* To use this option with a UDP socket, it must be bound to a local port,
and INADDR_ANY, to disallow possible collisions with existing udp inpcbs
bound to the same port on other interfaces at send time.
* If the socket is bound to INADDR_ANY, specifying IP_SENDSRCADDR with
INADDR_ANY will be rejected as it is ambiguous.
* If the socket is bound to an address other than INADDR_ANY, specifying
IP_SENDSRCADDR with INADDR_ANY will be disallowed by in_pcbbind_setup().
Reviewed by: silence on -net
Tested with: src/tools/regression/netinet/ipbroadcast
MFC after: 4 days
in the field. In one situation, one end of the TCP connection sends
a back-to-back RST packet, with delayed ack, the last_ack_sent variable
has not been update yet. When tcp_insecure_rst is turned off, the code
treats the RST as invalid because last_ack_sent instead of rcv_nxt is
compared against th_seq. Apparently there is some kind of firewall that
sits in between the two ends and that RST packet is the only RST
packet received. With short lived HTTP connections, the symptom is
a large accumulation of connections over a short period of time .
The +/-(1) factor is to take care of implementations out there that
generate RST packets with these types of sequence numbers. This
behavior has also been observed in live environments.
Reviewed by: silby, Mike Karels
MFC after: 1 week
been set at the socket layer, in our somewhat convoluted IPv4 source
selection logic in ip_output().
IP_ONESBCAST is actually a special case of SO_DONTROUTE, as 255.255.255.255
must always be delivered on a local link with a TTL of 1.
If IP_ONESBCAST has been set at the socket layer, also perform destination
interface lookup for point-to-point interfaces based on the destination
address of the link; previously it was not possible to use the option with
such interfaces; also, the destination/broadcast address fields map to the
same field within struct ifnet, which doesn't help matters.
One more valid fix going forward for these issues is to treat 255.255.255.255
as a destination in its own right in the forwarding trie. Other
implementations do this. It fits with the use of multiple paths, though
it then becomes necessary to specify interface preference.
This hack will eventually go away when that comes to pass.
Reviewed by: andre
MFC after: 1 week
potential issues where the peer does not close, potentially leaving
thousands of connections in FIN_WAIT_2. This is controlled by a new sysctl
fast_finwait2_recycle, which is disabled by default.
Reviewed by: gnn, silby.
It is built in the same module as IPv4 multicast forwarding, i.e. ip_mroute.ko,
if and only if IPv6 support is enabled for loadable modules.
Export IPv6 forwarding structs to userland netstat(1) via sysctl(9).
- ZONE get now also take a type cast so it does the
cast like mtod does.
- New macro SCTP_LIST_EMPTY, which in bsd is just
LIST_EMPTY
- Removal of const in some of the static hmac functions
(not needed)
- Store length changes to allow for new fields in auth
- Auth code updated to current draft (this should be the
RFC version we think).
- use uint8_t instead of u_char in LOOPBACK address comparison
- Some u_int32_t converted to uint32_t (in crc code)
- A bug was found in the mib counts for ordered/unordered
count, this was fixed (was referencing a freed mbuf).
- SCTP_ASOCLOG_OF_TSNS added (code will probably disappear
after my testing completes. It allows us to keep a
small log on each assoc of the last 40 TSN's in/out and
stream assignment. It is NOT in options and so is only
good for private builds.
- Some CMT changes in prep for Jana fixing his problem
with reneging when CMT is enabled (Concurrent Multipath
Transfer = CMT).
- Some missing mib stats added.
- Correction to number of open assoc's count in mib
- Correction to os_bsd.h to get right sha2 macros
- Add of special AUTH_04 flags so you can compile the code
with the old format (in case the peer does not yet support
the latest auth code).
- Nonce sum was incorrectly being set in when ecn_nonce was
NOT on.
- LOR in listen with implicit bind found and fixed.
- Moved away from using mbuf's for socket options to using
just data pointers. The mbufs were used to harmonize
NetBSD code since both Net and Open used this method. We
have decided to move away from that and more conform to
FreeBSD style (which makes more sense).
- Very very nasty bug found in some of my "debug" code. The
cookie_how collision case tracking had an endless loop in
it if you got a second retransmission of a cookie collision
case. This would lock up a CPU .. ugly..
