Commit Graph

40 Commits

Author SHA1 Message Date
Maxime Henrion
45c7aff75a Add explicit dependency on "ether", since we use ether_ifattach(). 2004-03-16 19:25:55 +00:00
Atsushi Onoe
e249fdbedb Change WI_RID_SCAN_RES compatibility interface to return the result after
active scan is completed just as WI_RID_READ_APS.
This fixes wicontrol -L for ath(4) and awi(4) to have results even if
the driver cannot associate any APs.
2004-01-19 05:25:43 +00:00
Atsushi Onoe
4844aa7d12 Add support for FH phy, which will be used by awi driver.
Also some if_media constants to indicate operational mode are changed
to bitmasks to reduce diffs from NetBSD.
2004-01-15 08:44:27 +00:00
Sam Leffler
6f161f0342 Handle SIOCSIFMTU ioctl directly so we can apply 802.11-specific bounds.
Note that the min is actually constrained to IF_MINMTU by the if layer.
2004-01-13 06:22:55 +00:00
Sam Leffler
c6b688c403 Sync with netbsd:
o #ifdef _KERNEL the fallback definition for DLT_IEEE802_11_RADIO
o fix many comments
o rename antenna stuff and fix units/reference signal
o change IEEE80211_RADIOTAP_DBM_TX_POWER from unsigned 16-bit value
  to a signed 8-bit value
o change IEEE80211_RADIOTAP_FLAGS from 16 bits to 8 bits to simplify
  padding requirements
o drop IEEE80211_RADIOTAP_TIME
o change IEEE80211_RADIOTAP_ANTENNA from 16 bits to 8 bits
o drop IEEE80211_RADIOTAP_PAD
o add channel flag definitions for outside the kernel so radiotap
  doesn't depend on stuff in ieee80211*.h

Obtained from:	NetBSD
2003-12-28 06:57:28 +00:00
Sam Leffler
93685685f4 o insure the current channel is in a good state before starting an AP scan
o reject scan requests for a device that isn't marked up

This fixes a problem where requesting a scan before marking the device
up would cause a panic because the current channel was set to "any" (0xffff).
2003-11-13 05:23:58 +00:00
Sam Leffler
bca1062ba5 fix typo that broke AP scanning by BSSID
Submitted by:	Len Widra
2003-11-09 23:36:46 +00:00
Brian Feldman
5c8bb90bf7 Fix a reversed suser(9) in SIOCG80211:IEEE80211_IOC_WEPKEY which prevents
root from reading the wireless card's WEP keys, but allows non-root.
2003-11-05 04:16:48 +00:00
Brooks Davis
9bf40ede4a Replace the if_name and if_unit members of struct ifnet with new members
if_xname, if_dname, and if_dunit. if_xname is the name of the interface
and if_dname/unit are the driver name and instance.

This change paves the way for interface renaming and enhanced pseudo
device creation and configuration symantics.

Approved By:	re (in principle)
Reviewed By:	njl, imp
Tested On:	i386, amd64, sparc64
Obtained From:	NetBSD (if_xname)
2003-10-31 18:32:15 +00:00
Sam Leffler
59571d2ba6 fix station mode breakage (repeat after me: "test every change, no
matter how small...")
2003-10-17 23:59:11 +00:00
Sam Leffler
1be50176db add statistics for all failures and/or abnormal events; still need
to add per-node statistics
2003-10-17 23:15:30 +00:00
Sam Leffler
627200f847 fixup debug msgs 2003-10-17 22:15:26 +00:00
Sam Leffler
b83d21129e include FH/DS parameters element in probe response frames 2003-10-17 22:09:20 +00:00
Sam Leffler
8b92bf47b0 correct comment 2003-10-17 21:56:42 +00:00
Sam Leffler
7f7ecba47e o add capability to indicate if device receives all management frames
o use recv mgmt capability to decide if outbound frames should be
  discarded if no node table entry is present
2003-10-17 21:54:59 +00:00
Sam Leffler
1e343b38be parameterize locking to improve portability and possible
change to different locking strategies
2003-10-17 21:41:52 +00:00
Sam Leffler
303ebc3c87 Try yet again to deal with timing out nodes. We cannot hold the
node lock while sending a management frame as this will potentially
result in a LOR with a driver lock.  This doesn't happen for the
Atheros driver but does for the wi driver.  Use a generation number
to help process each node once when scanning the node table and
drop the node lock if we need to timeout a node and send a frame.
2003-09-26 17:00:44 +00:00
Sam Leffler
ef39d4be37 Correct rate set negotiation when operating as a station: if the
AP has basic rates that we do not support then ignore them instead
of marking the rate set in error.

