old/broken hardware. Unfortunately, it adds cache pressure and possible
mispredicted branches to the fast path of the bus_dmamap_load collection of
functions. Since it's meant for slow path exception processing, de-inline
it and allow its conditions to be pre-computed at tag_create time and thus
short-circuited at runtime.
While here, cut down on the size of _bus_dmamap_load_buffer() by pushing the
bounce page logic into a non-inlined function. Again, this helps with
cache pressure and mispredicted branches.
According to the TSC, this shaves off a few cycles on average. Unfortunately,
the data varies quite a bit due to interrupts and preemption, so it's hard to
get a good measurement. Real world measurements of network PPS are welcomed.
A merge to amd64 and other arches is pending more testing.
asserts and makes binaries smaller. The binaries also become
repeatable again. As it was, without this md5's of binaries built
with different paths differed.
# Where do I document this?
support a network w/ split mtu's by assigning each host route the correct
mtu. an aspiring programmer could write a daemon to probe hosts and find
out if they support a larger mtu.
inherit all settings and options except listen specific options.
Add the missing send/receive timeouts and low watermarks.
Remove inheritance of the field so_timeo which is unused.
Noticed by: phk
Reviewed by: rwatson
Sponsored by: TCP/IP Optimization Fundraise 2005
MFC after: 3 days
and opens a small race window before tp->t_session->s_leader is accessed. In case
tp->t_session has just been set to NULL elsewhere, we get a panic().
This fix is a bandaid until someone else fixes the whole locking in the tty subsystem.
Definitly more work needs to be done.
MFC after: 1 week
Reviewed by: mlaier
PR: kern/103101
This way GEOM classes can safely detach from provider when an orphan
event is received. This fixes 'detach with active requests' panic for
gstripe/gconcat under load.
PR: kern/102766
Submitted by: mjacob
OK'ed by: phk
MFC after: 1 week
add count of active and total components to the launched line so you can
see at a glance if your mirror/raid3 is complete...
now:
GEOM_MIRROR: Device mirror/sam launched (2/2).
Reviewed by: pjd
it was present only in the enable path, not the disable path, which one
presumes would be equally of interest. Either way, it was not needed,
as the sysctl framework already calls suser() if the operation is a
write operation, which configuration requests are.
Sponsored by: nCircle Network Security, Inc.
to it. Try to co-operate with the IPMI/ASF firmware accessing the PHY.
One we get link we don't mess with the PHY. If we do then over time
the NIC will go off line. It would be nice if we could tell if IPMI
was enabled on the chip but I can't figure out a reliable way to do
that. The scheme I tried worked on a Dell PE850 but not on an HP machine.
So we assume any NIC that has ASF capability needs to deal with it.
The code was inspired by the support in Linux from kernel.org and Broadcom.
Broadcom did give me some info. but it is rather limited and is mostly
just what is in the Linux driver. Thanks to the numerous people that
helped debug the many prior versions and that I didn't break other
bge(4) HW.
Reviewed by: several people
Tested by: even more
it possible to e.g. distribute kernels with config names larger
than eight symbols, without the clash. Previousy, LALALALA
and LALALALA-SMP would be the same tarball. (I think this
comes from the old days where tarballs were put on the MS-DOS
formatted diskettes.)
MFC after: 3 days
given as dso handle, but also in the implicit dependencies of that dso.
Also, const-ify the read-only parameter objlist of symlook_list.
Reported by: "Simon 'corecode' Schubert" <corecode at fs ei tum de>
Approved by: kan (mentor)
X-MFC-After: 6.2
