segment is likely to trigger a TCP state change (i.e., FIN/RST/SYN).
If we later have to upgrade the lock, we acquire an inpcb reference
and drop both global/inpcb locks before reacquiring in-order. In
that gap, the connection may transition into TIMEWAIT, so we need
to loop back and reevaluate the inpcb after relocking.
MFC after: 3 days
Reported by: Kamigishi Rei <spambox at haruhiism.net>
Reviewed by: bz
triggered by a misconfigured host that is sending out gratuious ARPs.
This log message can also be triggered during a network renumbering
event when multiple prefixes co-exist on a single network segment.
MFC after: immediately
this address alias has a prefix matching that of another address
configured on the same interface, then the ARP entry for the alias
is not deleted from the ARP table when that address alias is removed.
This patch fixes the aforementioned issue.
PR: kern/139113
MFC after: 3 days
When authenticating DATA chunks some DATA chunks
might get stuck when the MTU gets decreased via
an ICMP message.
Approved by: rrs (mentor)
MFC after: immediately
feature when you have a seemingly stuck socket and want to figure
out why it has not been closed yet.
No plans to MFC this, as it changes the netstat sysctl ABI.
Reviewed by: andre, rwatson, Eric Van Gyzen
TCP_SORECEIVE_STREAM for the time being.
Requested by: brooks
Once compiled in make it easily switchable for testers by using a tuneable
net.inet.tcp.soreceive_stream
and a corresponding read-only sysctl to report the current state.
Suggested by: rwatson
MFC after: 2 days
and address aliases. After an interface is brought down and brought
back up again, those self pointing routes disappeared. This patch
ensures after an interface is brought back up, the loopback routes
are reinstalled properly.
Reviewed by: bz
MFC after: immediately
module tries to install the same address again. This extra code
is removed, which was discovered by the removal of a call to
in_ifscrub() in r196714. This call to in_ifscrub is put back here
because the SIOCAIFADDR command can be used to change the prefix
length of an existing alias.
Reviewed by: kmacy
within the system that owns the interface. Packets destined to
the local end point leak to the wire towards the default gateway
if one exists. This behavior is changed as part of the L2/L3
rewrite efforts. The local end point is now reachable within the
system. The inpcb code needs to consider this fact during the
address selection process.
Reviewed by: bz
MFC after: immediately
1) A lock issue, if we ever had to try again
we would double lock the INP lock.
2) We were allowing (at wrap) associd 0... which really
we cannot allow since 0 normally means in most socket
API calls that we are wishing to effect something on
the INP not TCB.
MFC after: 1 week
This is almost always pilot error.
We don't need to check for group filter UNDEFINED state at t1,
because we only ever allocate filters with their groups, so we
unconditionally reject such calls with EINVAL.
Trying to change the active filter mode w/o going through IP_MSFILTER
is also disallowed.
Deals with the case described in PR 137164 upfront, cumulative
with the fix in svn rev 197132 which only calls imo_match_source()
if the source address family was not unspecified.
PR: 137164
MFC after: 5 days
* Don't try to use the source address, when its family is unspecified.
* If we get a join without a source, on an existing inclusive
mode group, this is an error, as it would change the filter mode.
Fix a problem with the handling of in_mfilter for new memberships:
* Do not rely on imf being NULL; it is explicitly initialized to a
non-NULL pointer when constructing a membership.
* Explicitly initialize *imf to EX mode when the source address
is unspecified.
This fixes a problem with in_mfilter slot recycling in the join path.
PR: 138690
Submitted by: Stef Walter
MFC after: 5 days
* Do not assume that the group lookup performed by imo_match_group()
is valid when ifp is NULL in this case.
* Instead, return EADDRNOTAVAIL if the ifp cannot be resolved for the
membership we are being asked to leave.
Caveat user:
* The way IPv4 multicast memberships are implemented in the inpcb layer
at the moment, has the side-effect that struct ip_moptions will
still hold the membership, under the old ifp, until ip_freemoptions()
is called for the parent inpcb.
* The underlying issue is: the inpcb layer does not get notification
of ifp being detached going away in a thread-safe manner.
This is non-trivial to fix.
But hey, at least the kernel should't panic when you unplug a card.
PR: 138689
Submitted by: Stef Walter
MFC after: 5 days
has not worked since the arp-v2 rewrite.
The event handler will be called with the llentry write-locked and
can examine la_flags to determine whether the entry is being added
or removed.
Reviewed by: gnn, kmacy
Approved by: gnn (mentor)
MFC after: 1 month
include file, and include this where the previous duplicate definitions were.
Static program checkers like FlexeLint rightfully take a dim view of
duplicate definitions, even if they currently are identical.
does a KASSERT that the group address is multicast, so the
check if this is indeed true and eventually return a EINVAL if not,
should be done before calling inp_lookup_mcast_ifp. This fixes a kernel
crash when calling setsockopt (sock, IPPROTO_IP, IP_ADD_MEMBERSHIP,...)
with invalid group address.
Reviewed by: bms
Approved by: bms
MFC after: 3 days
New counters now exist for:
requests sent
replies sent
requests received
replies received
packets received
total packets dropped due to no ARP entry
entrys timed out
Duplicate IPs seen
The new statistics are seen in the netstat command
when it is given the -s command line switch.
MFC after: 2 weeks
In collaboration with: bz
L2 code does not have the ethernet address for the destination
within the broadcast domain in the table, we remember the
original mbuf in `la_hold' in arpresolve() and send out a
different packet with an arp request.
In case there will be more upper layer packets to send we will
free an earlier one held in `la_hold' and queue the new one.
Once we get a packet in, with which we can perfect our arp table
entry we send out the original 'on hold' packet, should there
be any.
