Note that setting the PTE_MODIFIED bit based on whether write is possible
is incorrect. We should set PTE_MODIFIED based on whether the access
is a write operation.
routines.
This unbreaks Book-E build after the recent machine/mutex.h removal.
While there move tlb_*lock() prototypes to machine/tlb.h.
Submitted by: jhb
Previously, DBCR0 flags were set "globally", but this leads to problems
because Book-E fine grained debug settings work only in conjuction with the
debug master enable bit in MSR: in scenarios when the DBCR0 was set with
intention to debug one process, but another one with MSR[DE] set got
scheduled, the latter would immediately cause debug exceptions to occur upon
execution of its own code instructions (and not the one intended for
debugging).
To avoid such problems and properly handle debugging context, DBCR0 state
should be managed individually per process.
Submitted by: Grzegorz Bernacki gjb ! semihalf dot com
Reviewed by: marcel
o Eliminate tlb0[] (a s/w copy of TLB0)
- The table contents cannot be maintained reliably in multiple MMU
environments, where asynchronous events (invalidations from other cores)
can change our local TLB0 contents underneath.
- Simplify and optimize TLB flushing: system wide invalidations are
performed using tlbivax instruction (propagates to other cores), for
local MMU invalidations a new optimized routine (assembly) is introduced.
o Improve and simplify TID allocation and management.
- Let each core keep track of its TID allocations.
- Simplify TID recycling, eliminate dead code.
- Drop the now unused powerpc/booke/support.S file.
o Improve page tables management logic.
o Simplify TLB1 manipulation routines.
o Other improvements and polishing.
Obtained from: Freescale, Semihalf
The PQ3 is a high performance integrated communications processing system
based on the e500 core, which is an embedded RISC processor that implements
the 32-bit Book E definition of the PowerPC architecture. For details refer
to: http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=MPC8555E
This port was tested and successfully run on the following members of the PQ3
family: MPC8533, MPC8541, MPC8548, MPC8555.
The following major integrated peripherals are supported:
* On-chip peripherals bus
* OpenPIC interrupt controller
* UART
* Ethernet (TSEC)
* Host/PCI bridge
* QUICC engine (SCC functionality)
This commit brings the main functionality and will be followed by individual
drivers that are logically separate from this base.
Approved by: cognet (mentor)
Obtained from: Juniper, Semihalf
MFp4: e500
