Otherwise when processing finally comes to efx_tx_qdesc_post() it could
be insufficient space between reaped and added to post pending
descriptors.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
efx_ev_mcdi() does not assert or check that all event handlers it
calls are non-null. Add assertions at the top for all required
event handlers, as some events (in the case of this bug, monitor
events) are rare.
Submitted by: Ben Hutchings
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Use nitem() to get number of array elements.
Remove unused define.
Use TAB to indent.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
TCP header is fragmented in the case of VLAN tagged IPv6 traffic without
HW VLAN tagging.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Allocate the minimum or maximum response length for GET_BOARD_CFG as
appropriate. When looking up firmware subtypes by partition ID,
check the ID against the actual response length.
Merge of the patch made by Ben Hutchings in 2011.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Mainly to unify with similar member for transmit and receive queues.
It will be used in the future for resources allocation processing.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
It avoids access to m_pkthdr when TSO packet is started and also makes
tso_start_new_packet() function smaller.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Now compiler does not need any help.
The patch does not change generated code.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor), glebius
It makes sfxge_tso_state smaller and even makes tso_start_new_packet()
few bytes smaller. Data used to calculate packet size are used nearby,
so it should be no problems with cache etc.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor), glebius
Lock name should include interface name.
Tx queue and event queue lock name should include queue number.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Allow access to statistics data not only from sysctl handlers.
Submitted by: Boris Misenov <Boris.Misenov at oktetlabs.ru>
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Add separate software Tx queue limit for non-TCP traffic to make total
limit higher and avoid local drops of TCP packets because of no
backpressure.
There is no point to make non-TCP limit high since without backpressure
UDP stream easily overflows any sensible limit.
Split early drops statistics since it is better to have separate counter
for each drop reason to make it unabmiguous.
Add software Tx queue high watermark. The information is very useful to
understand how big queues grow under traffic load.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Most likely is was just memory leak on the error handling path since
typically efsys_mem_t is filled in by zeros on allocation.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
sfxge_dma_alloc() calls bus_dmamem_alloc() with BUS_DMA_ZERO flag, so
allocated memory is already filled in by zeros
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Remove the first member alignment to cacheline since it is nop.
Use __aligned() for the whole structure to make sure that the structure
size is cacheline aligned.
Remove lock alignment to make the structure smaller and fit all members
used on event queue processing into one cacheline (128 bytes) on x86-64.
The lock is obtained as well from different context when event queue
statistics are retrived from sysctl context, but it is infrequent.
Reorder members to avoid padding and go in usage order on event
processing.
As the result all structure members used on event queue processing fit
into exactly one cacheline (128 byte) now.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
In fact the pointer is used only if more than one TXQ is processed in
one interrupt.
It is used (read-write) on completion path only.
Also it makes the first part of the structure smaller and it fits now
into one 128byte cache line. So, TXQ structure becomes 128 bytes smaller.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
from the FreeBSD network code. The flag is still kept around in the
"sys/mbuf.h" header file, but does no longer have any users. Instead
the "m_pkthdr.rsstype" field in the mbuf structure is now used to
decide the meaning of the "m_pkthdr.flowid" field. To modify the
"m_pkthdr.rsstype" field please use the existing "M_HASHTYPE_XXX"
macros as defined in the "sys/mbuf.h" header file.
This patch introduces new behaviour in the transmit direction.
Previously network drivers checked if "M_FLOWID" was set in "m_flags"
before using the "m_pkthdr.flowid" field. This check has now now been
replaced by checking if "M_HASHTYPE_GET(m)" is different from
"M_HASHTYPE_NONE". In the future more hashtypes will be added, for
example hashtypes for hardware dedicated flows.
"M_HASHTYPE_OPAQUE" indicates that the "m_pkthdr.flowid" value is
valid and has no particular type. This change removes the need for an
"if" statement in TCP transmit code checking for the presence of a
valid flowid value. The "if" statement mentioned above is now a direct
variable assignment which is then later checked by the respective
network drivers like before.
Additional notes:
- The SCTP code changes will be committed as a separate patch.
- Removal of the "M_FLOWID" flag will also be done separately.
- The FreeBSD version has been bumped.
MFC after: 1 month
Sponsored by: Mellanox Technologies
Also increase default for Tx queue get-list limit.
Too small limit results in TCP packets drops especiall when many
streams are running simultaneously.
Put list may be kept small enough since it is just a temporary
location if transmit function can't get Tx queue lock.
Submitted by: Andrew Rybchenko <arybchenko at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
Required size of event queue is calculated now.
Submitted by: Andrew Rybchenko <arybchenko at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
Remove trailing whitespaces and tabs.
Enclose value in return statements in parentheses.
Use tabs after #define.
Do not skip comparison with 0/NULL in boolean expressions.
