In xpt_release_device(), callout_stop() was being called without
holding the mutex (send_mtx) that is used to protect the callout.
So, move the mtx_unlock() call so that it is protected.
MFC after: 1 week
Sponsored by: Spectra Logic
In r361752 an error handling was introduced for using 0.0.0.0 or
255.255.255.255 as the address in connect() for TCP, since both
addresses can't be used. However, the stack maps 0.0.0.0 implicitly
to a local address and at least two regressions were reported.
Therefore, re-allow the usage of 0.0.0.0.
While there, change the error indicated when using 255.255.255.255
from EAFNOSUPPORT to EACCES as mentioned in the man-page of connect().
Reviewed by: rrs
MFC after: 1 week
Sponsored by: Netflix, Inc.
Differential Revision: https://reviews.freebsd.org/D25401
If the hypervisor advertises support for the DISCARD command then the
guest can perform TRIM commands, freeing space on the backing store.
If VIRTIO_BLK_F_DISCARD is enabled, advertise DISKFLAG_CANDELETE
Tested with FreeBSD guests on bhyve and KVM
Reviewed by: jhb
Tested by: freqlabs
MFC after: 1 month
Relnotes: yes
Sponsored by: Klara Inc.
Differential Revision: https://reviews.freebsd.org/D21708
This removes SCTP from in-tree kernel configuration files. Now, SCTP
can be enabled by simply loading the module, as discussed on
freebsd-net@.
Reviewed by: tuexen
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D25611
The code would unconditionally lock the vnode to audit or call the
mac hoook, even if neither want to do anything. Pre-check the state
to avoid locking in the common case of nothing to do.
Note this code should not be normally executed anyway as vnodes are
always return ready. However, poll1/2 from will-it-scale use regular
files for benchmarking, presumably to focus on the interface itself
as the vnode handler is not supposed to do almost anything.
This in particular fixes poll2 which passes 128 fds.
$ ./poll2_processes -s 10
before: 134411
after: 271572
if_attach() -> if_attach_internal() will call if_attachdomain1(ifp) any time
an ethernet interface is setup *after*
SI_SUB_PROTO_IFATTACHDOMAIN/SI_ORDER_FIRST. This eventually leads to
nd6_ifattach() -> nd6_setmtu0() stashing off ifp->if_mtu in ndi->maxmtu
*before* ifp->if_mtu has been properly set in some scenarios, e.g., USB
ethernet adapter plugged in later on.
For interfaces that are created in early boot, we don't have this issue as
domains aren't constructed enough for them to attach and thus it gets
deferred to domainifattach at SI_SUB_PROTO_IFATTACHDOMAIN/SI_ORDER_SECOND
*after* the mtu has been set earlier in ether_ifattach().
PR: 248005
Submitted by: Mathew <mjanelle blackberry com>
MFC after: 1 week
This shortens fdalloc by over 60 bytes. Correctness verified by running both
variants at the same time and comparing the result of each call.
Note someone(tm) should make a pass at converting everything else feasible.
The AR9341 AHB runs at 225MHz, much faster than the 33MHz of the
AR71xx AHB. So not only is the math going to do weird things, it
will also wrap rather than being clamped.
So:
* clamp! don't wrap!
* tidy up some debugging
* add an option to throw an NMI rather than reset!
Tested:
* AR9341 SoC (TP-Link TL-WDR4300), patting/not patting the watchdog!
Use PVO_PADDR macro to get the physical address from a PVO, instead of
explicitly ANDing pvo_pte.pa with LPTE_RPGN where it is needed. Besides
improving readability, this is needed to support superpages (D25237), where
the steps to get the PA from a PVO are different.
Reviewed by: markj
Sponsored by: Eldorado Research Institute (eldorado.org.br)
Differential Revision: https://reviews.freebsd.org/D25654
It keeps recalculated way more often than it is needed.
Provide a routine (fdlastfile) to get it if necessary.
Consumers may be better off with a bitmap iterator instead.
The code in nfscl_dofflayout() loops when a flexible file layout server
provides a small write data limit (no extant server is known to do this).
