed by the control device.
Set a timeout for test unit ready commands. Before it was uninitialized
and could cause us to drop off the bus when no real timeout had occurred.
caused by temporary EDT allocations performed by controller drivers in
their interrupt routiens.
Reference count bus entries in the EDT in preparation for support for
dynamic controller arrival and departure.
Have children of the EDT hold references to their parents.
Correct routing of the XPT_IMMED_NOTIFY ccb type for use in
target mode applications.
Fix a few cases where the generation count for EDT data members was
not being updated when a modification occurred.
splcam() problem Noticed by: Tor Egge <tegge@FreeBSD.org>
probably always be 16 bits if they exist at all, and fusword() and
susword() are only used in i386 code, so there aren't any portability
functions with them.
numbers as chars or use bogus casts in an attempt to unmisrepresnt
them. In top, don't assume that 0xff is the only negative cpu
number when cpu numbers are (mis)represented.