Rather than continuing to process the packet that we received,
we returned without freeing the packet that came in, which
basically means that we leaked an mbuf for every arp request
we sent.
Rather than freeing the received packet and returning, continue
to process the incoming arp packet as well.
This should (a) improve some setups, also proxy-arp, in case it was an
incoming arp request and (b) resembles the behaviour FreeBSD had
from day 1, which alignes with RFC826 "Packet reception" (merge case).
Rename 'm0' to 'hold' to make the code more understandable as
well as diffable to earlier versions more easily.
Handle the link-layer entry 'la' lock comepletely in the block
where needed and release it as early as possible, rather than
holding it longer, down to the end of the function.
Found by: pointyhat, ns1
Bug hunting session with: erwin, simon, rwatson
Tested by: simon on cluster machines
Reviewed by: ratson, kmacy, julian
MFC after: 3 days
- Routing messages are not generated when adding and removing
interface address aliases.
- Loopback route installed for an interface address alias is
not deleted from the routing table when that address alias
is removed from the associated interface.
- Function in_ifscrub() is called extraneously.
Reviewed by: gnn, kmacy, sam
MFC after: 3 days
ip_output() if the cached route was not initialized from the
flow-table. The rt_lle entry is invalid unless it has been
initialized through the flow-table.
Reviewed by: kmacy, rwatson
MFC after: immediately
list/index locks, to protect link layer address tables. This avoids
lock order issues during interface teardown, but maintains the bug that
sysctl copy routines may be called while a non-sleepable lock is held.
Reviewed by: bz, kmacy
MFC after: 3 days
1) When calculating the table offset for sliding the sack
array, the two byte values must be "ored" together in order
for us to do the correct sliding of the arrays.
2) We were NOT properly doing CC and other changes to things only
NR-Sacked. The solution here is to make a separate function that
will actually do both CC/updates and free things if its NR sack'd.
This actually shrinks out common code from three places (much better).
MFC after: 3 days
from the existing modevent / MOD_UNLOAD handler, and register div_destroy()
in protosw as per-vnet .pr_destroy() handler for options VIMAGE builds. In
nooptions VIMAGE builds, div_destroy() will be invoked from the modevent
handler, resulting in effectively identical operation as it was prior this
change. div_destroy() also tears down hashtables used by ipdivert, which
were previously left behind on ipdivert kldunloads.
For options VIMAGE builds only, temporarily disable kldunloading of ipdivert,
because without introducing additional locking logic it is impossible to
atomically check whether all ipdivert instances in all vnets are idle, and
proceed with cleanup without opening a race window for a vnet to open an
ipdivert socket while ipdivert tear-down is in progress.
While here, staticize div_init(), because it is not used outside of
ip_divert.c.
In cooperation with: julian
Approved by: re (rwatson), julian (mentor)
MFC after: 3 days
several critical bugs, including race conditions and lock order issues:
Replace the single rwlock, ifnet_lock, with two locks, an rwlock and an
sxlock. Either can be held to stablize the lists and indexes, but both
are required to write. This allows the list to be held stable in both
network interrupt contexts and sleepable user threads across sleeping
memory allocations or device driver interactions. As before, writes to
the interface list must occur from sleepable contexts.
Reviewed by: bz, julian
MFC after: 3 days
to allow vnet and non vnet operation. Move some functions from ip_fw_pfil.c
to ip_fw2.c and mode to mostly using the SYSINIT and VNET_SYSINIT handlers
instead of the modevent handler. Correct some spelling errors in comments
in the affected code. Note this bug fixes a crash in NON VIMAGE kernels when
ipfw is unloaded.
This patch is a minimal patch for 8.0
I have a much larger patch that actually fixes the underlying problems
that will be applied after 8.0
Reviewed by: zec@, rwatson@, bz@(earlier version)
Approved by: re (rwatson)
MFC after: Immediatly
CARP tries to free them using M_IFADDR after the last address for a virtual
host is removed and when detaching from the parent interface.
Reviewed by: mlaier
Approved by: re (kib), ken (mentor)
the mbuf for obtaining the fib index
- check that a cached flow corresponds to the same fib index as the
packet for which we are doing the lookup
- at interface detach time flush any flows referencing stale rtentrys
associated with the interface that is going away (fixes reported
panics)
- reduce the time between cleans in case the cleaner is running at
the time the eventhandler is called and the wakeup is missed less
time will elapse before the eventhandler returns
- separate per-vnet initialization from global initialization
(pointed out by jeli@)
Reviewed by: sam@
Approved by: re@
association setup.
* Fix a bug where message with illegal stream ids are not deleted.
* Fix a crash when reporting back unsent messages from the send_queue.
* Fix a bug related to INIT retransmission when the socket is already
closed.
* Fix a bug where associations were stalled when partial delivery API
was enabled.
* Fix a bug where the receive buffer size was smaller than the
partial_delivery_point.
Approved by: re, rrs (mentor)
MFC after: One day.
mismatch between the cached entry and the intended destination. The
cached rtentry{} is flushed but the associated llentry{} is not. This
causes the wrong destination MAC address being used in the output
packets. The fix is to flush the llentry{} when rtentry{} is cleared.
Reviewed by: kmacy, rwatson
Approved by: re
Receiving any ip packet for which there is no existing socket will
crash if ipfw has a uid or gid test rule, as the uid/gid
of the non existent owner of said non existent socket is tested.
Brooks introduced this error as part of his >16 gids patch.
It appears to be a cut-n-paste error from similar code a few lines
before. The old code used the 'pcb' variable here, but in the
new code that switched the 'inp' variable, which is often NULL
and what is tested in the code further up. The rest of the multi-gid
patch for ipfw seems solid (and cleaner than previous code).
Reviewed by: brooks
Approved by: re (rwatson)
