1. Detect the revision of the Rhine chip we're using.
2. Use the force reset command on revisions which support
it whenever the normal reset command fails.
This should solve a wide range of "my vr0 locks up with reset
failed messages" problems. (Although the root causes should
be eventually tracked down.)
Tested by: grenville armitage <garmitage@swin.edu.au>
Obtained from: Via's if_fet driver
MFC after: 3 days
Approved by: re
to the sparc64 implementation. (Note: With modest effort on the alpha and
ia64 this function could migrate to the MI part of the kernel.)
Approved by: re (blanket)
Add function map_port_space() to map the memory mapped I/O port
range as uncacheable virtual memory and call it prior to probing
for a console. This removes the dependency on the loader to have
done this for us. Note that this change does not include doing
the same for APs.
Approved by: re (blanket)
the kernel itself, but SAL on Itanium2 machines spontaneously
rebooted the machine.
Approved by: re (blanket)
Submitted by: Arun Sharma <adsharma@unix-os.sc.intel.com>
o Show the contents of the AP wakeup descriptor when dumping SAL
information.
o Increase S/N ratio when listing the itr and dtr. Only show valid
mappings and give the total number of TRs.
Approved by: re (blanket)
If the value from the user is less than 177, assume it is a multiple of
a single speed CDROM and convert to KB/sec.
No complaints from: sos
Reviewed by: ken
Approved by: re
MFC after: 1 day
i386 cpu_thread_exit(). This resulted in a panic with WITNESS
since we need to hold Giant to call kmem_free(), and we weren't
helding it anymore in cpu_thread_exit(). We now do this from a
new MD function, cpu_thread_dtor(), called by thread_dtor().
Approved by: re@
Suggested by: jhb
This code allows a user program to enable target mode on a SIM and
then emulate any number of devices (disks, tape drives, etc.) All
decisions about device behavior (UA, CA, inquiry response) are left
to the usermode program and the kernel driver is merely a conduit
for CCBs. This enables multiple concurrent target emulators, each
using its own backing store and IO model.
Also included is a user program that emulates a disk (RBC) using a
file as a backing store. This provides functionality similar to
md(4) at the CAM layer.
Code has been tested on ahc(4) and should also work on isp(4) (and
other SIMs that gain target mode support). It is a complete rewrite
of /sys/cam/scsi_target* and /usr/share/examples/scsi_target.
Design, comments from: gibbs
Supported by: Cryptography Research
Approved by: re
to PCI bridge can be read be evaluating the _BBN method of the host to PCI
device. Unfortunately, there appear to be some lazy/ignorant/moronic/
whatever BIOS writers that return 0 for _BBN for all host to PCI bridges in
the system. On a system with a single host to PCI bridge this is not a
problem as the child bus of that single bridge will be bus 0 anyway.
However, on systems with multiple host to PCI bridges and l/i/m/w BIOS
writers this is a major problem resulting in all but the first host to
PCI bridge failing to attach. So, this adds a workaround.
If the _BBN of a host to PCI bridge is zero and pcib0 already exists
and is not us, the we use _ADR to look up our PCI function and slot
(we currently assume we are on bus 0) and use that to call
host_pcib_get_busno() to try and extract our bus number from config
registers on the host to PCI bridge device. If that fails, then we make
an evil assumption that ACPI's _SB_ namespace lays out the host to PCI
bridges in ascending order and use our pcib unit number as our bus
number.
Approved by: re
macro for use when parsing MADT tables, thus we always tried to set the
interrupt model to APIC. This proved to be harmful on UP machines with
IO APIC's (or for UP kernels on SMP machines) since the wrong interrupt
routing information would be returned.
Pointy hat to: jhb
Approved by: re (rwatson)
- Provide a routine in sched_4bsd to add this functionality.
- Use sched_pctcpu() in kern_proc, which is the one place outside of
sched_4bsd where the old pctcpu value was accessed directly.
