It was previously used by felix(4) for PHY communication.
Since that is not the case anymore this driver is now left unused.
Obtained from: Semihalf
Sponsored by: Alstom Group
Use correct devclass name, due to the mismatch miibus would attach
to the wrong thing causing mii_attach to silently fail.
Fixes: dfcaa2c18b (enetc_mdio: Support building the driver ...)
The toolchain can reorder symbols, meaning that changing
the order of DRIVER_MODULE macros is not enough
to ensure that miibus gets registered first.
Use DRIVER_MODULE_ORDERED instead to fix the problem properly.
Fixes: 5ad6d28cbe ("enetc: Support building the driver as a loadable module.")
Reported by: jhb
After recent arm64 GENERIC config cleanup the ENETC MDIO
in NXP LS1028A SoC should support being loaded as a module.
Obtained from: Semihalf
Sponsored by: Alstom Group
Function level reset has to be done in attach in order to put the
hardware in a known state before configuring it.
The order of DRIVER_MODULEs was changed to ensure that the miibus driver
is loaded when mii_attach is called.
Obtained from: Semihalf
Sponsored by: Alstom Group
With the v5.13 device-tree update speed of the CPU switch port was
changed to 2.5G. Reflect that in the driver.
Submitted by: Kornel Duleba <mindal@semihalf.com>
Obtained from: Semihalf
Sponsored by: Alstom Group
Implement support for the NXP LS1028A SoC MDIO controller.
It is attached to the internal PCI root complex.
The controller is used to communicate with PHYs of ports connected
to the internal switch.
Submitted by: Lukasz Hajec <lha@semihalf.com>
Reviewed by: manu
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential Revision: https://reviews.freebsd.org/D30731
ENETC it a gigabit Ethernet controller found on the LS1028A board.
It supports basic VLAN offloads - tag extraction, injection and hardware
filtering. Inband MDIO connectivity is used for link status
monitoring through the miibus interface. Fixed-link mode is also
supported, which allows for operation of internal cpu to switch port.
Since no admin interrupts are present in hardware, link status polling
has to be used.
Due to a hardware bug software reset of the NIC results in a external
abort. Because of that most of the hardware initialization is done
during attach. This also means that in the case of an fatal error full
board reset is required.
The enetc_hw.h header was imporoted from Linux. It is dual licensed.
Submitted by: Kornel Duleba <mindal@semihalf.com>
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential Revision: https://reviews.freebsd.org/D30729
Provide common MDIO code for two LS1028 ENETC controllers -
an external one found on the PCI bus and internal one found in ENETC.
Submitted by: Lukasz Hajec <lha@semihalf.com>
Reviewed by: manu
Obtained from: Semihalf
Sponsored by: Alstom Group
Differential Revision: https://reviews.freebsd.org/D30730