wdc cap-diag Capture diagnostic data from drive
wdc drive-log Capture drive history data from drive
wdc get-crash-dump Retrieve firmware crash dump from drive
gmultipath.8: Add HISTORY
Adjust sentences with bad phrases picked up by igor
ggatec.8: Add HISTORY
ggated.8: Add HISTORY
ggatel.8: Add HISTORY
Seperate out sentence as advised by igor.
hastctl.8: Add HISTORY
hastd.8: Add HISTORY
Fix sentence highlighted by igor.
iscontrol.8: Add HISTORY
mdmfs.8: Add HISTORY
Address issues raised by igor
mount_nfs.8: Add HISTORY
Not sure where mount_nfs first showed up, but the verison used
in the BSD's originates from 4.4BSD according to CSRG archive.
Though commercial offerings from Sun and others covers older
systems, eg https://groups.google.com/forum/#!topic/net.unix-wizards/lMe7aQikqJI
nandfs.8: Add HISTORY
Adjust sentence in description to address bad phrase highlighted
by igor.
nvmecontrol.8: Add HISTORY
PR: 212491
PR: 212498
PR: 212499
PR: 212500
PR: 212501
PR: 212502
PR: 212505
PR: 212508
PR: 212540
PR: 212543
PR: 212546
Submitted by: Sevan Janiyan <venture37@geeklan.co.uk>
Some of the structures referenced in power.c (in particular
struct nvme_power_state) are missing from sbin/nvmecontrol/
Pointyhat to: imp
Reported by: Jenkins [*], O. Hartmann <ohartman@zedat.fu-berlin.de>, Outback Dingo <outbackdingo@gmail.com>
a new firmware command.
NVMe controllers may support up to 7 firmware slots for storing of
different firmware revisions. This new firmware command supports
firmware replacement (i.e. firmware download) with or without immediate
activation, or activation of a previously stored firmware image. It
also supports selection of the firmware slot during replacement
operations, using IDENTIFY information from the controller to
check that the specified slot is valid.
Newly activated firmware does not take effect until the new controller
reset, either via a reboot or separate 'nvmecontrol reset' command to the
same controller.
Submitted by: Joe Golio <joseph.golio@emc.com>
Obtained from: EMC / Isilon Storage Division
MFC after: 3 days
This includes pretty printers for all of the standard NVMe log pages
(Error, SMART/Health, Firmware), as well as hex output for non-standard
or vendor-specific log pages.
Submitted by: Joe Golio <joseph.golio@emc.com>
Obtained from: EMC / Isilon Storage Division
MFC after: 3 days
invoke it from nvmecontrol(8).
Controller reset will be performed in cases where I/O are repeatedly
timing out, the controller reports an unrecoverable condition, or
when explicitly requested via IOCTL or an nvme consumer. Since the
controller may be in such a state where it cannot even process queue
deletion requests, we will perform a controller reset without trying
to clean up anything on the controller first.
Sponsored by: Intel
Reviewed by: carl
