handlers as filter/"fast" handlers so shutdown_nice() can
acquire the process lock.
- Use bus_{read,write}_8() instead of bus_space_{read,write}_8()
in order to get rid of sc_bushandle and sc_bustag in the softc.
- Remove the banal and outdated comment above sbus_filter_stub().
allowing it to be a filter/"fast" handler. Locking the interrupt
handlers with a spin lock is mainly a requirement in schizo(4)
but as we ought to register the spin lock anyway it should not
hurt to take advantage of it in psycho(4).
- Pass both a driver_filter_t and a driver_intr_t argument to
psycho_set_intr(), allowing to get rid of the FAST interrupt
flag hack.
- Don't register the over-temperature interrupt handler as filter/
"fast" handler so shutdown_nice() can acquire the process lock.
- Use bus_{read,write}_8() instead of bus_space_{read,write}_8()
in order to get rid of sc_bushandle and sc_bustag in the softc.
- Correct the debug output for adjusting the subordinate bus number.
- Remove the banal and outdated above psycho_filter_stub().
- Fix some white space nits.
a privilege is checked against the real uid rather than the effective
uid, instead decide which uid to use in priv_check_cred() based on the
privilege passed in. We use the real uid for PRIV_MAXFILES,
PRIV_MAXPROC, and PRIV_PROC_LIMIT. Remove the definition of
SUSER_RUID; there are now no flags defined for priv_check_cred().
Obtained from: TrustedBSD Project
- Move the rtc_mtx spin lock out from under #ifdef SMP as it's just
not SMP-specific.
- Add a new spin lock pcib_mtx for locking "fast" interrupt handlers
of host-to-PCI bridge drivers on sparc64.
of the register rather than in the offset describing the register.
- In gem_reset_rx() let gem_bitwait() check for the Rx reset bit
rather than the Tx reset bit to clear.
Obtained from: OpenBSD (same/similar bugs being fixed)
These CPUs use an enhanced layout of the interrupt vector dispatch
and dispatch status registers in order to allow sending IPIs to
multiple targets simultaneously. Thus support for these CPUs was
put in a newly added cheetah_ipi_selected(). This is intended to
be pointed to by cpu_ipi_selected, which now is a function pointer,
in order to avoid cpu_impl checks once booted. Alternatively it
can point to spitfire_ipi_selected(), which was renamed from
cpu_ipi_selected(). Consequently cpu_ipi_send() was also renamed
to spitfire_ipi_send() (there's no need for a cheetah equivalent
of this so far). Initialization of the cpu_ipi_selected pointer
and other requirements is done in mp_init(), which was renamed
from mp_tramp_alloc(), as cpu_mp_start() isn't called on UP
systems while cpu_ipi_selected() is. As a side-effect this allows
to make mp_tramp static to sys/sparc64/sparc64/mp_machdep.c.
For the sake of avoiding #ifdef SMP and for keeping the history in
place cheetah_ipi_selected() and spitfire_ipi_{selected,send}()
where not put into/moved to sys/sparc64/sparc64/{cheetah,spitfire}.c
- Add some CTASSERTs and KASSERTs ensuring that MAXCPU doesn't
exceed the data types we use to store the CPU bit fields or the
number of USIII and greater CPUs supported by the current
cheetah_ipi_selected() implementation (which for JBus-CPUs is
only 4; that should be fine though as according to OpenSolaris
there are no sun4u machines with more than 4 JBus-CPUs).
- In cpu_mp_start() don't enumerate and start more than MAXCPU CPUs
as we can't handle more than that.
- In cpu_mp_start() check for upa-portid vs. portid depending on
cpu_impl for consistency with nexus(4).
- In spitfire_ipi_selected() add KASSERTs ensuring that a CPU isn't
told to IPI itself as sun4u CPUs just can't do that.
- In spitfire_ipi_send() do a MEMBAR #Sync after writing the
interrupt vector data as we want to make sure the payload was
actually written before we trigger the dispatch.
- In spitfire_ipi_send() also verify IDR_BUSY when checking whether
the dispatch was successful as it has to be cleared for this to
be the case.
- Remove some redundant variables.
RTC function of a National Semiconductor PC87317/PC97317. This
consists of using the century register the same way Solaris does
for compatibility reasons. Once there is a MD power(4) we'd also
want to interface the APC (Advanced Power Control) functionality
of the same chip function with it.
- Use a macro for the device description and take advantage of
ISA_PNP_PROBE() setting the device description.
- Use the generated typedefs for the prototypes of the device
interface functions.
reasons outlined in the comment removed along with it, because the
OFW hostid has no real meaning for FreeBSD and mainly so the OFW
hostid is not confused with the FreeBSD hostid.
moving OF_set_mmfsa_traptable() (SUNW,set-trap-table with the two
arguments used here is specific to sun4v) to MD code.
- In sys/dev/ofw/openfirm.h remove prototypes for unimplemented
functions and unused Solaris compatibility macros.
to be compiled into every driver making use of it. Use a const instance
of struct gfb_font for this as the font isn't intended to be changed at
run-time and in order to accompany the font data with height and width
info.
- Add missing prototypes.
- Define global variables not used outside of this module as static.
- Replace some outdated hard-coded functions names in panic strings
with __func__.
- Fix some style(9) bugs.
data and remove the array size from the definition as f.e. the gallant
12 x 22 font data is 256 * 44 in size, exceeding the previously hard-
coded size.
- Declare the bold8x16 instance of struct gfb_font as const as it's not
intended to be changed at run-time as a whole either.
- Use __FBSDID in xboxfb.c
Tested by: rink
the passed in auth_type is unacceptable to rpcauth_buildheader-
this avoids a null pointer panic. Clean up allocations if this
happens. This also quiets a gcc 4.2 complaint about ussing mheadend
without it being initialized.