Approved by: re
intended to be used by significant memory consumers so that they may drain
some of their caches.
Inspired by: phk
Approved by: re
Tested on: x86, alpha
These makefiles work when building in the sys/modules directory, but
not with the objdir stuff that buildkernel uses. This is because they
used -I../../../blah rather than -I${.CURDIR}/../../../blah.
# I didn't fix the abuse of CFLAGS to specify -g since I wanted the
# barest minimal change since we're in a code freeze.
Approved by: make buildkernel...
Hat for armchair anarchists: core member fixing src tree damage
data in the scheduler independant structures (proc, ksegrp, kse, thread).
- Implement unused stubs for this mechanism in sched_4bsd.
Approved by: re
Reviewed by: luigi, trb
Tested on: x86, alpha
Has been seen to work on several cards and communicating with
several mobile phones to use them as modems etc.
We are still talking with 3com to try get them to allow us to include
the firmware for their pccard in the driver but the driver is here..
In the mean time
it can be downloaded from the 3com website and loaded using the utility
bt3cfw(8) (supplied) (instructions in the man page)
Not yet linked to the build
Submitted by: Maksim Yevmenkin <myevmenk@exodus.net>
Approved by: re
bridge.c nor if_ethersubr.c depend on IPFIREWALL.
Restore the use of fw_one_pass in if_ethersubr.c
ipfw.8 will be updated with a separate commit.
Approved by: re
in struct proc. While the process label is actually stored in the
struct ucred pointed to by p_ucred, there is a need for transient
storage that may be used when asynchronous (deferred) updates need to
be performed on the "real" label for locking reasons. Unlike other
label storage, this label has no locking semantics, relying on policies
to provide their own protection for the label contents, meaning that
a policy leaf mutex may be used, avoiding lock order issues. This
permits policies that act based on historical process behavior (such
as audit policies, the MAC Framework port of LOMAC, etc) can update
process properties even when many existing locks are held without
violating the lock order. No currently committed policies implement use
of this label storage.
Approved by: re
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
in half because of reports that under heavy load the kernel could
exhaust its memory pool. The limit is now (desiredvnodes * 4)
rather than (desiredvnodes * 8), so it will still scale with
larger systems, just not as quickly.
Sponsored by: DARPA & NAI Labs.
not have hit the disk and the dependencies cannot be unrolled.
In this case, the system will mark the buffer as dirty again so
that the write can be retried in the future. When the write
succeeds or the system gives up on the buffer and marks it as
invalid (B_INVAL), the dependencies will be cleared.
Sponsored by: DARPA & NAI Labs.
checks permit policy modules to augment the system policy for permitting
kld operations. This permits policies to limit access to kld operations
based on credential (and other) properties, as well as to perform checks
on the kld being loaded (integrity, etc).
Approved by: re
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
leader wasn't exiting during a fork; instead, do remember to release
the lock avoiding lock order reversals and recursion panic.
Reported by: "Joel M. Baldwin" <qumqats@outel.org>
after configure() has run. Only create the device if ofwcons is the
highest priority console. Make a dev alias with the same name as the
firmware output-device property.
also add rusage time in thread mailbox.
2. Minor change for thread limit code in thread_user_enter(),
fix typo in kse_release() last I committed.
Reviewed by: deischen, mini
- Clear the PG_WRITEABLE flag in pmap_changebit() if write access is
being removed. Return immediately if write access is being removed and
PG_WRITEABLE is already clear.
Note: For efficiency, pmap_changebit() should be replaced by a function
similar to sparc64's pmap_clear_write().
- Clear the PG_WRITEABLE flag in pmap_page_protect() if write access is
being removed. Return immediately if write access is being removed and
PG_WRITEABLE is already clear.
so that it can be reused elsewhere (there is a number of places
where it can be useful). This also trims some 200 lines from
the body of ip_output(), which helps readability a bit.
(This change was discussed a few weeks ago on the mailing lists,
Julian agreed, silence from others. It is not a functional change,
so i expect it to be ok to commit it now but i am happy to back it
out if there are objections).
