Without this the PHY wouldn't work as expected. This should fix
dual-boot Windows XP machine where RealTek Windows drivers put the
PHY in power down mode during shutdown. The magic PHY register
accesses come from RealTek driver. No datasheets mention the magic
PHY registers.
In general, the PHY wakeup code should go into PHY driver. However it
seems that it only apply to RTL8169S single chip and it would be
another hack if we have rgephy(4) check what parent driver/chip model
is attached.
Reported by: lofi, Laurens Timmermans ( laurens AT timkapel DOT nl )
Tested by: lofi
Obtained from: RealTek FreeBSD driver
Approved by: re (Ken Smith)
- Don't leak the config lock if detach() fails due to the controller char
dev being open.
- Close a race between detach() and a process opening the controller char
dev.
MFC after: 1 week
Approved by: re (bmah)
Fix a resource allocation bug (explained by jhb on -acpi)
Thanks for Mike Tancsa for testing and helping track down the bug.
Approved by: re (kensmith)
MFC after: 3 weeks
detailed status on each of the backing subdisks. This allows userland
to see which subdisks are online, failed, missing, or a hot spare.
MFC after: 1 week
Approved by: re (bmah)
Reviewed by: sos
differ in their details with calls to a new function, ehci_hcreset(),
that performs the reset.
The original sequences either had no delay or a 1ms delay between
telling the controller to stop and asserting the controller reset
bit. One instance of the original reset sequence waited for the
controller to indicate that its reset was complete before continuing,
but the other two immediately let the subsequent code execute. The
latter is a problem on some hardware, because a read of the HCCPARAMS
register returns an incorrect value while the reset is in progress,
which triggers an infinite loop in ehci_pci_givecontroller(), which
hangs the system on shutdown.
The reset sequence in ehci_hcreset() starts with the most complete
instance from the original code, which contains a loop to wait for
the controller to indicate that its reset is complete. This appears
to be the correct thing to do according to "Enhanced Host Controller
Interface Specification for Universal Serial Bus" revision 1.0,
section 2.3.1. Add another loop to wait for the controller to
indicate that it has stopped before setting the HCRESET bit. This
is required by the section 2.3.1 in the specification, which says
that setting HCRESET before the controller has halted "will result
in undefined behaviour".
Reviewed by: imp (previous patch version without the extra wait loop)
Tested by: se (previous patch version without the extra wait loop)
Approved by: re (bmah)
MFC after: 1 week
o Revamp the PIC I/F to only abstract the PIC hardware. The
resource handling has been moved to nexus, where it belongs.
o Include EOI and MASK+EOI methods to the PIC I/F in support of
INTR_FILTER.
o With the allocation of interrupt resources and setup of
interrupt handlers in the common platform code we can delay
talking to the PIC hardware after enumeration of all devices.
Introduce a call to powerpc_intr_enable() in configure_final()
to achieve that and have powerpc_setup_intr() only program the
PIC when !cold.
o As a consequence of the above, remove all early_attach() glue
from the OpenPIC and Heathrow PIC drivers and have them
register themselves when they're found during enumeration.
o Decouple the interrupt vector from the interrupt request line.
Allocate vectors increasingly so that they can be used for
the intrcnt index as well. Extend the Heathrow PIC driver to
translate between IRQ and vector. The OpenPIC driver already
has the support for vectors in hardware.
Approved by: re (blanket)
- LK_RETRY prohibits vget() and vn_lock() to return error.
Remove associated code. [1]
- Properly use vhold() and vdrop() instead of their unlocked
versions, we are guaranteed to have the vnode's interlock
unheld. [1]
- Fix a pseudo-infinite loop caused by 64/32-bit arithmetic
with the same way used in modern NetBSD versions. [2]
- Reorganize tmpfs_readdir to reduce duplicated code.
Submitted by: kib [1]
Obtained from: NetBSD [2]
Approved by: re (tmpfs blanket)
- Respect cnflag and don't lock vnode always as LK_EXCLUSIVE [1]
- Properly lock around tn_vnode to avoid NULL deference
- Be more careful handling vnodes (*)
(*) This is a WIP
[1] by pjd via howardsu
Thanks kib@ for his valuable VFS related comments.
