had a 2.1 tag, thus sending these two changes into the 2.1 branch instead
of -current. Argh. I may bring these changes into the 2.1 anyway (they're
benign there) so I'm not going to admin them out of 2.1 for the time
being.
notebooks where a powerfail condition (external power drop; battery
state low) is signalled by an NMI. Makes it beep instead of panicing.
Reviewed by: davidg
LINT talks about about 2.1. I changed that to 2.0.5,
and clarified why certain devices need "at scbus?".
There is still a crazy "PCVT=210" which shouldn't be there,
but corrected comment as it is needed for 2.0.5.
- option DODUMP no longer exists (remove all references to it).
- directive `swap on' is now a no-op (don't bother documenting it; remove
comment to match code).
- directive `dumps on' still works (restore code to match comment; deprecate
it in comment).
Reviewed by: Poul-Henning Kamp, and me
Submitted by: Bruce Evans
require specific partitions be mentioned in the kernel config
file ("swap on foo" is now obsolete).
From Poul-Henning:
The visible effect is this:
As default, unless
options "NSWAPDEV=23"
is in your config, you will have four swap-devices.
You can swapon(2) any block device you feel like, it doesn't have
to be in the kernel config.
There is a performance/resource win available by getting the NSWAPDEV right
(but only if you have just one swap-device ??), but using that as default
would be too restrictive.
The invisible effect is that:
Swap-handling disappears from the $arch part of the kernel.
It gets a lot simpler (-145 lines) and cleaner.
Reviewed by: John Dyson, David Greenman
Submitted by: Poul-Henning Kamp, with minor changes by me.
The ``flags 1'' in the fdc line is now only needed for owners of an
Insight tape (perhaps there aren't any? Mine is disfunctional). All
other probes are safe wrt. to the motor-control line of floppy disk
drives. Document the flag in LINT finally.
card. This is the braindamaged card with the 80186 CPU on it. It is
slow, probably not very good after all, but hey, if you have one lying
around doing nothing anyway...
Added the "zp0" driver to GENERIC.
Make the sound configuration a little neater
(see /sys/i386/isa/sound/Readme.freebsd)
Add support for the Microsoft Sound Source.
Document the sound options again.
Submitted by: Sujal Patel <smpatel@wam.umd.edu>
Obtained from: Voxware
briefly over it, and see some serious architectural issues in this stuff.
On the other hand, I doubt that we will have any solution to these issues
before 2.1, so we might as well leave this in.
Most of the stuff is bracketed by #ifdef's so it shouldn't matter too much
in the normal case.
Reviewed by: phk
Submitted by: HOSOKAWA, Tatsumi <hosokawa@mt.cs.keio.ac.jp>
adapted to FreeBSD by Heikki Suonsivu <hsu@cs.hut.fi>.
Submitted by: Andrew Werple <andrew@werple.apana.org.au> and
Heikki Suonsivu <hsu@cs.hut.fi>
Obtained from: NetBSD
Handles at least Trantor T130 and ProAudioSpectrum adapters.
The pas driver has consequently been removed.
This driver can be configured without without interrupts.
Manpage to follow when PAS16 has been edited in.
Reviewed by: phk
Submitted by: Serge Vakulenko, <vak@cronyx.ru>
(Boot with the -D flag if you want symbols.)
Make it easier to extend `struct bootinfo' without losing either forwards
or backwards compatibility.
ddb_aout.c:
Get the symbol table from wherever the loader put it.
Nuke db_symtab[SYMTAB_SPACE].
boot.c:
Enable loading of symbols. Align them on a page boundary. Add printfs
about the symbol table sizes.
Pass the memory sizes to the kernel.
Fix initialization of `unit' (it got moved out of the loop).
Fix adding the bss size (it got moved inside an ifdef).
Initialize serial port when RB_SERIAL is toggled on.
Fix comments.
Clean up formatting of recently added code.
io.c:
Clean up formatting of recently added code.
netboot/main.c, machdep.c, wd.c:
Change names of bootinfo fields.
LINT:
Nuke SYMTAB_SPACE.
Fix comment about DODUMP.
Makefile.i386:
Nuke use of dbsym.
Exclude gcc symbols from kernel unless compiling with -g.
Remove unused macro.
Fix comments and formatting.
genassym.c:
Generate defines for some new bootinfo fields. Change names of old ones.
locore.s:
Copy only the valid part of the `struct bootinfo' passed by the loader.
Reserve space for symbol table, if any.
machdep.c:
Check the memory sizes passed by the loader, if any. Don't use them yet.
bootinfo.h:
Add a size field so that we can resolve some mismatches between the loader
bootinfo and the kernel boot info. The version number is not so good for
this because of historical botches and because it's harder to maintain.
