race where a thread could assume that a process was swapped in by
PHOLD() when it actually wasn't fully swapped in yet.
- In faultin(), always msleep() if PS_SWAPPINGIN is set instead of doing
this check after bumping p_lock in the PS_INMEM == 0 case. Also,
sched_lock is only needed for setting and clearning swapping PS_*
flags and the swap thread inhibitor.
- Don't set and clear the thread swap inhibitor in the same loops as the
pmap_swapin/out_thread() since we have to do it under sched_lock.
Instead, mimic the treatment of the PS_INMEM flag and use separate loops
to set the inhibitors when clearing PS_INMEM and clear the inhibitors
when setting PS_INMEM.
- swapout() now returns with the proc lock held as it holds the lock
while adjusting the swapping-related PS_* flags so that the proc lock
can be used to test those flags.
- Only use the proc lock to check the swapping-related PS_* flags in
several places.
- faultin() no longer requires sched_lock to be held by callers.
- Rename PS_SWAPPING to PS_SWAPPINGOUT to be less ambiguous now that we
have PS_SWAPPINGIN.
gets signals operating based on a TailQ, and is good enough to run X11,
GNOME, and do job control. There are some intricate parts which could be
more refined to match the sigset_t versions, but those require further
evaluation of directions in which our signal system can expand and contract
to fit our needs.
After this has been in the tree for a while, I will make in kernel API
changes, most notably to trapsignal(9) and sendsig(9), to use ksiginfo
more robustly, such that we can actually pass information with our
(queued) signals to the userland. That will also result in using a
struct ksiginfo pointer, rather than a signal number, in a lot of
kern_sig.c, to refer to an individual pending signal queue member, but
right now there is no defined behaviour for such.
CODAFS is unfinished in this regard because the logic is unclear in
some places.
Sponsored by: New Gold Technology
Reviewed by: bde, tjr, jake [an older version, logic similar]
s/SNGL/SINGLE/
s/SNGLE/SINGLE/
Fix abbreviation for P_STOPPED_* etc flags, in original code they were
inconsistent and difficult to distinguish between them.
Approved by: julian (mentor)
except for the fact tha they are presently swapped out. Also add a process
flag to indicate that the process has started the struggle to swap
back in. This will be needed for the case where multiple threads
start the swapin action top a collision. Also add code to stop
a process fropm being swapped out if one of the threads in this
process is actually off running on another CPU.. that might hurt...
Submitted by: Seigo Tanimura <tanimura@r.dl.itc.u-tokyo.ac.jp>
The ability to schedule multiple threads per process
(one one cpu) by making ALL system calls optionally asynchronous.
to come: ia64 and power-pc patches, patches for gdb, test program (in tools)
Reviewed by: Almost everyone who counts
(at various times, peter, jhb, matt, alfred, mini, bernd,
and a cast of thousands)
NOTE: this is still Beta code, and contains lots of debugging stuff.
expect slight instability in signals..
pointer instead of a proc pointer and require the process pointed to
by the second argument to be locked. We now use the thread ucred reference
for the credential checks in p_can*() as a result. p_canfoo() should now
no longer need Giant.
of a process pointer.
- Move the p_candebug() at the start of procfs_control() a bit to make
locking feasible. We still perform the access check before doing
anything, we just now perform it after acquiring locks.
- Don't lock the sched_lock for TRACE_WAIT_P() and when checking to see if
p_stat is SSTOP. We lock the process while setting p_stat to SSTOP
so locking the process is sufficient to do a read to see if p_stat is
SSTOP or not.
New locks are:
- pgrpsess_lock which locks the whole pgrps and sessions,
- pg_mtx which protects the pgrp members, and
- s_mtx which protects the session members.
Please refer to sys/proc.h for the coverage of these locks.
Changes on the pgrp/session interface:
- pgfind() needs the pgrpsess_lock held.
- The caller of enterpgrp() is responsible to allocate a new pgrp and
session.
- Call enterthispgrp() in order to enter an existing pgrp.
- pgsignal() requires a pgrp lock held.
Reviewed by: jhb, alfred
Tested on: cvsup.jp.FreeBSD.org
(which is a quad-CPU machine running -current)
- clobbering of jsp's $Id$ by FreeBSD's old $Id$.
- long lines in recent KSE changes (procfs_ctl.c).
- other style bugs in KSE changes (most related to an shadowed variable
in procfs_status.c -- the td in the outer scope is obfuscated by
PFS_FILL_ARGS).
Approved by: des
this is a low-functionality change that changes the kernel to access the main
thread of a process via the linked list of threads rather than
assuming that it is embedded in the process. It IS still embeded there
but remove all teh code that assumes that in preparation for the next commit
which will actually move it out.
Reviewed by: peter@freebsd.org, gallatin@cs.duke.edu, benno rice,
Note ALL MODULES MUST BE RECOMPILED
make the kernel aware that there are smaller units of scheduling than the
process. (but only allow one thread per process at this time).
This is functionally equivalent to teh previousl -current except
that there is a thread associated with each process.
Sorry john! (your next MFC will be a doosie!)
Reviewed by: peter@freebsd.org, dillon@freebsd.org
X-MFC after: ha ha ha ha
The p_can(...) construct was a premature (and, it turns out,
awkward) abstraction. The individual calls to p_canxxx() better
reflect differences between the inter-process authorization checks,
such as differing checks based on the type of signal. This has
a side effect of improving code readability.
o Replace direct credential authorization checks in ktrace() with
invocation of p_candebug(), while maintaining the special case
check of KTR_ROOT. This allows ktrace() to "play more nicely"
with new mandatory access control schemes, as well as making its
authorization checks consistent with other "debugging class"
checks.
o Eliminate "privused" construct for p_can*() calls which allowed the
caller to determine if privilege was required for successful
evaluation of the access control check. This primitive is currently
unused, and as such, serves only to complicate the API.
