were unused or already in if_var.h so add if_name() to if_var.h and
remove net_osdep.h along with all references to it.
Longer term we may want to kill off if_name() entierly since all modern
BSDs have if_xname variables rendering it unnecessicary.
functions not yet asserting it but working on global ip6_forward_rt
route cache which is not locked and perhaps should go away in the
future though cache hit/miss ration wasn't bad.
It's #if 0ed in frag6 because the code working on ip6_forward_rt is.
filtering mechanisms to use the new rwlock(9) locking API:
- Drop the variables stored in the phil_head structure which were specific to
conditions and the home rolled read/write locking mechanism.
- Drop some includes which were used for condition variables
- Drop the inline functions, and convert them to macros. Also, move these
macros into pfil.h
- Move pfil list locking macros intp phil.h as well
- Rename ph_busy_count to ph_nhooks. This variable will represent the number
of IN/OUT hooks registered with the pfil head structure
- Define PFIL_HOOKED macro which evaluates to true if there are any
hooks to be ran by pfil_run_hooks
- In the IP/IP6 stacks, change the ph_busy_count comparison to use the new
PFIL_HOOKED macro.
- Drop optimization in pfil_run_hooks which checks to see if there are any
hooks to be ran, and returns if not. This check is already performed by the
IP stacks when they call:
if (!PFIL_HOOKED(ph))
goto skip_hooks;
- Drop in assertion which makes sure that the number of hooks never drops
below 0 for good measure. This in theory should never happen, and if it
does than there are problems somewhere
- Drop special logic around PFIL_WAITOK because rw_wlock(9) does not sleep
- Drop variables which support home rolled read/write locking mechanism from
the IPFW firewall chain structure.
- Swap out the read/write firewall chain lock internal to use the rwlock(9)
API instead of our home rolled version
- Convert the inlined functions to macros
Reviewed by: mlaier, andre, glebius
Thanks to: jhb for the new locking API
- most of the kernel code will not care about the actual encoding of
scope zone IDs and won't touch "s6_addr16[1]" directly.
- similarly, most of the kernel code will not care about link-local
scoped addresses as a special case.
- scope boundary check will be stricter. For example, the current
*BSD code allows a packet with src=::1 and dst=(some global IPv6
address) to be sent outside of the node, if the application do:
s = socket(AF_INET6);
bind(s, "::1");
sendto(s, some_global_IPv6_addr);
This is clearly wrong, since ::1 is only meaningful within a single
node, but the current implementation of the *BSD kernel cannot
reject this attempt.
Submitted by: JINMEI Tatuya <jinmei__at__isl.rdc.toshiba.co.jp>
Obtained from: KAME
passing along socket information. This is required to work around a LOR with
the socket code which results in an easy reproducible hard lockup with
debug.mpsafenet=1. This commit does *not* fix the LOR, but enables us to do
so later. The missing piece is to turn the filter locking into a leaf lock
and will follow in a seperate (later) commit.
This will hopefully be MT5'ed in order to fix the problem for RELENG_5 in
forseeable future.
Suggested by: rwatson
A lot of work by: csjp (he'd be even more helpful w/o mentor-reviews ;)
Reviewed by: rwatson, csjp
Tested by: -pf, -ipfw, LINT, csjp and myself
MFC after: 3 days
LOR IDs: 14 - 17 (not fixed yet)
compile option. All FreeBSD packet filters now use the PFIL_HOOKS API and
thus it becomes a standard part of the network stack.
If no hooks are connected the entire packet filter hooks section and related
activities are jumped over. This removes any performance impact if no hooks
are active.
Both OpenBSD and DragonFlyBSD have integrated PFIL_HOOKS permanently as well.
mode is applied, since tunneled packets are considered to be
generated packets from a tunnel encapsulating node.
- tunnel mode may not be applied if SA mode is ANY and policy
does not say "tunnel it". check if we have extra IPv6 header
on the packet after ipsec6_output_tunnel() and call ip6_output()
only if additional IPv6 header is added.
- free the copyed packet before returning.
Obtained from: KAME
accordingly. The define is left intact for ABI compatibility
with userland.
