Previously, DBCR0 flags were set "globally", but this leads to problems
because Book-E fine grained debug settings work only in conjuction with the
debug master enable bit in MSR: in scenarios when the DBCR0 was set with
intention to debug one process, but another one with MSR[DE] set got
scheduled, the latter would immediately cause debug exceptions to occur upon
execution of its own code instructions (and not the one intended for
debugging).
To avoid such problems and properly handle debugging context, DBCR0 state
should be managed individually per process.
Submitted by: Grzegorz Bernacki gjb ! semihalf dot com
Reviewed by: marcel
While the KSE project was quite successful in bringing threading to
FreeBSD, the M:N approach taken by the kse library was never developed
to its full potential. Backwards compatibility will be provided via
libmap.conf for dynamically linked binaries and static binaries will
be broken.
The PQ3 is a high performance integrated communications processing system
based on the e500 core, which is an embedded RISC processor that implements
the 32-bit Book E definition of the PowerPC architecture. For details refer
to: http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=MPC8555E
This port was tested and successfully run on the following members of the PQ3
family: MPC8533, MPC8541, MPC8548, MPC8555.
The following major integrated peripherals are supported:
* On-chip peripherals bus
* OpenPIC interrupt controller
* UART
* Ethernet (TSEC)
* Host/PCI bridge
* QUICC engine (SCC functionality)
This commit brings the main functionality and will be followed by individual
drivers that are logically separate from this base.
Approved by: cognet (mentor)
Obtained from: Juniper, Semihalf
MFp4: e500