This fixes an 11b station associating with an 11g/b AP.
2003-09-26 16:54:55 +00:00
Sam Leffler
37c150c4a6 allocate node table entries with a specific malloc type 2003-09-26 16:52:12 +00:00
Sam Leffler
13604e6bad correct spelling of IEEE80211_IOC_RTSTHRESHOLD 2003-09-26 16:48:39 +00:00
Sam Leffler
d1e61976a0 Generalize the per-node RSSI data so drivers can do more interesting
things than record a single value.

o add a per-node method for returning the "current RSSI" for a node
o create a default method that returns ni_rssi which is the rssi for
  the last received frame
o use the per-node "get rssi" method to return data for the RID's
  submitted by wicontrol, et. al.

Loosely based on work by Tom Marshall <tommy@home.tig-grr.com> for MADWIFI.
2003-09-15 22:28:07 +00:00
Sam Leffler
18f897abe0 Change input handling to not expect drivers to filter short frames.
In particular, let drivers send up control frames so we can dispatch
them to bpf in monitor mode.

This is the first (small) step to adding more functionality such as
power save mode.
2003-09-15 19:38:29 +00:00
Sam Leffler
993338b6ab add definitions for various control frames and a minimum-sized frame that
we use to define IEEE80211_MIN_LEN; the minimal length for frames drivers
may pass up into the 802.11 layer
2003-09-15 19:36:34 +00:00
Sam Leffler
4f2e09c4b2 Honor the short preamble capability/state flag when calculating the
capabilities for outbound management frames.  But beware of sending
this when operating on 5GHz channels; some 11a AP's reject association
requests if this bit is set in the capabilities listed.

Obtained from:	MADWIFI (with modifications)
2003-09-14 22:34:24 +00:00
Sam Leffler
fba3db9f57 short preamble capability is not just for 11g; mark IEEE80211_F_SHPREAMBLE
regardless of the operating mode

Obtained from:	MADWIFI
2003-09-14 22:32:18 +00:00
Sam Leffler
95a22a9a71 Experimental bpf capture format for 802.11 devices. The link layer
type belongs in net/bpf.h but we keep it here for the moment.

P:
Submittep by:
Obtained from:	David Young <dyoung@pobox.com>
2003-09-05 22:19:32 +00:00
Sam Leffler
7997bcbc55 o correct logic that checks frame size to decide if a cluaster is needed
o add an assertion to check the max possible packet size

Noticed by:	David Young <dyoung@pobox.com>
2003-09-01 02:55:09 +00:00
Sam Leffler
0a915fad5d MFp4 changes to fix locking issues and correct reference
count handling of station entries in hostap mode:

Input path:

o driver is now expected to find the node associated with the
  sender of a received frame; use ic_bss if none is located
o driver passes the (referenced) node into ieee80211_input for
  use within the wlan module and is responsible for cleaning up
  on return
o the antenna state is no longer passed up with each frame; this
  is now considered driver-private state and drivers are responsible
  for keeping it in the driver-private part of a node

Output path:

Revamp output path for management frames to eliminate redundant
locking that causes problems and to correct reference counting
bogosity that occurs when stations are timed out due to inactivity
(in AP mode).  On output the refcnt'd node is stashed in the pkthdr's
recvif field (yech) and retrieved by the driver.  This eliminates
an unref/ref scenario and related node table unlock/lock due to the
driver looking up the node.  This is particularly important when
stations are timed out as this causes a lock order reversal that
can result in a deadlock.  As a byproduct we also reduce the overhead
for sending management frames (minimal).  Additional fallout from
this is a change to ieee80211_encap to return a refcn't node for
tieing to the outbound frame.  Node refcnts are not reclaimed until
after a frame is completely processed (e.g. in the tx interrupt
handler).  This is especially important for timed out stations as
this deref will be the final one causing the node entry to be
reclaimed.