While at it, fix some function headers and replace m_copy() with
m_copypacket() where applicable.
MFC after: 1 week
2. Avoid referencing bcopy() and bzero(), since they may not be in
scope.
Request by: bde (1)
Submitted by: wollman (2)
Reviewed by: archie, bde
PR: 43270
Replace m_copy() with m_copypacket() where applicable.
Replace "if (a.s_addr ...)" with "if (a.s_addr != INADDR_ANY ...)"
to make it clear what the code means.
While at it, fix some function headers and remove 'register' from
variable declarations.
MFC after: 3 days
trigger a breakpoint with this chip.
- Fiddle the right bits in the cn input and output routines to disable port
interrupts and enable visibility of the masked interrupt status bits.
- Register a shutdown final event handler to put the chip back in the mode
that the prom expects.
kern.threads.max_threads_per_proc
kern.threads.max_groups_per_proc
2.Temporary disable borrower thread stash itself as
owner thread's spare thread in thread_exit(). there
is a race between owner thread and borrow thread:
an owner thread may allocate a spare thread as this:
if (td->td_standin == NULL)
td->standin = thread_alloc();
but thread_alloc() can block the thread, then a borrower
thread would possible stash it self as owner's spare
thread in thread_exit(), after owner is resumed, result
is a thread leak in kernel, double check in owner can
avoid the race, but it may be ugly and not worth to do.
sysconf.c:
Use 'break' rather than 'goto yesno' in sysconf.c so that we report a '0'
return value from the kernel sysctl.
vfs_aio.c:
Make aio reset its configuration parameters to -1 after unloading
instead of 0.
posix4_mib.c:
Initialize the aio configuration parameters to -1
to indicate that it is not loaded.
Add a facility (p31b_iscfg()) to determine if a posix4 facility has been
initialized to avoid having to re-order the SYSINITs.
Use p31b_iscfg() to determine if aio has had a chance to run yet which
is likely if it is compiled into the kernel and avoid spamming its
values.
Introduce a macro P31B_VALID() instead of doing the same comparison over
and over.
posix4.h:
Prototype p31b_iscfg().
Previously these were libc functions but were requested to
be made into system calls for atomicity and to coalesce what
might be two entrances into the kernel (signal mask setting
and floating point trap) into one.
A few style nits and comments from bde are also included.
Tested on alpha by: gallatin
No functional changes, but:
+ the mrouting module now should behave the same as the compiled-in
version (it did not before, some of the rsvp code was not loaded
properly);
+ netinet/ip_mroute.c is now truly optional;
+ removed some redundant/unused code;
+ changed many instances of '0' to NULL and INADDR_ANY as appropriate;
+ removed several static variables to make the code more SMP-friendly;
+ fixed some minor bugs in the mrouting code (mostly, incorrect return
values from functions).
This commit is also a prerequisite to the addition of support for PIM,
which i would like to put in before DP2 (it does not change any of
the existing APIs, anyways).
Note, in the process we found out that some device drivers fail to
properly handle changes in IFF_ALLMULTI, leading to interesting
behaviour when a multicast router is started. This bug is not
corrected by this commit, and will be fixed with a separate commit.
Detailed changes:
--------------------
netinet/ip_mroute.c all the above.
conf/files make ip_mroute.c optional
net/route.c fix mrt_ioctl hook
netinet/ip_input.c fix ip_mforward hook, move rsvp_input() here
together with other rsvp code, and a couple
of indentation fixes.
netinet/ip_output.c fix ip_mforward and ip_mcast_src hooks
netinet/ip_var.h rsvp function hooks
netinet/raw_ip.c hooks for mrouting and rsvp functions, plus
interface cleanup.
netinet/ip_mroute.h remove an unused and optional field from a struct
Most of the code is from Pavlin Radoslavov and the XORP project
Reviewed by: sam
MFC after: 1 week
