This adds support for bhnd_nvram_val_convert_init() and
bhnd_nvram_val_convert_new(), which may be used to perform value
format-aware encoding of an NVRAM value to a new target format/type.
This will be used to simplify converting to/from serialized
format-specific NVRAM value representations to common external
representations.
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8757
representing arbitrary Broadcom NVRAM key/value pairs.
This will be used to track pending changes in bhnd_nvram_store, and
provide support for exporting all or a device subpath for NVRAM (as
required by some fullmac wifi chipsets).
Approved by: adrian (mentor)
Differential Revision: https://reviews.freebsd.org/D8756
boot panics in conjunction with the recently added EARLY_AP_STARTUP feature.
The panics happen due to using kernel facilities like callouts too early.
Tested by: jhb @
MFC after: 1 week
This 6 times gettimeofday performance, as measured by
tools/tools/syscall_timing
Reviewed by: kib
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8789
enabled. This results in a -Werror warning in mlx4ib:
sys/dev/mlx4/mlx4_ib/mlx4_ib_sysfs.c:90:22: error: format specifies type 'unsigned long long *' but the argument has type 'u64 *' (aka 'unsigned long *') [-Werror,-Wformat]
sscanf(buf, "%llx", &sysadmin_ag_val);
~~~~ ^~~~~~~~~~~~~~~~
Change sysadmin_ag_val to unsigned long long to avoid the warning.
Reviewed by: hselasky
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D8831
As cs is stored in a uint32_t, use the last bit to store the
active high flag as it's unlikely that we will have that much CS.
Reviewed by: loos
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D8614
Remove unused fields from uart_pl011_softc. Add an interrupt mask
field to the softc and use it to set the interrupt mask register.
There should be no functional change introduced here except in the
grab and ungrab functions. In these functions, we now disable and
enable all interrupts rather than just the receive interrupt.
Make st_data part of spigen_transfer optional by letting pass zero length
and NULL pointer. SPI controller drivers handle this case fine.
MFC after: 1 week
memory-mapped devices that are normally PCIe drives. Devices can then use
the existing pci_get_class, etc. accessors to query this data.
The ivar values are different enough from the existing ACPI and ISA values
to not conflict.
Reviewed by: jhb
Obtained from: ABT Systems Ltd
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D8721
- Disable features that are not supported or not used on FreeBSD.
- Increase the RSS table slice per interface.
- Increase the share of the TCAM reserved for filtering.
MFH: 2 weeks
Sponsored by: Chelsio Communications
This paves way to implement VDSO for the enlightened time counter.
Reviewed by: kib
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8768
feature_barrier and feature_flush variables. Otherwise, adjacent
variables on the stack, such as sector_size, may be overwritten, with
disastrous results.
Note that I did not see a good reason to revert the addition of zero
checks introduced in r310013. Better safe than sorry.
PR: 215209
Tested by: royger
MFC after: 3 days
In order to make Prometheus do graphing/alerting on thermal sensors in a
generic fashion, we should attach the name of the thermal zone device as
a label. That way there is only a single metric for the temperature of a
thermal zone, with its name attached as a label.
Reviewed by: cem
Differential Revision: https://reviews.freebsd.org/D8775
This commit corrects print of nomatch (newline was too early) and fix
unit number for new child in ar5315_spi (was 0, now is -1 to calculate it
according to actual system state)
Submitted by: Hiroki Mori <yamori813@yahoo.co.jp>
Reviewed by: ray, loos, mizhka
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D8749
non-zero sector size. Such a device would be a virtual disk of zero
bytes; clearly not useful, and not something we should try to attach.
As a fortuitous side effect, checking that these values are non-zero
here results in them not *becoming* zero later on the function. This
odd behaviour began with r309124 (clang 3.9.0) but is challenging to
debug; making any changes to this function whatsoever seems to affect
the llvm optimizer behaviour enough to make the unexpected zeroing of
the sector_size variable cease.
PR: 215209
Security: The potential for variables to unexpectedly become zero
has worrying consequences for security in general, but
not so much in this particular context.
Some clocks on SoC have a diff between the value written in the register
and the real divider.
Add a table that where we can lookup the real value of the divider.
Reviewed by: mmel (earlier revision)
Differential Revision: https://reviews.freebsd.org/D8728
ARM GIC specification in device trees use 3 cells, so the current
limit of 2 causes the last cell to be dropped. This in turn can
cause the interrupt polarity and trigger settings to be incorrect.
Increase the limit to 4 which should handle all reasonable cases.
This fixes issues seen in QEMU when registering PCI interrupts.
- Do not ignore initialization errors; call ieee80211_stop()
when initialization failed.
- Use usb_pause_mtx() instead of DELAY() while waiting for firmware
loading; this fixes system freeze during firmware startup.
- Do not execute rsu_stop() when device is powered off; fixes
'unknown board type (rfconfig=0xff)' error when the device is
reattached.
Tested with Asus USB-N10.
- Replace all remaining DPRINTF(N)'s with RSU_DPRINTF.
- Add new RSU_DEBUG_USB flag to track error codes returned by
usbd_do_request_flags().
- Improve few messages.