Tested with: fsx, fstest, tmpfs regression test set
Found by: pho's stress2 suite
Approved by: re (tmpfs blanket)
cr0-4, etc. Support should be added for other platforms that have a
different set of registers for system use.
Loosely based on: OpenBSD
Approved by: re
a test that assumes that char is signed by default and causes a
warning with GCC 4.2 on PowerPC.
A patch has been sent to the maintainer that addresses this.
Approved by: re (blanket)
of device pager in the pagers list by handle is now synchronized with
its removal from the list, and dev_pager_mtx is put before vm object
lock in lock order. Dispose the dev_pager_sx lock, since dev_pager_mtx
now covers the same block.
Noted by: kensmith
Reviewed by: alc
Approved by: re (kensmith)
(uio_offset < 0) since this can't happen. If this happens, then the
general code handles the problem safely (better than before for reading,
returning 0 (EOF) instead of the bogus errno EINVAL, and the same as
before for writing, returning EFBIG).
In msdosfs_read(), don't check for (uio_resid < 0). msdosfs_write()
already didn't check.
In msdosfs_read(), document in a comment our assumptions that the caller
passed a valid uio_offset and uio_resid. ffs checks using KASSERT(),
and that is enough sanity checking. In the same comment, partly document
there is no need to check for the EOVERFLOW case, unlike in ffs where this
case can happen at least in theory.
In msdosfs_write(), add a comment about why the checking of
(uio_resid == 0) is explicit, unlike in ffs.
In msdosfs_write(), check for impossibly large final offsets before
checking if the file size rlimit would be exceeded, so that we don't
have an overflow bug in the rlimit check and are consistent with ffs.
We now return EFBIG instead of EFBIG plus a SIGXFSZ signal if the final
offset would be impossibly large but not so large as to cause overflow.
Overflow normally gave the benign behaviour of no signal.
Approved by: re (kensmith) (blanket)
remove some parentheses; fix some whitespace errors; fix only one case of
a boolean comparison of a non-boolean).
Improve an error message by quoting ".", and by not printing large positive
values as negative ones.
Approved by: re (kensmith) (blanket)
namespace pollution in <sys/vnode.h>.
Sort the include of <sys/mutex.h> instead of unsorting it after
<sys/vnode.h> and depending on the pollution there.
Approved by: re (kensmith) (blanket)
the use of divert sockets to dead locks. A number of LORs have been reported
between divert and a number of other network subsystems including: IPSEC, Pfil,
multicast, ipfw and others. Other dead locks could occur because of recursive
entry into the IP stack. This change should take care of most if not all of
these issues.
A summary of the changes follow:
- We disallow multicast operations on divert sockets. It really doesn't make
semantic sense to allow this, since typically you would set multicast
parameters on multicast end points.
NOTE: As a part of this change, we actually dis-allow multicast options on
any socket that IS a divert socket OR IS NOT a SOCK_RAW or SOCK_DGRAM family
- We check to see if there are any socket options that have been specified on
the socket, and if there was (which is very un-common and also probably
doesnt make sense to support) we duplicate the mbuf carrying the options.
- We then drop the INP/INFO locks over the call to ip_output(). It should be
noted that since we no longer support multicast operations on divert sockets
and we have duplicated any socket options, we no longer need the reference
to the pcb to be coherent.
- Finally, we replaced the call to ip_input() to use netisr queuing. This
should remove the recursive entry into the IP stack from divert.
By dropping the locks over the call to ip_output() we eliminate all the lock
ordering issues above. By switching over to netisr on the inbound path,
we can no longer recursively enter the ip_input() code via divert.
I have tested this change by using the following command:
ipfwpcap -r 8000 - | tcpdump -r - -nn -v
This should exercise the input and re-injection (outbound) path, which is
very similar to the work load performed by natd(8). Additionally, I have
run some ospf daemons which have a heavy reliance on raw sockets and
multicast.