Approved by: ({procfs,linprocfs} changes) des
Obtained from: TrustedBSD Project
systems were repo-copied from sys/miscfs to sys/fs.
- Renamed the following file systems and their modules:
fdesc -> fdescfs, portal -> portalfs, union -> unionfs.
- Renamed corresponding kernel options:
FDESC -> FDESCFS, PORTAL -> PORTALFS, UNION -> UNIONFS.
- Install header files for the above file systems.
- Removed bogus -I${.CURDIR}/../../sys CFLAGS from userland
Makefiles.
other "system" header files.
Also help the deprecation of lockmgr.h by making it a sub-include of
sys/lock.h and removing sys/lockmgr.h form kernel .c files.
Sort sys/*.h includes where possible in affected files.
OK'ed by: bde (with reservations)
proctree lock and the process lock are held when updating p_pptr and
p_oppid. When we are just reaading p_pptr we only need the proc lock and
not a proctree lock as well.
mtx_enter(lock, type) becomes:
mtx_lock(lock) for sleep locks (MTX_DEF-initialized locks)
mtx_lock_spin(lock) for spin locks (MTX_SPIN-initialized)
similarily, for releasing a lock, we now have:
mtx_unlock(lock) for MTX_DEF and mtx_unlock_spin(lock) for MTX_SPIN.
We change the caller interface for the two different types of locks
because the semantics are entirely different for each case, and this
makes it explicitly clear and, at the same time, it rids us of the
extra `type' argument.
The enter->lock and exit->unlock change has been made with the idea
that we're "locking data" and not "entering locked code" in mind.
Further, remove all additional "flags" previously passed to the
lock acquire/release routines with the exception of two:
MTX_QUIET and MTX_NOSWITCH
The functionality of these flags is preserved and they can be passed
to the lock/unlock routines by calling the corresponding wrappers:
mtx_{lock, unlock}_flags(lock, flag(s)) and
mtx_{lock, unlock}_spin_flags(lock, flag(s)) for MTX_DEF and MTX_SPIN
locks, respectively.
Re-inline some lock acq/rel code; in the sleep lock case, we only
inline the _obtain_lock()s in order to ensure that the inlined code
fits into a cache line. In the spin lock case, we inline recursion and
actually only perform a function call if we need to spin. This change
has been made with the idea that we generally tend to avoid spin locks
and that also the spin locks that we do have and are heavily used
(i.e. sched_lock) do recurse, and therefore in an effort to reduce
function call overhead for some architectures (such as alpha), we
inline recursion for this case.
Create a new malloc type for the witness code and retire from using
the M_DEV type. The new type is called M_WITNESS and is only declared
if WITNESS is enabled.
Begin cleaning up some machdep/mutex.h code - specifically updated the
"optimized" inlined code in alpha/mutex.h and wrote MTX_LOCK_SPIN
and MTX_UNLOCK_SPIN asm macros for the i386/mutex.h as we presently
need those.
Finally, caught up to the interface changes in all sys code.
Contributors: jake, jhb, jasone (in no particular order)
-----------------------------
The core of the signalling code has been rewritten to operate
on the new sigset_t. No methodological changes have been made.
Most references to a sigset_t object are through macros (see
signalvar.h) to create a level of abstraction and to provide
a basis for further improvements.
The NSIG constant has not been changed to reflect the maximum
number of signals possible. The reason is that it breaks
programs (especially shells) which assume that all signals
have a non-null name in sys_signame. See src/bin/sh/trap.c
for an example. Instead _SIG_MAXSIG has been introduced to
hold the maximum signal possible with the new sigset_t.
struct sigprop has been moved from signalvar.h to kern_sig.c
because a) it is only used there, and b) access must be done
though function sigprop(). The latter because the table doesn't
holds properties for all signals, but only for the first NSIG
signals.
signal.h has been reorganized to make reading easier and to
add the new and/or modified structures. The "old" structures
are moved to signalvar.h to prevent namespace polution.
Especially the coda filesystem suffers from the change, because
it contained lines like (p->p_sigmask == SIGIO), which is easy
to do for integral types, but not for compound types.
NOTE: kdump (and port linux_kdump) must be recompiled.
Thanks to Garrett Wollman and Daniel Eischen for pressing the
importance of changing sigreturn as well.
changes, so don't expect to be able to run the kernel as-is (very well)
without the appropriate Lite/2 userland changes.
The system boots and can mount UFS filesystems.
Untested: ext2fs, msdosfs, NFS
Known problems: Incorrect Berkeley ID strings in some files.
Mount_std mounts will not work until the getfsent
library routine is changed.
Reviewed by: various people
Submitted by: Jeffery Hsu <hsu@freebsd.org>
This will make a number of things easier in the future, as well as (finally!)
avoiding the Id-smashing problem which has plagued developers for so long.
Boy, I'm glad we're not using sup anymore. This update would have been
insane otherwise.
Implement a "variable" directory structure. Files that do not make
sense for the given process do not "appear" and cannot be opened.
For example, "system" processes do not have "file", "regs" or "fpregs",
because they do not have a user area.
"attempt" to fill in the user area of a given process when it is being
accessed via /proc/pid/mem (the user struct is just after
VM_MAXUSER_ADDRESS in the process address space.)
Dont do IO to the U area while it's swapped, hold it in place if possible.
Lock off access to the "ctl" file if it's done a setuid like the other
pseudo-files in there.