If/when it looped, it erroneously reused the "drpc" argument for the
mirror worker thread, corrupting it.
This patch fixes the problem by only using the calling thread after the
first loop iteration.
Found during testing by simulating a server with a small write size.
Since no extant pNFS server is known to provide a small write size,
this fix it not needed in practice at this time.
MFC after: 2 weeks
pmc_cpuid was uninitialized for most AMD processor families. We can still
populate this string for unimplemented families.
Also added a CPUID_TO_STEPPING macro and converted existing code to use it.
Reviewed by: mav
MFC after: 2 weeks
Sponsored by: iXsystems, Inc.
Differential Revision: https://reviews.freebsd.org/D25673
That follows Linux and fixes related drm-kmod-5.3 panic.
Reviewed by: imp, hselasky
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D25657
Previously it would check 4, 3, 2, 1 lists. In practice by the time
it is getting called all lists have some elements and consequently
this does not result in new evictions.
Nonetheless, the code is clearer.
Tested by: pho
.. and stuff if into the unused target vnode field
This gets rid of concurrent nc_flag modifications racing with the
shrinker and consequently fixes a bug where such a change could have
been missed when cache_ncp_invalidate was being issued..
Reported by: zeising
Tested by: pho, zeising
Fixes: r362828 ("cache: lockless forward lookup with smr")
Stop using smp_ipi_mtx to protect global shootdown state, and
move/multiply the global state into pcpu. Now each CPU can initiate
shootdown IPI independently from other CPUs. Initiator enters
critical section, then fills its local PCPU shootdown info
(pc_smp_tlb_XXX), then clears scoreboard generation at location (cpu,
my_cpuid) for each target cpu. After that IPI is sent to all targets
which scan for zeroed scoreboard generation words. Upon finding such
word the shootdown data is read from corresponding cpu' pcpu, and
generation is set. Meantime initiator loops waiting for all zeroed
generations in scoreboard to update.
Initiator does not disable interrupts, which should allow
non-invalidation IPIs from deadlocking, it only needs to disable
preemption to pin itself to the instance of the pcpu smp_tlb data.
The generation is set before the actual invalidation is performed in
handler. It is safe because target CPU cannot return to userspace
before handler finishes. In principle only NMI can preempt the
handler, but NMI would see the kernel handler frame and not touch
not-invalidated user page table.
Handlers loop until they do not see zeroed scoreboard generations.
This, together with hardware keeping one pending IPI in LAPIC IRR
should prevent lost shootdowns.
Notes.
1. The code does protect writes to LAPIC ICR with exclusion. I believe
this is fine because we in fact do not send IPIs from interrupt
handlers. More for !x2APIC mode where ICR access for write requires
two registers write, we disable interrupts around it. If considered
incorrect, I can add per-cpu spinlock around ipi_send().
2. Scoreboard lines owned by given target CPU can be padded to the
cache line, to reduce ping-pong.
Reviewed by: markj (previous version)
Discussed with: alc
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
Differential revision: https://reviews.freebsd.org/D25510
In case of errors, the cleanup was not consistent.
Thanks to Felix Weinrank for fuzzing the userland stack and making
me aware of the issue.
MFC after: 1 week
realtime priorities
The current `ps -axO rtprio' show threads running at interrupt
priority such as the [intr] thread as '1:48' and threads running
at kernel priority such as [pagedaemon] as normal:4294967260.
This change shows [intr] as intr:48 and [pagedaemon] as kernel:4.
Reviewed by: kib
MFC after: 1 week (together with -r362369)
Differential Revision: https://reviews.freebsd.org/D25660
It can be useful to get a dump of all registers when investigating why we
received an exception that we are unable to handle. In these cases we
already call panic, however we don't always print the registers.
Add calls to print_registers and print esr and far when applicable.
Sponsored by: Innovate UK
It follows the equivalent Linux change to be able to differentiate
skylakex and cascadelakex, sharing the same model but not stepping.
This fixes skylakex handling broken by r363144.