- auth function goes to using size_t instead of int which
conforms to socketapi better
- Found the nasty bug that happens after 9 days of testing.. you
get the data chunk, deliver it and due to the reference to a ch->
that every now and then has been deleted (depending on the postion
in the mbuf) you have an invalid ch->ch.flags.. and thus you don't
advance the stream sequence number.. so you block the stream
permanently. The fix is to make local variables of these guys
and set them up before you have any chance of trimming the
mbuf.
- style fix in sctp_util.h, not sure how this got bad maybe in
the last patch? (aka it may not be in the real source).
- Found interesting bug when using the extended snd/rcv info where
we would get an error on receiving with this. Thats because
it was NOT padded to the same size as the snd_rcv info. We
increase (add the pad) so the two structs are the same size
in sctp_uio.h
- In sctp_usrreq.c one of the most common things we did for
socket options was to cast the pointer and validate the size.
This as been macro-ized to help make the code more readable.
- in sctputil.c two things, the socketapi class found a missing
flag type (the next msg is a notification) and a missing
scope recovery was also fixed.
Reviewed by: gnn
IGMPMSG_WHOLEPKT notifications to the userland PIM routing daemon,
as an optimization to mitigate the effects of high multicast
forwarding load.
This is an experimental change, therefore it must be explicitly enabled by
setting the sysctl/tunable net.inet.pim.squelch_wholepkt to a non-zero value.
The tunable may be set from the loader or from within the kernel environment
when loading ip_mroute.ko as a module.
Submitted by: edrt <edrt at citiz.net>
See also: http://mailman.icsi.berkeley.edu/pipermail/xorp-users/2005-June/000639.html
Make PIM dynamically loadable by using encap_attach_func().
PIM may now be loaded into a GENERIC kernel.
Tested with: ports/net/pimdd && tcpreplay && wireshark
Reviewed by: Pavlin Radoslavov
by the token bucket filter will result in EINVAL being returned.
If you want to rate-limit traffic in future, use ALTQ or dummynet; this
isn't a general purpose QoS engine.
Preserve the now unused fields in struct vif so as to avoid having to
recompile netstat(1) and other tools.
Reviewed by: Pavlin Radslavov, Bill Fenner
never used them; with mrouted, their functionality may be replaced by
explicitly configuring gif(4) instances and specifying them with the
'phyint' keyword.
Bump __FreeBSD_version to 700030, and update UPDATING.
A doc update is forthcoming.
Discussed on: net
Reviewed by: fenner
MFC after: 3 months
socket option TCP_INFO.
Note that the units used in the original Linux API are in microseconds,
so use a 64-bit mantissa to convert FreeBSD's internal measurements
from struct tcpcb from ticks.
multicast memberships, when interface is detached. Thus, when
an underlying interface is detached, we do not need to free
our multicast memberships.
Reviewed by: bms
Normally the socket buffers are static (either derived from global
defaults or set with setsockopt) and do not adapt to real network
conditions. Two things happen: a) your socket buffers are too small
and you can't reach the full potential of the network between both
hosts; b) your socket buffers are too big and you waste a lot of
kernel memory for data just sitting around.
With automatic TCP send and receive socket buffers we can start with a
small buffer and quickly grow it in parallel with the TCP congestion
window to match real network conditions.
FreeBSD has a default 32K send socket buffer. This supports a maximal
transfer rate of only slightly more than 2Mbit/s on a 100ms RTT
trans-continental link. Or at 200ms just above 1Mbit/s. With TCP send
buffer auto scaling and the default values below it supports 20Mbit/s
at 100ms and 10Mbit/s at 200ms. That's an improvement of factor 10, or
1000%. For the receive side it looks slightly better with a default of
64K buffer size.
New sysctls are:
net.inet.tcp.sendbuf_auto=1 (enabled)
net.inet.tcp.sendbuf_inc=8192 (8K, step size)
net.inet.tcp.sendbuf_max=262144 (256K, growth limit)
net.inet.tcp.recvbuf_auto=1 (enabled)
net.inet.tcp.recvbuf_inc=16384 (16K, step size)
net.inet.tcp.recvbuf_max=262144 (256K, growth limit)
Tested by: many (on HEAD and RELENG_6)
Approved by: re
MFC after: 1 month
upper-bounding it to the size of the initial socket buffer lower-bound it
to the smallest MSS we accept. Ideally we'd use the actual MSS information
here but it is not available yet.