Submitted by: Andrew Rybchenko <arybchenko at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
The MAC filter set may be called without softc_lock held in the case of
SIOCADDMULTI and SIOCDELMULTI ioctls. The ioctl handler checks IFF_DRV_RUNNING
flag which implies port started, but it is not guaranteed to remain.
softc_lock shared lock can't be held in the case of these ioctls processing,
since it results in failure where kernel complains that non-sleepable
lock is held in sleeping thread.
Both problems are repeatable on LAG with LACP proto bring up.
Submitted by: Andrew Rybchenko <Andrew.Rybchenko at oktetlabs.ru>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 weeks
this set of patches fixes support for systems with > 32 cores.
Details include
sfxge: RXQ index (not label) comes from FW in flush done/failed events
Change the second argument name of the efx_rxq_flush_done_ev_t and
efx_rxq_flush_failed_ev_t prototypes to highlight that RXQ index (not label)
comes from FW in flush done and failed events.
sfxge: TXQ index (not label) comes from FW in flush done event
Change the second argument name of the efx_txq_flush_done_ev_t prototype to
highlight that TXQ index (not label) comes from FW in flush done event.
sfxge: use TXQ type as label to support more than 32 TXQs
There are 3 TXQs in event queue 0 and 1 TXQ (with TCP/UDP checksum offload)
in all other event queues.
Submitted by: Andrew Rybchenko <Andrew.Rybchenko at oktetlabs.ru>
Sponsored by: Solarflare Communications, Inc.
Previous implementation limits put queue size only (when Tx lock can't
be acquired), but get queue may grow unboundedly which results in mbuf
pools exhaustion and latency growth.
Submitted by: Andrew Rybchenko <Andrew.Rybchenko at oktetlabs.ru>
Sponsored by: Solarflare Communications, Inc.
mbuf should be owned by if_transmit function in any case.
Submitted-by: Andrew Rybchenko <Andrew.Rybchenko at oktetlabs.ru>
Sponsored by: Solarflare Communications, Inc.
option, unbreak the lock tracing release semantic by embedding
calls to LOCKSTAT_PROFILE_RELEASE_LOCK() direclty in the inlined
version of the releasing functions for mutex, rwlock and sxlock.
Failing to do so skips the lockstat_probe_func invokation for
unlocking.
- As part of the LOCKSTAT support is inlined in mutex operation, for
kernel compiled without lock debugging options, potentially every
consumer must be compiled including opt_kdtrace.h.
Fix this by moving KDTRACE_HOOKS into opt_global.h and remove the
dependency by opt_kdtrace.h for all files, as now only KDTRACE_FRAMES
is linked there and it is only used as a compile-time stub [0].
[0] immediately shows some new bug as DTRACE-derived support for debug
in sfxge is broken and it was never really tested. As it was not
including correctly opt_kdtrace.h before it was never enabled so it
was kept broken for a while. Fix this by using a protection stub,
leaving sfxge driver authors the responsibility for fixing it
appropriately [1].
Sponsored by: EMC / Isilon storage division
Discussed with: rstone
[0] Reported by: rstone
[1] Discussed with: philip
to this event, adding if_var.h to files that do need it. Also, include
all includes that now are included due to implicit pollution via if_var.h
Sponsored by: Netflix
Sponsored by: Nginx, Inc.
functions instead of using the IF_ADDR_LOCK directly. The wrapper
functions are the supported interface for device drivers.
Reviewed by: bz, philip
MFC after: 1 week
one. Interestingly, these are actually the default for quite some time
(bus_generic_driver_added(9) since r52045 and bus_generic_print_child(9)
since r52045) but even recently added device drivers do this unnecessarily.
Discussed with: jhb, marcel
- While at it, use DEVMETHOD_END.
Discussed with: jhb
- Also while at it, use __FBSDID.
It's not currently used; it didn't build on 32-bit and the previous build fix
is incorrect. If we really implement self-tests we can do this again
properly.
Submitted by: Ben Hutchings <bwh -at- solarflare.com>
MFC after: 3 weeks
This field is supposed to be set to the interface bit rate, but for some
reason I thought it was denominated in kilobits. Multiply the values up
accordingly, taking care to saturate rather than overflow on 32-bit
architectures.
Submitted by: Ben Hutchings <bwh -at- solarflare.com>
MFC after: 3 weeks
based on Solarflare SFC9000 family controllers. The driver supports jumbo
frames, transmit/receive checksum offload, TCP Segmentation Offload (TSO),
Large Receive Offload (LRO), VLAN checksum offload, VLAN TSO, and Receive Side
Scaling (RSS) using MSI-X interrupts.
This work was sponsored by Solarflare Communications, Inc.
My sincere thanks to Ben Hutchings for doing a lot of the hard work!
Sponsored by: Solarflare Communications, Inc.
MFC after: 3 weeks
