enabled in critical sections and streamline critical_enter() and
critical_exit().
This commit allows an architecture to leave interrupts enabled inside
critical sections if it so wishes. Architectures that do not wish to do
this are not effected by this change.
This commit implements the feature for the I386 architecture and provides
a sysctl, debug.critical_mode, which defaults to 1 (use the feature). For
now you can turn the sysctl on and off at any time in order to test the
architectural changes or track down bugs.
This commit is just the first stage. Some areas of the code, specifically
the MACHINE_CRITICAL_ENTER #ifdef'd code, is strictly temporary and will
be cleaned up in the STAGE-2 commit when the critical_*() functions are
moved entirely into MD files.
The following changes have been made:
* critical_enter() and critical_exit() for I386 now simply increment
and decrement curthread->td_critnest. They no longer disable
hard interrupts. When critical_exit() decrements the counter to
0 it effectively calls a routine to deal with whatever interrupts
were deferred during the time the code was operating in a critical
section.
Other architectures are unaffected.
* fork_exit() has been conditionalized to remove MD assumptions for
the new code. Old code will still use the old MD assumptions
in regards to hard interrupt disablement. In STAGE-2 this will
be turned into a subroutine call into MD code rather then hardcoded
in MI code.
The new code places the burden of entering the critical section
in the trampoline code where it belongs.
* I386: interrupts are now enabled while we are in a critical section.
The interrupt vector code has been adjusted to deal with the fact.
If it detects that we are in a critical section it currently defers
the interrupt by adding the appropriate bit to an interrupt mask.
* In order to accomplish the deferral, icu_lock is required. This
is i386-specific. Thus icu_lock can only be obtained by mainline
i386 code while interrupts are hard disabled. This change has been
made.
* Because interrupts may or may not be hard disabled during a
context switch, cpu_switch() can no longer simply assume that
PSL_I will be in a consistent state. Therefore, it now saves and
restores eflags.
* FAST INTERRUPT PROVISION. Fast interrupts are currently deferred.
The intention is to eventually allow them to operate either while
we are in a critical section or, if we are able to restrict the
use of sched_lock, while we are not holding the sched_lock.
* ICU and APIC vector assembly for I386 cleaned up. The ICU code
has been cleaned up to match the APIC code in regards to format
and macro availability. Additionally, the code has been adjusted
to deal with deferred interrupts.
* Deferred interrupts use a per-cpu boolean int_pending, and
masks ipending, spending, and fpending. Being per-cpu variables
it is not currently necessary to lock; bus cycles modifying them.
Note that the same mechanism will enable preemption to be
incorporated as a true software interrupt without having to
further hack up the critical nesting code.
* Note: the old critical_enter() code in kern/kern_switch.c is
currently #ifdef to be compatible with both the old and new
methodology. In STAGE-2 it will be moved entirely to MD code.
Performance issues:
One of the purposes of this commit is to enhance critical section
performance, specifically to greatly reduce bus overhead to allow
the critical section code to be used to protect per-cpu caches.
These caches, such as Jeff's slab allocator work, can potentially
operate very quickly making the effective savings of the new
critical section code's performance very significant.
The second purpose of this commit is to allow architectures to
enable certain interrupts while in a critical section. Specifically,
the intention is to eventually allow certain FAST interrupts to
operate rather then defer.
The third purpose of this commit is to begin to clean up the
critical_enter()/critical_exit()/cpu_critical_enter()/
cpu_critical_exit() API which currently has serious cross pollution
in MI code (in fork_exit() and ast() for example).
The fourth purpose of this commit is to provide a framework that
allows kernel-preempting software interrupts to be implemented
cleanly. This is currently used for two forward interrupts in I386.
Other architectures will have the choice of using this infrastructure
or building the functionality directly into critical_enter()/
critical_exit().
Finally, this commit is designed to greatly improve the flexibility
of various architectures to manage critical section handling,
software interrupts, preemption, and other highly integrated
architecture-specific details.
on for a while:
- fine grained TLB shootdown for SMP on i386
- ranged TLB shootdowns.. eg: specify a range of pages to shoot down with
a single IPI, since the IPI is very expensive. Adjust some callers
that used to trigger this inside tight loops to do a ranged shootdown
at the end instead.