- Add partial promiscuous mode support (no management frames;
they cannot be received by the firmware and net80211 at the same time).
- Add monitor mode support (all frames).
Tested with Asus, USB-N10.
For horizontal (T-axis) wheel reporting which is not supported by
sysmouse protocol kern.evdev.sysmouse_t_axis sysctl is introduced.
It can take following values:
0 - no T-axis events (default)
1 - T-axis events are originated in ums(4) driver.
2 - T-axis events are originated in psm(4) driver.
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D8597
BUS_DMASYNC_PREREAD is required when setting up RX buffer, otherwise
data provided by card can be overwritten by data evicted from cache
Also use proper tag when setting up RX descriptor
Reviewed by: adrian, avos, ivadasz
Differential Revision: https://reviews.freebsd.org/D8717
This is required for USB Rx aggregation
(and fixes 'could not allocate RX mbuf' / few other failures).
While here, reduce the number of Rx buffers from 100 to 1 -
the driver never uses more than one Rx buffer.
Tested with Asus USB-N10.
Changes include modifications in kernel crash dump routines, dumpon(8) and
savecore(8). A new tool called decryptcore(8) was added.
A new DIOCSKERNELDUMP I/O control was added to send a kernel crash dump
configuration in the diocskerneldump_arg structure to the kernel.
The old DIOCSKERNELDUMP I/O control was renamed to DIOCSKERNELDUMP_FREEBSD11 for
backward ABI compatibility.
dumpon(8) generates an one-time random symmetric key and encrypts it using
an RSA public key in capability mode. Currently only AES-256-CBC is supported
but EKCD was designed to implement support for other algorithms in the future.
The public key is chosen using the -k flag. The dumpon rc(8) script can do this
automatically during startup using the dumppubkey rc.conf(5) variable. Once the
keys are calculated dumpon sends them to the kernel via DIOCSKERNELDUMP I/O
control.
When the kernel receives the DIOCSKERNELDUMP I/O control it generates a random
IV and sets up the key schedule for the specified algorithm. Each time the
kernel tries to write a crash dump to the dump device, the IV is replaced by
a SHA-256 hash of the previous value. This is intended to make a possible
differential cryptanalysis harder since it is possible to write multiple crash
dumps without reboot by repeating the following commands:
# sysctl debug.kdb.enter=1
db> call doadump(0)
db> continue
# savecore
A kernel dump key consists of an algorithm identifier, an IV and an encrypted
symmetric key. The kernel dump key size is included in a kernel dump header.
The size is an unsigned 32-bit integer and it is aligned to a block size.
The header structure has 512 bytes to match the block size so it was required to
make a panic string 4 bytes shorter to add a new field to the header structure.
If the kernel dump key size in the header is nonzero it is assumed that the
kernel dump key is placed after the first header on the dump device and the core
dump is encrypted.
Separate functions were implemented to write the kernel dump header and the
kernel dump key as they need to be unencrypted. The dump_write function encrypts
data if the kernel was compiled with the EKCD option. Encrypted kernel textdumps
are not supported due to the way they are constructed which makes it impossible
to use the CBC mode for encryption. It should be also noted that textdumps don't
contain sensitive data by design as a user decides what information should be
dumped.
savecore(8) writes the kernel dump key to a key.# file if its size in the header
is nonzero. # is the number of the current core dump.
decryptcore(8) decrypts the core dump using a private RSA key and the kernel
dump key. This is performed by a child process in capability mode.
If the decryption was not successful the parent process removes a partially
decrypted core dump.
Description on how to encrypt crash dumps was added to the decryptcore(8),
dumpon(8), rc.conf(5) and savecore(8) manual pages.
EKCD was tested on amd64 using bhyve and i386, mipsel and sparc64 using QEMU.
The feature still has to be tested on arm and arm64 as it wasn't possible to run
FreeBSD due to the problems with QEMU emulation and lack of hardware.
Designed by: def, pjd
Reviewed by: cem, oshogbo, pjd
Partial review: delphij, emaste, jhb, kib
Approved by: pjd (mentor)
Differential Revision: https://reviews.freebsd.org/D4712
On pre-WS2016 Hyper-V, if the only LUNs > 7 are used, then all disks
fails to attach. Mainly because those versions of Hyper-V do not set
SRB_STATUS properly and deliver junky INQUERY responses.
Submitted by: Hongjiang Zhang <honzhan microsoft com>
Reported by: Hongxiong Xian <v-hoxian microsoft com>
MFC after: 1 week
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D8724
In particular, the fault access type is accounted for when the
aperture page is moved to GTT domain. On the other hand, the current
pager structure is left intact, most important, only one page is
instantiated per populate call.
Reviewed by: alc
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
values. This more closely matches other wifi drivers in the tree.
The bitmap levels have been based closely on other drivers (primarily
[u]rtwn(4)) in the hope that one day these can be unified into a shared
wifi-debug framework.
This is the first step of several pieces of work I'm planning on doing
with the run(4) driver. I may well adjust and refine some of the debug
bitmaps at a later date.
Reviewed by: adrian, avos
Differential Revision: https://reviews.freebsd.org/D8704