Reviewed by: alfred
through wpa_supplcant. If a sta is deauth'd (e.g. due to inactivity)
with roaming mode set to manual then a subsequent MLME assoc request
will be incorrectly handled and the station will never reauthenticate.
To fix this interpret a reason code of zero as sufficient to send an
auth request frame.
This allocator uses a binary buddy system with a twist. First and
foremost, this allocator is required to support the implementation of
superpages. As a side effect, it enables a more robust implementation
of contigmalloc(9). Moreover, this reimplementation of
contigmalloc(9) eliminates the acquisition of Giant by
contigmalloc(..., M_NOWAIT, ...).
The twist is that this allocator tries to reduce the number of TLB
misses incurred by accesses through a direct map to small, UMA-managed
objects and page table pages. Roughly speaking, the physical pages
that are allocated for such purposes are clustered together in the
physical address space. The performance benefits vary. In the most
extreme case, a uniprocessor kernel running on an Opteron, I measured
an 18% reduction in system time during a buildworld.
This allocator does not implement page coloring. The reason is that
superpages have much the same effect. The contiguous physical memory
allocation necessary for a superpage is inherently colored.
Finally, the one caveat is that this allocator does not effectively
support prezeroed pages. I hope this is temporary. On i386, this is
a slight pessimization. However, on amd64, the beneficial effects of
the direct-map optimization outweigh the ill effects. I speculate
that this is true in general of machines with a direct map.
Approved by: re
eradication in/from userland path, countless locking fixes, etc.
- General sleep call through msleep(9) has been converted to condvar(9)
with better consistencies.
- Heavily guard every possible "slow path" entries (open(), close(),
few ioctl()s, sysctls), but once it entering "fast path" (io, interrupt
started), they are free to fly on their own.
- Rearrange locking sequences, resulting better concurrency and
serialization. Large part doesn't even need locking at all, and will be
removed in future. Less clutter, except in few places due to lock
ordering.
- Anonymous mixer object creation/deletion to simplify mixer handling
beyond typical mixer ioctls.
Submitted by: chibis (with modifications)
- Add few mix_[get|set|..] functions to avoid calling mixer_ioctl()
directly using cryptic arguments.
- Locking fixes to avoid possible deadlock with (still under Giant) USB.
- Better simplex/duplex device handling.
- Recover mmap() functionality for recording, which has been lost
since 2.2.x - 3.x (the introduction of newpcm). Full-duplex mmap still
doesn't work (due to VM/page design), but people still can mmap
both by opening each direction separately. mmaped playback is guarantee
to work either way.
- New sysctl: "hw.snd.compat_linux_mmap" to allow PROT_EXEC page
mapping, due to recent changes in linux compatibility layer which
require it. All linux applications that using sound + mmap() (mostly games)
require this to be enabled. Disabled by default.
- Other goodies.. too many, that will increase releng7 shareholder value
and make users of releng6 (and below) cry ;)
* This commit should be atomic. If anything goes wrong (not counting problem
originated from elsewhere), I will not hesitate to revert everything back
within 12 hours. This substantial changes itself not a rocket science
and the process has begun for almost 2 years, and lots of incremental
changes are already in place during that period of time.
* Some issues does occur in snd_emu10kx (note the 'x') due to various
internal locking issues and it is currently being worked on by chibis.
Tested by: chibis (Yuriy Tsibizov), joel, Alexandre Vieira,
many innocent souls...
Without bus_dma clean up and increment of number of Tx descriptors
it's hard to guarantee correct Tx operation in TSO case. The TSO
support would be enabled again when I get more feeback from re(4)
patch posted to current.
Please note that, this is currently considered as an
experimental feature so there could be some rough
edges. Consult http://wiki.freebsd.org/TMPFS for
more information.
For now, connect tmpfs to build on i386 and amd64
architectures only. Please let us know if you have
success with other platforms.
This work was developed by Julio M. Merino Vidal
for NetBSD as a SoC project; Rohit Jalan ported it
from NetBSD to FreeBSD. Howard Su and Glen Leeder
are worked on it to continue this effort.
Obtained from: NetBSD via p4
Submitted by: Howard Su (with some minor changes)
Approved by: re (kensmith)
- Remove unnecessary timestamps.
- Return CAM_RESRC_UNAVAIL for ORB shortage.
- Fix a lock problem when doorbell is used.
- Fix a potential bug for unordered execution.
'result' is still NULL and we do not need to free anything.
That allows us to gc the entire goto parts and a now unused variable.
Found with: Coverity Prevent(tm)
CID: 2519
do not continue with a NULL pointer. [1]
While here change the return of the error handling code path above.
I cannot see why we should always return 0 there. Neither does KAME
nor do we in here for the similar check in all the other functions.
Found with: Coverity Prevent(tm) [1]
CID: 2521
114 bytes of cmos ram in the PC clock chip. The big difference between
this and the Linux version is that we do not recalculate the checksums
for bytes 16..31.
We use this at work when cloning identical machines - we can copy the
bios settings as well. Reading /dev/nvram gives 114 bytes of data but
you can seek/read/write whichever bytes you like.
Yes, this is a "foot, gun, fire!" type of device.
without an mtag in ipsec4_common_input_cb.
So in case of !IPCOMP (AH,ESP) only change the m_tag_id if an mtag
was passed to ipsec4_common_input_cb.
Found with: Coverity Prevent(tm)
CID: 2523
handle, document those sprotos using an IPSEC_ASSERT so that it will
be clear that 'spi' will always be initialized when used the first time.
Found with: Coverity Prevent(tm)
CID: 2533
