bridge but the interface can still be changed afterwards.
This falls under the 'dont do that' category but log an warning when INVARIANTS
is defined.
Approved by: mlaier (mentor)
MFC after: 3 days
we can only bridge interfaces with the same value it meant that all members had
to be set at ETHERMTU as well.
Allow the first member to be added to define the MTU for the bridge, the check
still applies to all additional members.
Print an informative message if the MTU is incorrect [1]
Requested by: Niki Denev [1]
Approved by: mlaier (mentor)
MFC after: 3 days
hooks for each outgoing interface but also run pfil hooks _N times_ on the
bridge interface. This is changed so pfil hooks are run once for the bridge
interface (bridge0) and then only on the outgoing interfaces in the broadcast
loop.
- Simplify bridge_enqueue() by moving bridge_pfil() to the callers.
- Check (inet6_pfil_hook.ph_busy_count >= 0), it may be possible to have a
packet filter hooked for only ipv6 but we were only checking if ipv4 hooks
were busy.
- Minor optimisation for null mbuf check after bridge_pfil(), move it into the
if-block as it couldnt possibly be null outside.
Prodded by: mlaier
Approved by: re (scottl), mlaier (mentor)
packet filter. This would cause a panic on architectures that require strict
alignment such as sparc64 (tier1) and ia64/ppc (tier2).
This adds two new macros that check the alignment, these are compile time
dependent on __NO_STRICT_ALIGNMENT which is set for i386 and amd64 where
alignment isn't need so the cost is avoided.
IP_HDR_ALIGNED_P()
IP6_HDR_ALIGNED_P()
Move bridge_ip_checkbasic()/bridge_ip6_checkbasic() up so that the alignment
is checked for ipfw and dummynet too.
PR: ia64/81284
Obtained from: NetBSD
Approved by: re (dwhite), mlaier (mentor)
pointer to a softc which is no longer valid since the ifnet struct was split
out from the softc.
Approved by: mlaier (mentor)
Approved by: re (blanket)
struct ifnet or the layer 2 common structure it was embedded in have
been replaced with a struct ifnet pointer to be filled by a call to the
new function, if_alloc(). The layer 2 common structure is also allocated
via if_alloc() based on the interface type. It is hung off the new
struct ifnet member, if_l2com.
This change removes the size of these structures from the kernel ABI and
will allow us to better manage them as interfaces come and go.
Other changes of note:
- Struct arpcom is no longer referenced in normal interface code.
Instead the Ethernet address is accessed via the IFP2ENADDR() macro.
To enforce this ac_enaddr has been renamed to _ac_enaddr.
- The second argument to ether_ifattach is now always the mac address
from driver private storage rather than sometimes being ac_enaddr.
Reviewed by: sobomax, sam
using the layer2, mac and mac-type keywords.
This is one of the last features that bridge.c has over if_bridge and gets us
very close to a full functional replacement.
Approved by: mlaier (mentor)
spanning tree support.
Based on Jason Wright's bridge driver from OpenBSD, and modified by Jason R.
Thorpe in NetBSD.
Reviewed by: mlaier, bms, green
Silence from: -net
Approved by: mlaier (mentor)
Obtained from: NetBSD
