* Refactor the initial learning configuration (port learning, address expiry,
handling address moving between ports, etc, etc) into a separate HAL routine
* and ensure that it's consistent between switch chips - the AR8216,8316,724x,9331
SoCs all share the same switch code.
* .. the AR8327 needs doing - the defaults seem OK for now
* .. the AR9340 is different but it's also programmed now.
* Add support for flushing a single port worth of ATU entries
* Add support for fetching the ATU table from AR8216 and derived chips
Tested:
* AR9344, Carambola 2
TODO:
* Further testing on other chips
* Add AR9340 support
* Add AR8327 support
Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error
prone - task.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
arswitch_setled() and a number of _global_setup functions did not acquire the
lock before calling arswitch_modifyreg(). With WITNESS enabled this would
instantly panic.
Discovered on a TPLink-3600:
("panic: mutex arswitch not owned at sys/dev/etherswitch/arswitch/arswitch_reg.c:236")
Reviewed by: adrian, kan
Differential Revision: https://reviews.freebsd.org/D9187
The mdio driver interface is generally useful for devices that require
MDIO without the full MII bus interface. This lifts the driver/interface
out of etherswitch(4), and adds a mdio(4) man page.
Submitted by: Landon Fuller <landon@landonf.org>
Differential Revision: https://reviews.freebsd.org/D4606
arswitch_writereg() routine was writing the registers in the wrong order.
Revert -r241918 as the root problem is now fixed. Remove another workaround
from arswitch_ar7240.c.
Simplify and fix the code on arswitch_writephy() by using
arswitch_writereg().
While here remove a redundant declaration from arswitchvar.h.
Approved by: adrian (mentor)
depending upon the bootloader initialising it.
The aim is to eventually support a full switch set and reinitialisation
rather than relying on a consistent bootloader setup.
Remove the port flood config from arswitch.c, it's not yet used and
it's totally incorrect.
Whilst I'm here, also add in a comment describing why the full switch
reset is disabled.
Obtained from: Linux (OpenWRT) - Values
* Add in the AR724x support. It probes the same as an AR8216/AR8316, so
just add in a hint to force the probe success rather than auto-detecting
it.
* Add in the missing entries from conf/files, lacking in the previous
commit.
The register values and CPU port / mirror port initialisation value was
obtained from Linux OpenWRT ag71xx_ar7240.c.
The DELAY(1000) to let things settle is my local workaround. For some
reason, PHY4 doesn't seem to probe very reliably without it. It's quite
possible that we're missing some MDIO bus initialisation code in if_arge
for the AR724x case. As I dislike DELAY() workarounds in general, it's
definitely worth trying to figure out why this is the case.
Tested on: AP93 (AR7240) reference design
Obtained from: Linux OpenWRT
