or not a process in a jail, with privilege, may set the jail's hostname.
Defaults to 1, which permits this. May be set to 0 by a process with
appropriate privilege outside of jail. Preventing hostname renaming
from within a jail is currently required to make jails manageable, as they
a currently identifiable only by hostname using /proc, which may be
modified without this sysctl being set to 0. This will be documented
in upcoming man commits.
Authorized by: jkh, the ever-patient
for optimizing the unpause operation no-longer exist, and this is much
safer.
When restarting the sequencer, reconstitute the free SCB list on the card.
This deals with a single instruction gap between marking the SCB as free
and actually getting it onto the free list.
Reduce the number of transfer negotiations that occur. In the past, we
renegotiated after every reported check condition status. This ensures
that we catch devices that have unexpectidly reset. In this situation,
the target will always report the check condition before performing a
data-phase. The new behavior is to renegotiate for any check-condition where
the residual matches the orginal data-length of the command (including
0 length transffers). This avoids renegotiations during things like
variable tape block reads, where the check condition is reported only
to indicate the residual of the read.
Revamp the parity error detection logic. We now properly report and
handle injected parity errors in all phases. The old code used to hang
on message-in parity errors.
Correct the reporting of selection timeout errors to the XPT. When
a selection timeout occurs, only the currently selecting command
is flagged with SELTO status instead of aborting all currently active
commands to that target.
Fix flipped arguments in ahc_match_scb and in some of the callers of this
routine. I wish that gcc allowed you to request warnings for enums passed
as ints.
Make ahc_find_msg generically handle all message types.
Work around the target mode data-in wideodd bug in all non-U2 chips.
We can now do sync-wide target mode transfers in target mode across the
hole product line.
Use lastphase exclusively for handling timeouts. The current phase
doesn't take the bus free state into account.
Fix a bug in the timeout handler that could cause corruption of the
disconnected list.
When sending an embedded cdb to a target, ensure that we start on a
quad word boundary in the data-fifo. It seems that unaligned stores
do not work correctly.
chipset to be probed & attached on newer Dell PowerEdge servers, such as
the 2400 and 4400.
Reviewed by: dfr, msmith, jlemon
Tested by: hnokubi@yyy.or.jp (in a previous incantation)
Approved by: jkh
ptys in ways that might be unethical, especially towards processes not in
jail, or in other jails.
Submitted by: phk
Reviewed by: rwatson
Approved by: jkh
at the same time.
When rfc1323 and rfc1644 option are enabled by sysctl,
and tcp over IPv6 is tried, kernel panic happens by the
following check in tcp_output(), because now hdrlen is bigger
in such case than before.
/*#ifdef DIAGNOSTIC*/
if (max_linkhdr + hdrlen > MHLEN)
panic("tcphdr too big");
/*#endif*/
So change the above check to compare with MCLBYTES in #ifdef INET6 case.
Also, allocate a mbuf cluster for the header mbuf, in that case.
Bug reported at KAME environment.
Approved by: jkh
Reviewed by: sumikawa
Obtained from: KAME project
(1)When all related IPv6 addresses are removed,
then remove the associated IPv6 prefix.
(2)When multiple IPv6 link local addrs exist for a same
interface , then let its IPv6 prefix have multiple
interface id, and create multiple IPv6 global addrs with same
interface id.
(3)When a new IPv6 link local addr is assigned for an
interface, then let its IPv6 prefix also have the
interface id of the new IPv6 link local addr, and
create new IPv6 global addrs with same interface id.
Approved by: jkh
KAME source addr selection rule had a problem to treat IPv6 site
local addr.
The rule is completely rewritten recently and the above problem
is also fixed, but rewriting same code part in freebsd4.0 is too
dangerous in this stage, so just add workaround to avoid
the problem. Just add code for IPv6 site local addresses into IPv6
source addr selection algorythm part.
is initialised by usb_init.
This might solve problems with some controllers not being initiliased
properly, because a delay was effectively a tsleep that returned
immediately.
Approved by: jhk
Up to now, errors from DEVICE_SUSPEND(root_bus) were ignored. The fix for
this problem (the introduction of defaults for device methods) has been
committed months ago by Doug Rabson.
Second, the suspended devices were not always properly resumed on error.
Third, swapped the order for calling restore hooks and restore methods, to
be in line with the cases above.
Reviewed by: Doug Rabson
Approved by: jhk
the PIRQD bit.
This fixes the problem of uhub0 hanging forever during boot when USB
keyboard support is switched on in the BIOS on motherboards with Intel
chipsets (UHCI).
Approved by: The Sheep
fix support for multiple HPT & Promise controllers.
support mixed 33/66 devices on the Promise 66 controllers.
fix the refcount stuff in the atapi drivers.
misc cleanups.
support is also included for the ASC38C1600 Ultra160 chipset, but
as firmware is not yet available for this chip, it is disabled.
Approved by: jkh@FreeBSD.org
attempt to copy the ethernet header forward and otherwise encapsulate
a packet for output.
This fixes the panic when using VLAN devices on hardware that doesn't
do 802.1Q tagging onboard. (That is to say, all drivers except the Tigon.)
My tests consisted of telnet, ttcp, and a pingflood of packets
between 1 and 1600 (plus headers) bytes.
MFC to follow in 1 week.
Approved by: jkh
Also update wicontrol to enable/disable encryption, set WEP keys and set the
TX key index. Silver cards only have 40-bit keys. This is something of a quick
hack, but it works well enough for me to commit this from the LinuxWorld
exhibit floor.
The WEP support only shows up if you have a card that supports it.
Would have been approved by: jkh, if he hadn't wandered off somewhere
Approved in his place by: msmith, who's standing right here
conversion to eliminate the compatability shims without making any
significant changes. This eliminates the shim warnings.
Obtained from: n_himba (tweaked by me, don't blame him for this)
Approved by: jkh