Approved by: re@ (kensmith)
MFC after: 1 month
LOR: 163
LOR: 181
LOR: 202
LOR: 203
Discussed with: julian, andre et al (on freebsd-net)
In collaboration with: bms [1], rwatson [2]
[1] bms helped out with the multicast decisions
[2] rwatson submitted the original netisr patches and came up with some
of the original ideas on how to combat this issue.
for bakeoff.. using the next sequential ones)
- In cookie processing 1-2-1, we did not increment the stcb
refcnt before releasing the tcb lock. We need to do this
to keep the tcb from being freed by a abort or ?? unlikely
but worth doing. Also get rid of unneed INP_WLOCK.
- extra receive info included the rcvinfo which killed the
padding/alignment. We now redefine all the fields properly
so they both align properly both to 128 bytes.
- A peeled off socket would not close without an error due to
its misguided idea that sctp_disconnect() was not supported
on it. This fixes it so it goes through the proper path.
- When an assoc was being deleted after abort (via a timer) a
small race condition exists where we might take a packet for
the old assoc (since we are waiting for a cleanup timer). This
state especially happens in mac. We now add a state in the asoc
so these can properly handle the packet as OOTB.
Approved by: re@freebsd.org(Ken Smith)
previously conditionally acquired Giant based on debug.mpsafenet. As that
has now been removed, they are no longer required. Removing them
significantly simplifies error-handling in the socket layer, eliminated
quite a bit of unwinding of locking in error cases.
While here clean up the now unneeded opt_net.h, which previously was used
for the NET_WITH_GIANT kernel option. Clean up some related gotos for
consistency.
Reviewed by: bz, csjp
Tested by: kris
Approved by: re (kensmith)
Recently the AP in my Merced box seems to have grown a habit
of getting unexpected interrupts, such as redundant wake-ups
and legacy interrupts that require an INTA cycle.
While here, replace DELAY(0) with cpu_spinwait() so that it's
clear what we're doing as well as enable the code to take
advantage of cpu_spinwait() when it gets implemented.
Approved by: re (blanket)
There's no advantage in allowing nested external interrupts.
In fact, it leads to a potential stack overrun.
While here, put the interrupt vector in the trapframe, so as
to compensate for the 36 cycle latency of reading cr.ivr.
Further simplify assembly code by dealing with ASTs from C.
Approved by: re (blanket)
vm_object_terminate() on a device-backed object at the same time that
another processor, call it Pa, is performing dev_pager_alloc() on the
same device. The problem is that vm_pager_object_lookup() should not be
allowed to return a doomed object, i.e., an object with OBJ_DEAD set,
but it does. In detail, the unfortunate sequence of events is: Pt in
vm_object_terminate() holds the doomed object's lock and sets OBJ_DEAD
on the object. Pa in dev_pager_alloc() holds dev_pager_sx and calls
vm_pager_object_lookup(), which returns the doomed object. Next, Pa
calls vm_object_reference(), which requires the doomed object's lock, so
Pa waits for Pt to release the doomed object's lock. Pt proceeds to the
point in vm_object_terminate() where it releases the doomed object's
lock. Pa is now able to complete vm_object_reference() because it can
now complete the acquisition of the doomed object's lock. So, now the
doomed object has a reference count of one! Pa releases dev_pager_sx
and returns the doomed object from dev_pager_alloc(). Pt now acquires
dev_pager_mtx, removes the doomed object from dev_pager_object_list,
releases dev_pager_mtx, and finally calls uma_zfree with the doomed
object. However, the doomed object is still in use by Pa.
Repeating my key point, vm_pager_object_lookup() must not return a
doomed object. Moreover, the test for the object's state, i.e.,
doomed or not, and the increment of the object's reference count
should be carried out atomically.
Reviewed by: kib
Approved by: re (kensmith)
MFC after: 3 weeks
us to do the data serializations once after writing multiple
region registers, as is done in pmap_switch(). All existing
calls to ia64_set_rr() are followed with calls to ia64_srlz_d().
Approved by: re (blanket)