Additional semi-related changes:
o replace m_copym use with m_copypacket (optimization)
o add assert to verify ic_bss is never free'd during normal operation
o add comments explaining calling conventions by drivers for frames
  going in each direction
o remove extraneous code that "cannot be executed" (e.g. because
  pointers may never be null)
2003-08-19 22:17:04 +00:00
Sam Leffler
2692bb26d4 Delay creating ic_bss until after the super-class has a chance
to override the method pointers for manipulating nodes; this fixes
a problem where the ic_bss node was not being created properly
for the ath driver causing the driver to scribble on random memory.

Noticed by:	David Young <dyoung@pobox.com>
2003-08-13 22:09:44 +00:00
Sam Leffler
dd0e6ea6b0 Use IEEE80211_RATE_MAXSIZE instead of IEEE80211_RATE_SIZE to validate the
rate set element id from an AP.  This allows stations to associate with
AP's that violate the 802.11 spec by sending >8 rates.  This corrects a
recent regression; older code did likewise.
2003-08-13 21:49:35 +00:00
Sam Leffler
2bbe529d9c add monitor mode 2003-07-21 02:49:42 +00:00
Sam Leffler
a11c9a5cc2 o change ieee80211_new_state handling to use a proper method that drivers
override in their sub-class; this eliminates the hack of interpreting the
  EINPROGRESS return value to mean "don't do any of the normal work"
o correct active scanning so the first channel is only scanned once and so
  per-channel passive mode is properly honored
o expose 802.11 FSM state names so every driver doesn't keep a private copy
o eliminate node parameter to ieee80211_begin_scan; it was not being used
2003-07-20 21:36:08 +00:00
Sam Leffler
58f40303c4 insure ic_bss always has a "valid" channel; avoids problems where users could
query the state of a card and find a null channel since allocating the node
left ni_chan zero
2003-06-29 20:13:38 +00:00
Sam Leffler
b9ee58c4af use proper length to copy data for WI_RID_DESIRED_SSID (was smashing
ic_des_chan that immediately follows)
2003-06-29 20:12:17 +00:00
Sam Leffler
8be0d57010 add safeguard against (bogus) null channel parameter 2003-06-29 20:10:54 +00:00
Sam Leffler
7535e66acd revise copyright notices per discussion with Atsushi Onoe <onoe@sm.sony.co.jp> 2003-06-27 05:13:52 +00:00
Sam Leffler
c032abb595 fix typo
Submitted by:	"Norman Diamond \(ITS\)" <n_diamond@its.jp>
2003-06-27 02:53:00 +00:00
Sam Leffler
a296d8af2f add comment 2003-06-26 22:11:19 +00:00
Sam Leffler
1300bbb70e fix tcpdump -y IEEE802_11; NBPFILTER was a holdover from netbsd compatibility 2003-06-25 17:42:36 +00:00
Sam Leffler
1a1e1d2157 new 802.11 layer:
o code reorg (relative to old netbsd-derived code) for future growth
o drivers now specify available channels and rates and 802.11 layer handles
  almost all ifmedia actions
o multi-mode support for 11a/b/g devices
o 11g protocol additions (incomplete)
o new element id additions (for other than 11g)
o node/station table redone for proper locking and to eliminate driver
  incestuousness
o split device flags and capabilities to reduce confusion and provide room
  for expansion
o incomplete power management infrastructure (need to revisit)
o incomplete hooks for software retry
o more...
2003-06-23 16:55:01 +00:00