De-hardcode usage of ARM_TP_ADDRESS and RAS local storage, and move this
special purpose page to a more convenient place i.e. after the vectors high
page, more towards the end of address space. Previous location (0xe000_0000)
caused grief if KVA was to go beyond the default limit.
Note that ARM world rebuilding is required after this change since the
location of ARM_TP_ADDRESS is shared between kernel and userland.
Submitted by: Grzegorz Bernacki (gjb AT semihalf dot com)
Reviewed by: imp
Approved by: cognet (mentor)
The RAS implementation would set the end address, then the start
address. These were used by the kernel to restart a RAS sequence if
it was interrupted. When the thread switching code ran, it would
check these values and adjust the PC and clear them if it did.
However, there's a small flaw in this scheme. Thread T1, sets the end
address and gets preempted. Thread T2 runs and also does a RAS
operation. This resets end to zero. Thread T1 now runs again and
sets start and then begins the RAS sequence, but is preempted before
the RAS sequence executes its last instruction. The kernel code that
would ordinarily restart the RAS sequence doesn't because the PC isn't
between start and 0, so the PC isn't set to the start of the sequence.
So when T1 is resumed again, it is at the wrong location for RAS to
produce the correct results. This causes the wrong results for the
atomic sequence.
The window for the first race is 3 instructions. The window for the
second race is 5-10 instructions depending on the atomic operation.
This makes this failure fairly rare and hard to reproduce.
Mutexs are implemented in libthr using atomic operations. When the
above race would occur, a lock could get stuck locked, causing many
downstream problems, as you might expect.
Also, make sure to reset the start and end address when doing a syscall, or
a malicious process could set them before doing a syscall.
Reviewed by: imp, ups (thanks guys)
Pointy hat to: cognet
MFC After: 3 days
It only supports sa1110 (on simics) right now, but xscale support should come
soon.
Some of the initial work has been provided by :
Stephane Potvin <sepotvin at videotron.ca>
Most of this comes from NetBSD.
