Currently we use interface indeces as zone IDs for link-local and
interface-local scopes, and since we don't have any tool to configure
zone IDs, there is no need to acquire the afdata lock several times per
packet only to read if_index value.
So, now in6_setscope reads zone IDs for interface-local, link-local and
global scopes without a lock.
Sponsored by: Yandex LLC
MFC after: 2 weeks
It stops treating the address on the interface as special by source
address selection rule even when the interface is outgoing interface.
This is desired in some situation.
Requested by: hrs
Reviewed by: IHANet folks including hrs
MFC after: 1 week
and embeds it into address. Inside the kernel we keep addresses with
embedded zone id only for two scopes: link-local and interface-local.
For other scopes this function is nop in most cases. To reduce an
overhead of locking, first check that address is capable for embedding.
Also, handle the loopback address before acquire the lock.
Sponsored by: Yandex LLC
MFC after: 1 week
all interested parties in case if interface flag IFF_UP has changed.
However, not only SIOCSIFFLAGS can raise the flag, but SIOCAIFADDR
and SIOCAIFADDR_IN6 can, too. The actual |= is done not in the protocol
code, but in code of interface drivers. To fix this historical layering
violation, we will check whether ifp->if_ioctl(SIOCSIFADDR) raised the
IFF_UP flag, and if it did, run the if_up() handler.
This fixes configuring an address under CARP control on an interface
that was initially !IFF_UP.
P.S. I intentionally omitted handling the IFF_SMART flag. This flag was
never ever used in any driver since it was introduced, and since it
means another layering violation, it should be garbage collected instead
of pretended to be supported.
For now use 256 buckets and fnv_hash function. Use xor'ed 32-bit
s6_addr32 parts of in6_addr structure as a hash key. Update
in6_localip and in6_is_addr_deprecated to use hash table for fastest
lookup.
Sponsored by: Yandex LLC
Discussed with: dwmalone, glebius, bz
entering llentry_free(), and in case if we lose the race, we should simply
perform LLE_FREE_LOCKED(). Otherwise, if the race is lost by the thread
performing arptimer(), it will remove two references from the lle instead
of one.
Reported by: Ian FREISLICH <ianf clue.co.za>
- Deembed scope id in L3 address in in6_lltable_dump().
- Simplify scope id recovery in rtsock routines.
- Remove embedded scope id handling in ndp(8) and route(8) completely.
Instead, add protocol specific mbuf flags M_IP_NEXTHOP and
M_IP6_NEXTHOP. Use them to indicate that the mbuf's chain
contains the PACKET_TAG_IPFORWARD tag. And do a tag lookup
only when this flag is set.
Suggested by: andre
on the related functionality in the runtime via the sysctl variable
net.pfil.forward. It is turned off by default.
Sponsored by: Yandex LLC
Discussed with: net@
MFC after: 2 weeks
in network byte order. Any host byte order processing is
done in local variables and host byte order values are
never[1] written to a packet.
After this change a packet processed by the stack isn't
modified at all[2] except for TTL.
After this change a network stack hacker doesn't need to
scratch his head trying to figure out what is the byte order
at the given place in the stack.
[1] One exception still remains. The raw sockets convert host
byte order before pass a packet to an application. Probably
this would remain for ages for compatibility.
[2] The ip_input() still subtructs header len from ip->ip_len,
but this is planned to be fixed soon.
Reviewed by: luigi, Maxim Dounin <mdounin mdounin.ru>
Tested by: ray, Olivier Cochard-Labbe <olivier cochard.me>
are using (different) ND-based approach described in RFC 4861. This change
is similar to r241406 which conditionally skips the same check in IPv4.
This change is part of bigger patch eliminating rte locking.
Sponsored by: Yandex LLC.
OK'd by: hrs
MFC after: 2 weeks
host byte order, was sometimes called with net byte order. Since we are
moving towards net byte order throughout the stack, the function was
converted to expect net byte order, and its consumers fixed appropriately:
- ip_output(), ipfilter(4) not changed, since already call
in_delayed_cksum() with header in net byte order.
- divert(4), ng_nat(4), ipfw_nat(4) now don't need to swap byte order
there and back.
- mrouting code and IPv6 ipsec now need to switch byte order there and
back, but I hope, this is temporary solution.
- In ipsec(4) shifted switch to net byte order prior to in_delayed_cksum().
- pf_route() catches up on r241245 changes to ip_output().
llentry_free() and arptimer():
o Use callout_init_rw() for lle timeout, this allows us safely
disestablish them.
- This allows us to simplify the arptimer() and make it
race safe.
o Consistently use ifp->if_afdata_lock to lock access to
linked lists in the lle hashes.
o Introduce new lle flag LLE_LINKED, which marks an entry that
is attached to the hash.
- Use LLE_LINKED to avoid double unlinking via consequent
calls to llentry_free().
- Mark lle with LLE_DELETED via |= operation istead of =,
so that other flags won't be lost.
o Make LLE_ADDREF(), LLE_REMREF() and LLE_FREE_LOCKED() more
consistent and provide more informative KASSERTs.
The patch is a collaborative work of all submitters and myself.
PR: kern/165863
Submitted by: Andrey Zonov <andrey zonov.org>
Submitted by: Ryan Stone <rysto32 gmail.com>
Submitted by: Eric van Gyzen <eric_van_gyzen dell.com>
adding any extension header, or rather before calling into IPsec
processing as we may send the packet and not return to IPv6 output
processing here.
PR: kern/170116
MFC After: 3 days
implementation of RFC 3484 for this purpose for a long time and "prefer_source"
was never implemented actually. ND6_IFF_PREFER_SOURCE macro is left intact.
it skips FLOWTABLE lookup. However, the non-NULL ro has dual meaning
here: it may be supplied to provide route, and it may be supplied to
store and return to caller the route that ip_output()/ip6_output()
finds. In the latter case skipping FLOWTABLE lookup is pessimisation.
The difference between struct route filled by FLOWTABLE and filled
by rtalloc() family is that the former doesn't hold a reference on
its rtentry. Reference is hold by flow entry, and it is about to
be released in future. Thus, route filled by FLOWTABLE shouldn't
be passed to RTFREE() macro.
- Introduce new flag for struct route/route_in6, that marks route
not holding a reference on rtentry.
- Introduce new macro RO_RTFREE() that cleans up a struct route
depending on its kind.
- All callers to ip_output()/ip6_output() that do supply non-NULL
but empty route should use RO_RTFREE() to free results of
lookup.
- ip_output()/ip6_output() now do FLOWTABLE lookup always when
ro->ro_rt == NULL.
Tested by: tuexen (SCTP part)