MFC after: 6 days
The EIP-97 is a packet processing module found on the ESPRESSObin. This
commit adds a crypto(9) driver for the crypto and hash engine in this
device. An initial skeleton driver that could attach and submit
requests was written by loos and others at Netgate, and the driver was
finished by me.
Support for separate AAD and output buffers will be added in a separate
commit, to simplify merging to stable/12 (where those features don't
exist).
Reviewed by: gnn, jhb
Feedback from: andrew, cem, manu
MFC after: 1 week
Sponsored by: Rubicon Communications, LLC (Netgate)
Differential Revision: https://reviews.freebsd.org/D25417
so it can be used on other IOMMU systems.
Provide MI iommu_unit, iommu_domain and iommu_ctx structs in sys/iommu.h;
use them as a first member of MD dmar_unit, dmar_domain and dmar_ctx.
Change the namespace in DMAR backend: use iommu_ prefix instead of dmar_.
Move some macroses and function prototypes to sys/iommu.h.
Reviewed by: kib
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D25574
to coalesce tx work requests.
Note that Coverity will still treat this as an out-of-bounds access. We
do want to compare 16B starting from ethmacdst but cmp_l2hdr was was
going beyond that by 2B.
cmp_l2hdr was introduced in r362905.
Reported by: Coverity (CID 1430284)
Sponsored by: Chelsio Communications
When dummynet initializes it prints a debug message with the current VNET
pointer unnecessarily revealing kernel memory layout. This appears to be left
over from when the first pieces of vimage support were added.
PR: 238658
Submitted by: huangfq.daxian@gmail.com
Reviewed by: markj, bz, gnn, kp, melifaro
Approved by: jtl (co-mentor), bz (co-mentor)
Event: July 2020 Bugathon
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D25619
The statement "nd->nd_bpos = mcp;" was in both the if and else. Correct,
but potentially confusing. This patch fixes this.
There should be no semantics change caused by this commit.
This file is only compiled if INET or INET6 is defined. So there
is no need for checking that.
Reviewed by: markj
Differential Revision: https://reviews.freebsd.org/D25635
r363079 introduced the possibility of loading the SCTP stack as a module in
addition to compiling it into the kernel. As part of this, the registration
of the system calls was removed and put into the loading of the module.
Therefore, the system calls are not registered anymore when compiling the
SCTP into the kernel. This patch addresses that.
Reviewed by: markj
Differential Revision: https://reviews.freebsd.org/D25632
Old subscription model allowed only single customer.
Switch inet6 to the new subscription api and eliminate the old model.
Differential Revision: https://reviews.freebsd.org/D25615
Subscriptions are planned to be used by modules such as route lookup engines.
In that case that's the module task to properly unsibscribe before detach.
However, the in-kernel customer - inet6 wants to track default route changes.
To avoid having inet6 store per-fib subscriptions, handle automatic
destruction internally.
Differential Revision: https://reviews.freebsd.org/D25614
It is documented as a raw hardware-based clock not subject to NTP or
incremental adjustments. With this "not as precise as CLOCK_MONOTONIC"
description in mind, map it to our CLOCK_MONOTNIC_FAST (the same
mapping as for the linux CLOCK_MONOTONIC_COARSE).
This is needed for the webcomponent of steam (chromium) and some
other steam component or game.
The linux-steam-utils port contains a LD_PRELOAD based fix for this.
There this is mapped to CLOCK_MONOTONIC.
As an untrained ear/eye (= the majority of people) is normaly not
noticing a difference of jitter in the 10-20 ms range, specially
if you don't pay attention like for example in a browser session
while watching a video stream, the mapping to CLOCK_MONOTONIC_FAST
seems more appropriate than to CLOCK_MONOTONIC.
Linux processes these clocks in reverse order and some DT relies
on this fact. For example, the frequency setting for a given PLL
is the last in the list, preceded by the frequency setting of its
following divider or so...
MFC after: 1 week
Module name (unlike of the of driver name) must be system wide unique.
Reported by: Mark Millard(bcm_pci), andrew(mvebu_gpio)
MFC with: r362954, r362385