The lagg(4) is often used to bond high speed links, so basic per-packet +=
on statistics cause cache misses and statistics loss.
Perfect solution would be to convert ifnet(9) to counters(9), but this
requires much more work, and unfortunately ABI change, so temporarily
patch lagg(4) manually.
We store counters in the softc, and once per second push their values
to legacy ifnet counters.
Sponsored by: Nginx, Inc.
reside on their own cache line to prevent false sharing with other
nearby structures, especially for those in the .bss segment.
NB: Those mutexes and rwlocks with variables next to them that get
changed on every invocation do not benefit from their own cache line.
Actually it may be net negative because two cache misses would be
incurred in those cases.
- Convert panic() to KASSERT.
- Remove superfluous cleaning of mbuf fields after allocation.
- Add comment on possible use of m_get2() here.
Sponsored by: Nginx, Inc.
and that can drive someone crazy. While m_get2() is young and not
documented yet, change its order of arguments to match m_getm2().
Sorry for churn, but better now than later.
Use RTM_PINNED flag to mark route as immutable.
Forbid deleting immutable routes without special rtrequest1_fib() flag.
Adding interface address with prefix already in route table is handled
by atomically deleting old prefix and adding interface one.
Discussed with: andre, eri
MFC after: 3 weeks
length packets, which was actually harmless.
Note that peers with different version of head/ may grow this
counter, but it is harmless - all pfsync data is processed.
Reported & tested by: Anton Yuzhaninov <citrin citrin.ru>
Sponsored by: Nginx, Inc
of helper functions:
- carp_master() - boolean function which is true if an address
is in the MASTER state.
- ifa_preferred() - boolean function that compares two addresses,
and is aware of CARP.
Utilize ifa_preferred() in ifa_ifwithnet().
The previous version of patch also changed source address selection
logic in jails using carp_master(), but we failed to negotiate this part
with Bjoern. May be we will approach this problem again later.
Reported & tested by: Anton Yuzhaninov <citrin citrin.ru>
Sponsored by: Nginx, Inc
of the newer drivers. The basic problem was
that the driver was pulling the mbuf off the
drbr ring and then when sending with xmit(), encounting
a full transmit ring. Thus the lower layer
xmit() function would return an error, and the
drivers would then append the data back on to the ring.
For TCP this is a horrible scenario sure to bring
on a fast-retransmit.
The fix is to use drbr_peek() to pull the data pointer
but not remove it from the ring. If it fails then
we either call the new drbr_putback or drbr_advance
method. Advance moves it forward (we do this sometimes
when the xmit() function frees the mbuf). When
we succeed we always call advance. The
putback will always copy the mbuf back to the top
of the ring. Note that the putback *cannot* be used
with a drbr_dequeue() only with drbr_peek(). We most
of the time, in putback, would not need to copy it
back since most likey the mbuf is still the same, but
sometimes xmit() functions will change the mbuf via
a pullup or other call. So the optimial case for
the single consumer is to always copy it back. If
we ever do a multiple_consumer (for lagg?) we
will need a test and atomic in the put back possibly
a seperate putback_mc() in the ring buf.
Reviewed by: jhb@freebsd.org, jlv@freebsd.org
Since ARP and routing are separated, "proxy only" entries
don't have any meaning, thus we don't need additional field
in sockaddr to pass SIN_PROXY flag.
New kernel is binary compatible with old tools, since sizes
of sockaddr_inarp and sockaddr_in match, and sa_family are
filled with same value.
The structure declaration is left for compatibility with
third party software, but in tree code no longer use it.
Reviewed by: ru, andre, net@
lle_event replaced arp_update_event after the ARP rewrite and ended up
in if_ether.h simply because arp_update_event used to be there too.
IPv6 neighbor discovery is going to grow lle_event support and this is a
good time to move it to if_llatbl.h.
The two in-tree consumers of this event - OFED and toecore - are not
affected.
Reviewed by: bz@
in from kernel-pppd which is long gone) so that ZFS and DTRACE play nice.
This is a horrible hack to get freefall to compile, and is in dire need
of reconciliation. This antique zlib-1.04 code needs to go away.
entering llentry_free(), and in case if we lose the race, we should simply
perform LLE_FREE_LOCKED(). Otherwise, if the race is lost by the thread
performing arptimer(), it will remove two references from the lle instead
of one.
Reported by: Ian FREISLICH <ianf clue.co.za>
cause kernel panics.
Add a flag to the bpf descriptor to indicate whether the hold buffer
is in use. In bpfread(), set the "hold buffer in use" flag before
dropping the descriptor lock during the call to bpf_uiomove().
Everywhere else the hold buffer is used or changed, wait while
the hold buffer is in use by bpfread(). Add a KASSERT in bpfread()
after re-acquiring the descriptor lock to assist uncovering any
additional hold buffer races.
- Deembed scope id in L3 address in in6_lltable_dump().
- Simplify scope id recovery in rtsock routines.
- Remove embedded scope id handling in ndp(8) and route(8) completely.
- Check V_deembed_scopeid before checking if sa_family == AF_INET6.
- Fix scope id handing in route(8)[2] and ifconfig(8).
Reported by: rpaulo[1], Mateusz Guzik[1], peter[2]
for bridge interface.
- If we found a collision we can break the loop - only one collision is
possible and one is exactly enough to need to renegerate.
Obtained from: WHEEL Systems
MFC after: 1 week
userland via routing socket or sysctl. This eliminates the following
KAME-specific sin6_scope_id handling routine from each userland utility:
sin6.sin6_scope_id = ntohs(*(u_int16_t *)&sin6.sin6_addr.s6_addr[2]);
This behavior can be controlled by net.inet6.ip6.deembed_scopeid. This is
set to 1 by default (sin6_scope_id will be filled in the kernel).
Reviewed by: bz
Instead, add protocol specific mbuf flags M_IP_NEXTHOP and
M_IP6_NEXTHOP. Use them to indicate that the mbuf's chain
contains the PACKET_TAG_IPFORWARD tag. And do a tag lookup
only when this flag is set.
Suggested by: andre
on checksums directly from mbuf flags. This simplifies code.
o Clear CSUM_IP from the mbuf in ip_fragment() if we did checksums in
hardware. Some driver may not announce CSUM_IP in theur if_hwassist,
although try to do checksums if CSUM_IP set on mbuf. Example is em(4).
o While here, consistently use CSUM_IP instead of its alias CSUM_DELAY_IP.
After this change CSUM_DELAY_IP vanishes from the stack.
Submitted by: Sebastian Kuzminsky <seb lineratesystems.com>
on the related functionality in the runtime via the sysctl variable
net.pfil.forward. It is turned off by default.
Sponsored by: Yandex LLC
Discussed with: net@
MFC after: 2 weeks
in network byte order. Any host byte order processing is
done in local variables and host byte order values are
never[1] written to a packet.
After this change a packet processed by the stack isn't
modified at all[2] except for TTL.
After this change a network stack hacker doesn't need to
scratch his head trying to figure out what is the byte order
at the given place in the stack.
[1] One exception still remains. The raw sockets convert host
byte order before pass a packet to an application. Probably
this would remain for ages for compatibility.
[2] The ip_input() still subtructs header len from ip->ip_len,
but this is planned to be fixed soon.
Reviewed by: luigi, Maxim Dounin <mdounin mdounin.ru>
Tested by: ray, Olivier Cochard-Labbe <olivier cochard.me>