- PG_G support for SMP on i386 (options ENABLE_PG_G)
- defer PG_G activation till after we decide what we are going to do with
PSE and the 4MB pages at the start of the kernel. This should solve
some rumored strangeness about stale PG_G entries getting stuck
underneath the 4MB pages.
- add some instrumentation for the fine TLB shootdown
- convert some asm instruction wrappers from functions to inlines. gcc
seems to do a fair bit better with this.
- [temporarily!] pessimize the tlb shootdown IPI handlers. I will fix
this again shortly.
This has been working fairly well for me for a while, but I have tweaked
it again prior to commit since my last major testing round. The only
outstanding problem that I know of is PG_G related, which is why there
is an option for it (not on by default for SMP). I have seen a world
speedups by a few percent (as much as 4 or 5% in one case) but I have
*not* accurately measured this - I am a bit sceptical of these numbers.
ucontext_t. Forward declare struct __ucontext in <sys/signal.h> and
remove reliance on <sys/ucontext.h> being included.
While I'm here, also hide osigcontext types from userland; suggested
by bde.
Namespace pollution noticed by: Kevin Day <toasty@shell.dragondata.com>
for SMP in the plain profiling case. It seems to work too.
This error was not detected by LINT because LINT only compiles the
GUPROF profiling case, which is is a superset of the plain profiling
case for !SMP but which is so broken for SMP that the buggy code is
not compiled.
they make it through to userland. This should fix the p5-smp problem
without affecting the other cpus (eg: cyrix, see initcpu.c and the special
cache handling for these cpu types).
whether the machine context is valid and whether the FPU state is
valid (saved).
Mark the machine context valid before copying it out when sending a
signal.
Approved by: -arch
and it's associated state variables: icu_lock with the name "icu". This
renames the imen_mtx for x86 SMP, but also uses the lock to protect
access to the 8259 PIC on x86 UP. This also adds an appropriate lock to
the various Alpha chipsets which fixes problems with Alpha SMP machines
dropping interrupts with an SMP kernel.
- The MD functions critical_enter/exit are renamed to start with a cpu_
prefix.
- MI wrapper functions critical_enter/exit maintain a per-thread nesting
count and a per-thread critical section saved state set when entering
a critical section while at nesting level 0 and restored when exiting
to nesting level 0. This moves the saved state out of spin mutexes so
that interlocking spin mutexes works properly.
- Most low-level MD code that used critical_enter/exit now use
cpu_critical_enter/exit. MI code such as device drivers and spin
mutexes use the MI wrappers. Note that since the MI wrappers store
the state in the current thread, they do not have any return values or
arguments.
- mtx_intr_enable() is replaced with a constant CRITICAL_FORK which is
assigned to curthread->td_savecrit during fork_exit().
Tested on: i386, alpha
- Axe inlvtlb_ok as it was completely redundant with smp_active.
- Remove references to non-existent variable and non-existent file
in i386/include/smp.h.
- Don't perform initializations local to each CPU while holding the
ap boot lock on i386 while an AP bootstraps itself.
- Reorganize the AP startup code some to unify the latter half of the
functions to bring an AP up. Eventually this might be broken out into
a MI function in subr_smp.c.
- The MI portions of struct globaldata have been consolidated into a MI
struct pcpu. The MD per-CPU data are specified via a macro defined in
machine/pcpu.h. A macro was chosen over a struct mdpcpu so that the
interface would be cleaner (PCPU_GET(my_md_field) vs.
PCPU_GET(md.md_my_md_field)).
- All references to globaldata are changed to pcpu instead. In a UP kernel,
this data was stored as global variables which is where the original name
came from. In an SMP world this data is per-CPU and ideally private to each
CPU outside of the context of debuggers. This also included combining
machine/globaldata.h and machine/globals.h into machine/pcpu.h.
- The pointer to the thread using the FPU on i386 was renamed from
npxthread to fpcurthread to be identical with other architectures.