Add memory size and symbol table fields. Change the names of everything.
Hacks to save a few bytes:
asm.S, boot.c, boot2.S:
Replace `ouraddr' by `(BOOTSEG << 4)'.
boot.c:
Don't statically initialize `loadflags' to 0. Disable the "REDUNDANT"
code that skips the BIOS variables. Eliminate `total'. Combine some
more printfs.
boot.h, disk.c, io.c, table.c:
Move all statically initialzed data to table.c.
io.c:
Don't put the A20 gate bits in a variable.
Somebody should make a mib variable for it.
Just now it is pointless to dump the kernel, since we have nothing which
can read the dump.
Furthermore is should never be the default to dump.
options DODUMP
will enable dumps.
- Make a number of filesystems work again when they are statically compiled
(blush)
- FIFOs are no longer optional; ``options FIFO'' removed from distributed
config files.
with BOUNCE_BUFFERS. This is more intuitive, and is better for future
multiplatform support. Added BOUNCE_BUFFERS option to the GENERIC and
LINT kernel config files.
This is the slowest and most stupid of our SCSI-drivers, but it is there
and it works. It has been tested with CD-ROM and disk.
It uses no interrupts, no DMA, just polled I/0.
Transfer-rate is <= 100Kbyte/sec.
If you set the jumpers on the board, you can change the unit-number and
you will be able to have four of these co-exist in one computer, why one
would do that is somewhat unclear though.
If I ever get my hand on the docs for this, I will improve it of course,
but for now we can install and access those CD-ROMs.
compile this thing. I won't turn on the ALLOW_CONFLICT_IOADDR this would need
to compile instead since that would then rob us of other, possibly important,
conflict checks.
the NTP kernel PLL is disabled, and acquire_timer0() is enabled, thus
opening the door for microtime() (and hence gettimeofday()) to return
bogus timestamps. This option is necessary for the `pca' driver to
work, but is implemented to underscore the fact that accurate timekeeping
and the `pca' driver are incompatible at present. If someone writes a version
of microtime() that works when the `pca' driver is being used, this can get
junked.
Removed com port comments, since we are about to depricate the driver.
Fix several plaes in LINT where people have been cutting and pasting using
xterms :-(
a binary link-kit. Make all non-optional options (pagers, procfs) standard,
and update LINT to reflect new symtab requirements.
NB: -Wtraditional will henceforth be forgotten. This editing pass was
primarily intended to detect any constructions where the old code might
have been relying on traditional C semantics or syntax. These were all
fixed, and the result of fixing some of them means that -Wall is now a
realistic possibility within a few weeks.
John Dyson to make it reliably work under FreeBSD.
2) Added and enabled PROCFS in the GENERICxx and LINT kernels.
3) New execve() from me. Still work to be done here, but this version
works well and is needed before other changes can be made. For
a description of the design behind this, see freebsd-arch or
ask me.
4) Rewrote stack fault code; made user stack VM grow as needed rather
than all up front; improves performance a little and reduces
process memory requirements.
5) Incorporated fix from Gene Stark to fault/wire a user page table
page to fix a problem in copyout. This is a temporary fix and
is not appropriate for pageable page tables. For a description
of the problem, see Gene's post to the freebsd-hackers mailing
list.
6) Tighten up vm_page struct to reduce memory requirements for it. ifdef
pager page lock code as it's not being used currently.
7) Introduced new element to vmspace struct - vm_minsaddr; initial
(minimum) stack address. Compliment to vm_maxsaddr.
8) Added a panic if the allocation for process u-pages fails.
9) Improve performance and accuracy of kernel profiling by putting in
a little inline assembly instead of spl().
10) Made serial console with sio driver work. Still has problems with
serial input, but is almost useable.
11) Added -Bstatic to SYSTEM_LD in Makefile.i386 so that kernels will
build properly with the new ld.
pccons or syscons usage. Modified comment in LINT for FAT_CURSOR.
Now the FAT_CURSOR can be controlled over the option, instead of hacking
syscons.c and pccons.c.
Change the cpu "i386" line to 2 lines:
cpu "I386_CPU"
cpu "I486_CPU"
This is so we can do real CPU classification of code.
Fix missing depend for assym.s which does depend on genassym.c
wd80x3 class boards can be configured to the GENERIC kernels.
Entry was:
device ed0 at isa? port 0x280 net irq 9 iomem 0xd0000 vector edintr
Is now:
device ed0 at isa? port 0x280 net irq 5 iomem 0xd8000 vector edintr
