about removing a few #ifdefs and providing compatibility wrappers and
VOP implementations to get and set an ACL; ZFS does ACL enforcement all
by itself.
Note that the VOPs are ifdefed out for now, so this change should be
a no-op.
Reviewed by: pjd
hard and soft interrupts
- Do not handle masked interrupts
- Do not write Cause register because most bytes are read-only and
writing the same byte to RW fields are pointless. And in case of
software interrupt utterly wrong
- Get rid of arge_fix_chain, use m_defrag like if_vr
- Rework interrupt handling routine to avoid race that lead
to disabling RX interrupts
- Enable full duplex if requested
- Properly set station MAC address
- Slightly optimize RX loop
- Initialize FILTERMATCH and FILTERMASK registers as linux driver does
that the range of versions of NFS handled by the server can
be limited. The nfsd daemon must be restarted after these
sysctl variables are changed, in order for the change to take
effect.
Approved by: kib (mentor)
that it handles the case of a non-exported NFSv4 root correctly.
Also, delete handling for the case where nd_repstat is already
set in nfs_proc(), since that no longer happens.
Approved by: kib (mentor)
o do not attach DLT_IEEE802_11_RADIO unless both tx and rx headers are
present; this is assumed in the capture code paths
o verify the above with asserts in ieee80211_radiotap_{rx,tx}
o add missing checks for active taps before calling ieee80211_radiotap_rx
PCB, simply embed it in the PCB, avoiding additional memory overhead,
memory allocation overhead, and removing one of the few remaining
uses of dtom() in the network stack.
Restore misplaced spx_ctlinput() from an earlier commit.
MFC after: 1 month
severe silicon bugs that can't handle VLAN hardware tagging as well
as status LE writeback bug. The status LE writeback bug is so
critical we can't trust status word of received frame. To accept
frames on Yukon FE+ A0 msk(4) just do minimal check for received
frames and pass them to upper stack. This means msk(4) can pass
corrupted frames to upper layer. You have been warned!
Also I supposed RX_GMF_FL_THR to be 32bits register but Linux
driver treated it as 16bit register so follow their leads. At least
this does not seem to break msk(4) on Yukon FE+.
Tested by: bz, Tanguy Bouzeloc ( the.zauron <> gmail dot com )
Bruce Cran ( bruce <> cran dot org dot uk )
Michael Reifenberger ( mike <> reifenberger dot com )
Stephen Montgomery-Smith ( stephen <> missouri dot edu )
Yukon FE+ is fast ethernet controller and uses new descriptor
format. Since I don't have this controller, the support code was
written from guess and various feedback from enthusiastic users.
Thanks to all users who patiently tested my initial patches.
Special thanks to Tanguy Bouzeloc who fixed critical bug of initial
patch.
Tested by: bz, Tanguy Bouzeloc ( the.zauron <> gmail dot com )
Bruce Cran ( bruce <> cran dot org dot uk )
Michael Reifenberger ( mike <> reifenberger dot com )
Stephen Montgomery-Smith ( stephen <> missouri dot edu )
The GM_GP_CTRL register may have stale content from previous link
information so clearing it will make hardware update the register
correctly when it established a valid link.
While I'm here remove stale comment.
does not guarantee established link. Also 1000baseT link report for
fast ethernet controller is not valid one so make sure gigabit link
is allowed for this controller.
Whenever we lost link, check whether Rx/Tx MACs were enabled. If both
MAC are not active, do not try to disable it again.