- Make the show pcpu ddb command MI with a MD callout to display MD
fields.
- The globaldata_register() function was renamed to pcpu_init() and now
init's MI fields of a struct pcpu in addition to registering it with
the internal array and list.
- A pcpu_destroy() function was added to remove a struct pcpu from the
internal array and list.
Tested on: alpha, i386
Reviewed by: peter, jake
alpha pmap. In particular -
- pd_entry_t and pt_entry_t are now u_int32_t instead of a pointer.
This is to enable cleaner PAE and x86-64 support down the track sor
that we can change the pd_entry_t/pt_entry_t types to 64 bit entities.
- Terminate "unsigned *ptep, pte" with extreme prejudice and use the
correct pt_entry_t/pd_entry_t types.
- Various other cosmetic changes to match cleanups elsewhere.
- This eliminates a boatload of casts.
- use VM_MAXUSER_ADDRESS in place of UPT_MIN_ADDRESS in a couple of places
where we're testing user address space limits. Assuming the page tables
start directly after the end of user space is not a safe assumption.
There is still more to go.
ill effects. This should fix problems threaded programs are having with
auto-detecting CPU type.
Reported by: Joe Clarke <marcus@marcuscom.com>
Tested by: Joe Clarke <marcus@marcuscom.com>
Reviewed by: jhb
MFC after: 1 week
o Make <stdint.h> a symbolic link to <sys/stdint.h>.
o Move most of <sys/inttypes.h> into <sys/stdint.h>, as per C99.
o Remove <sys/inttypes.h>.
o Adjust includes in sys/types.h and boot/efi/include/ia64/efibind.h
to reflect new location of integer types in <sys/stdint.h>.
o Remove previously symbolicly linked <inttypes.h>, instead create a
new file.
o Add MD headers <machine/_inttypes.h> from NetBSD.
o Include <sys/stdint.h> in <inttypes.h>, as required by C99; and
include <machine/_inttypes.h> in <inttypes.h>, to fill in the
remaining requirements for <inttypes.h>.
o Add additional integer types in <machine/ansi.h> and
<machine/limits.h> which are included via <sys/stdint.h>.
Partially obtain from: NetBSD
Tested on: alpha, i386
Discussed on: freebsd-standards@bostonradio.org
Reviewed by: bde, fenner, obrien, wollman
a temporary fix so that we can compile kernels. I waited 30 minutes
for a response from the person who would likely know, but any longer
is too long to wait with breakage at ToT.
by the profiler on a running system. This is not done sparsely, as
memory is cheaper than processor speed and each gprof mcount() and
mexitcount() operation is already very expensive.
Obtained from: NAI Labs CBOSS project
Funded by: DARPA
{set,fill}_{,fp,db}regs() fixup:
- Add dummy {set,fill}_dbregs() on architectures that don't have them.
- KSEfy the powerpc versions (struct proc -> struct thread).
- Some architectures had the prototypes in md_var.h, some in reg.h, and
some in both; for consistency, move them to reg.h on all platforms.
These functions aren't really MD (the implementation is MD, but the interface
is MI), so they should move to an MI header, but I haven't figured out which
one yet.
Run-tested on i386, build-tested on Alpha, untested on other platforms.
the size of the kernel virtual address space relatively painlessly.
Userland will adapt via the exported kernbase symbol. Increasing
this causes the user part of address space to reduce.
will be private to each CPU.
- Re-style(9) the globaldata structures. There really needs to be a MI
struct pcpu that has a MD struct mdpcpu member at some point.
Note ALL MODULES MUST BE RECOMPILED
make the kernel aware that there are smaller units of scheduling than the
process. (but only allow one thread per process at this time).
This is functionally equivalent to teh previousl -current except
that there is a thread associated with each process.
Sorry john! (your next MFC will be a doosie!)
Reviewed by: peter@freebsd.org, dillon@freebsd.org
X-MFC after: ha ha ha ha
with system statistics monitoring tools (such as systat, vmstat...)
because of stopping RTC interrupts generation.
Restore all the timers (RTC and i8254) atomically.
Reviewed by: bde
MFC after: 1 week
