Pulled firmware_ids.h from firmwaresrc and applied genfwdef script.
Submitted by: Richard Houldsworth <rhouldsworth at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4897
The EFSYS_OPT_RX_HDR_SPLIT optional feature in the common code
implemented the Lookahead Split feature of Windows. This split
received packets at a preconfigured byte offset, and delivered
the header and payload portions to separate receive queues.
Now the common code interface has no callers, so remove it.
Note that this should not be confused with the Header Data Split
feature of Windows, which splits packets at a header boundary.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4888
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4880
option to invert the polarity in software. Also add an option to capture
very narrow pulses by using the hardware's MSR delta-bit capability of
latching line state changes.
This effectively reverts the mistake I made in r286595 which was based on
empirical measurements made on hardware using TTL-level signaling, in which
the logic levels are inverted from RS-232. Thus, this re-syncs the polarity
with the requirements of RFC 2783, which is writen in terms of RS-232
signaling.
Narrow-pulse mode uses the ability of most ns8250 and similar chips to
provide a delta indication in the modem status register. The hardware is
able to notice and latch the change when the pulse width is shorter than
interrupt latency, which results in the signal no longer being asserted by
time the interrupt service code runs. When running in this mode we get
notified only that "a pulse happened" so the driver synthesizes both an
ASSERT and a CLEAR event (with the same timestamp for each). When the pulse
width is about equal to the interrupt latency the driver may intermittantly
see both edges of the pulse. To prevent generating spurious events, the
driver implements a half-second lockout period after generating an event
before it will generate another.
Differential Revision: https://reviews.freebsd.org/D4477
Prior to Medford, option ROM config was stored with one partition
per network port. Medford stores option ROM config in a single
partition (as an array of configurations, one per PF).
Update the EFXname /port to MCDI partition mapping for this.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4885
Make error messages consistent, and remove redundant checks.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4884
This API has been replaced by efx_mac_multicast_list_set()
and has no callers.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4883
New filters types may be added, but the same machinery should be able to
handle them.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4881
These bigs are changed on Medford.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4876
The pktfilter module has been obsolete for some time, as
it was replaced by newer features in filter module. With
the removal of the storport driver, this module has no
users and can be removed.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4875
Some new partitions have been added, but they shouldn't need to be
handled any differently.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4873
Rename all except hunt_tx_qdesc_tso_create(), which creates a
fw-assisted TSO v1 descriptor which isn't supported on Medford.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4870
All of these apply to both Huntington and Medford.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4868
This should allow these functions to work for Medford as well.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4866
All these fields will be used in shared ef10 code, so put them in an
ef10 member of a per-architecture union, rather that in the per-chip
union.
Submitted by: Mark Spender <mspender at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4865
Creating some files together to do the build system changes in one go.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4859
This one mainly avoids mbuf cluster allocation for TCP ACKs during
TCP sending tests. And it gives me ~200Mbps improvement (4.7Gbps
-> 4.9Gbps), when running iperf3 TCP sending test w/ 16 connections.
While I'm here, nuke the unnecessary zeroing out pkthdr.csum_flags.
Reviewed by: adrain
Approved by: adrian (mentor)
Sponsored by: Microsoft OSTC
Differential Revision: https://reviews.freebsd.org/D4853
Many applications and kernel modules (e.g. bridge) rely on the ifmedia
status report; give them what they want.
Submitted by: Dexuan Cui <decui microsoft com>
Reviewed by: Jun Su <junsu microsoftc com>, me, adrian
Modified by: me (minor)
Original differential: https://reviews.freebsd.org/D4611
Differential Revision: https://reviews.freebsd.org/D4852
Approved by: adrian (mentor)
Sponsored by: Microsoft OSTC
- Implement the LRO using tcp_lro APIs, and LRO is enabled by default.
- Add several stats sysctl nodes.
- Check IP/TCP length before sending the packet to tcp_lro_rx(), if host
does not provide RX csum information (*); and add an option through
sysctl to always trust host TCP segment csum checks (default is off).
- Add sysctl to control the LRO entry depth; it is disabled by default.
It is used to avoid holding too much TCP segments in driver. Limiting
the LRO entry depth helps a lot in a one/two streams RX test.
This one 3x the RX performance on my local test (3Gbps -> 10Gbps), and
~2x the RX performance over a directly connected 40Ge network (5Gbps ->
9Gbps).
(*) It seems the host stops supplying csum information, once the network
load is high. This still needs investigation...
Reviewed by: Hongjiang Zhang <honzhan microsoft com>,
Dexuan Cui <decui microsoft com>,
Jun Su <junsu microsoft com>,
delphij
Tested by: me (local),
Hongjiang Zhang <honzhan microsoft com>
(directly connected 40Ge)
Approved by: delphij (mentor), adrian (mentor, no objection)
With feedback from: delphij, Hongjiang Zhang <honzhan microsoft com>
Sponsored by: Microsoft OSTC
Differential Revision: https://reviews.freebsd.org/D4824
This will allow to restore channel list after switching interface
to more restrictive regdomain.
Tested with Intel 3945BG (wpi) only.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D4863
by busdma to the blkfront driver must be an integer number of sectors,
and must be aligned in memory on a "sector" boundary.
Having these assertions yesterday would have made finding the bug fixed
in r293698 somewhat easier.
Ensure that all iSCSI sessions are correctly terminated during shutdown.
* Enhances the changes done by r286226 (D3052).
* Add shutdown post sync event to run after filesystem shutdown
(SHUTDOWN_PRI_FIRST) but before CAM shutdown (SHUTDOWN_PRI_DEFAULT).
* Changes iscsi_maintenance_thread to processes terminate in preference to
reconnect.
Reviewed by: trasz
MFC after: 2 weeks
Sponsored by: Multiplay
Differential Revision: https://reviews.freebsd.org/D4429
- Add a description of Advantech PCI-1602 Rev. A boards. [1]
- Properly set up REG_ACR also for PCI-1602 Rev. A based on what the
Advantech-supplied Linux driver does.
- Additionally use the macros of <dev/ic/ns16550.h> to replace existing
magic values and get rid of trivial comments.
- Fix the style of some comments.
PR: 205359 [1]
Submitted by: Jan Mikkelsen (original patch) [1]