For socket buffer auto sizing to be effective we need room to grow the
receive window. The window scale shift is determined at connection setup
and can't be changed afterwards. The previous, original, method effectively
just did a power of two roundup of the socket buffer size at connection
setup severely limiting the headroom for larger socket buffers.
Tested by: many (as part of the socket buffer auto sizing patch)
MFC after: 1 month
This is not a functional change.
IN_LINKLOCAL() tests if an address falls within the IPv4 link-local prefix.
IN_PRIVATE() tests if an address falls within an RFC 1918 private prefix.
IN_LOCAL_GROUP() tests if an address falls within the statically assigned
link-local multicast scope specified in RFC 2365.
IN_ANY_LOCAL() tests for either of IN_LINKLOCAL() or IN_LOCAL_GROUP().
As with the existing macros in the FreeBSD netinet stack, comparisons
are performed in host-byte order.
See also: RFC 1918, RFC 2365, RFC 3927
Obtained from: NetBSD (dyoung@)
MFC after: 2 weeks
carp_clone_destroy() we are on a safe side, we don't need to
unlock the cif, that can me already non-existent at this point.
Reported by: Anton Yuzhaninov <citrin rambler-co.ru>
- Finally all splxx() are removed
- Count error fixed in mapping array which might
cause a wrong cumack generation.
- Invariants around panic for case D + printf when no invariants.
- one-to-one model race condition fixed by using
a pre-formed connection and then completing the
work so accept won't happen on a non-formed
association.
- Some additional paranoia checks in sctp_output.
- Locks that were missing in the accept code.
Approved by: gnn
- Added a short time wait (not used yet) constant
- Corrected the type of the crc32c table (it was
unsigned long and really is a uint32_t
- Got rid of the user of MHeaders until they
are truely needed by lower layers.
- Fixed an initialization problem in the readq structure
(ordering was off).
- Found yet another collision bug when the random number
generator returns two numbers on one side (during a collision)
that are the same. Also added some tracking of cookies
that will go away when we know that we have the last collision
bug gone.
- Fixed an init bug for book_size_scale, that was causing
Early FR code to run when it should not.
- Fixed a flight size tracking bug that was associated with
Early FR but due to above bug also effected all FR's
- Fixed it so Max Burst also will apply to Fast Retransmit.
- Fixed a bug in the temporary logging code that allowed a
static log array overflow
- hashinit_flags is now used.
- Two last mcopym's were converted to the macro sctp_m_copym that
has always been used by all other places
- macro sctp_m_copym was converted to upper case.
- We now validate sinfo_flags on input (we did not before).
- Fixed a bug that prevented a user from sending data and immediately
shuting down with one send operation.
- Moved to use hashdestroy instead of free() in our macros.
- Fixed an init problem in our timed_wait vtag where we
did not fully initialize our time-wait blocks.
- Timer stops were re-positioned.
- A pcb cleanup method was added, however this probably will
not be used in BSD.. unless we make module loadable protocols
- I think this fixes the mysterious timer bug.. it was a
ordering of locks problem in the way we did timers. It
now conforms to the timeout(9) manual (except for the
_drain part, we had to do this a different way due
to locks).
- Fixed error return code so we get either CONNREUSED or CONNRESET
depending on where one is in progression
- Purged an unused clone macro.
- Fixed a read erro code issue where we were NOT getting the proper
error when the connection was reset.
- Purged an unused clone macro.
- Fixed a read erro code issue where we were NOT getting the proper
error when the connection was reset.
Approved by: gnn
members right. However, it also said it was aligned(1), which meant
that gcc generated really bad code. Mark this as aligned(4). This
makes things a little faster on arm (a couple percent), but also saves
about 30k on the size of the kernel for arm.
I talked about doing this with bde, but didn't check with him before
the commit, so I'm hesitant say 'reviewed by: bde'.
mbuf. First moves toward being able to cope better with having layer 2 (or
other encapsulation data) before the IP header in the packet being examined.
More commits to come to round out this functionality. This commit should
have no practical effect but clears the way for what is coming.
Revirewed by: luigi, yar
MFC After: 2 weeks