This is a pre-step for the introduction of tcp_hostcache. The
network stack remains fully useable with this change.
Reviewed by: sam (mentor), bms
Reviewed by: -net, -current, core@kame.net (IPv6 parts)
Approved by: re (scottl)
- share policy-on-socket for listening socket.
- don't copy policy-on-socket at all. secpolicy no longer contain
spidx, which saves a lot of memory.
- deep-copy pcb policy if it is an ipsec policy. assign ID field to
all SPD entries. make it possible for racoon to grab SPD entry on
pcb.
- fixed the order of searching SA table for packets.
- fixed to get a security association header. a mode is always needed
to compare them.
- fixed that the incorrect time was set to
sadb_comb_{hard|soft}_usetime.
- disallow port spec for tunnel mode policy (as we don't reassemble).
- an user can define a policy-id.
- clear enc/auth key before freeing.
- fixed that the kernel crashed when key_spdacquire() was called
because key_spdacquire() had been implemented imcopletely.
- preparation for 64bit sequence number.
- maintain ordered list of SA, based on SA id.
- cleanup secasvar management; refcnt is key.c responsibility;
alloc/free is keydb.c responsibility.
- cleanup, avoid double-loop.
- use hash for spi-based lookup.
- mark persistent SP "persistent".
XXX in theory refcnt should do the right thing, however, we have
"spdflush" which would touch all SPs. another solution would be to
de-register persistent SPs from sptree.
- u_short -> u_int16_t
- reduce kernel stack usage by auto variable secasindex.
- clarify function name confusion. ipsec_*_policy ->
ipsec_*_pcbpolicy.
- avoid variable name confusion.
(struct inpcbpolicy *)pcb_sp, spp (struct secpolicy **), sp (struct
secpolicy *)
- count number of ipsec encapsulations on ipsec4_output, so that we
can tell ip_output() how to handle the packet further.
- When the value of the ul_proto is ICMP or ICMPV6, the port field in
"src" of the spidx specifies ICMP type, and the port field in "dst"
of the spidx specifies ICMP code.
- avoid from applying IPsec transport mode to the packets when the
kernel forwards the packets.
Tested by: nork
Obtained from: KAME
then the mbuf has been consumed by a hook; otherwise beware of a null
mbuf return (gack). In particular the bridge was doing the wrong thing.
While in the ipv6 code make it's handling of pfil_run_hooks identical
to netbsd.
Pointed out by: Pyun YongHyeon <yongari@kt-is.co.kr>
o revamp IPv4+IPv6+bridge usage to match API changes
o remove pfil_head instances from protosw entries (no longer used)
o add locking
o bump FreeBSD version for 3rd party modules
Heavy lifting by: "Max Laier" <max@love2party.net>
Supported by: FreeBSD Foundation
Obtained from: NetBSD (bits of pfil.h and pfil.c)
configuration stuff as well as conditional code in the IPv4 and IPv6
areas. Everything is conditional on FAST_IPSEC which is mutually
exclusive with IPSEC (KAME IPsec implmentation).
As noted previously, don't use FAST_IPSEC with INET6 at the moment.
Reviewed by: KAME, rwatson
Approved by: silence
Supported by: Vernier Networks
This work was based on kame-20010528-freebsd43-snap.tgz and some
critical problem after the snap was out were fixed.
There are many many changes since last KAME merge.
TODO:
- The definitions of SADB_* in sys/net/pfkeyv2.h are still different
from RFC2407/IANA assignment because of binary compatibility
issue. It should be fixed under 5-CURRENT.
- ip6po_m member of struct ip6_pktopts is no longer used. But, it
is still there because of binary compatibility issue. It should
be removed under 5-CURRENT.
Reviewed by: itojun
Obtained from: KAME
MFC after: 3 weeks
pr_input() routines prototype is also changed to support IPSEC and IPV6
chained protocol headers.
Reviewed by: freebsd-arch, cvs-committers
Obtained from: KAME project
packet divert at kernel for IPv6/IPv4 translater daemon
This includes queue related patch submitted by jburkhol@home.com.
Submitted by: queue related patch from jburkhol@home.com
Reviewed by: freebsd-arch, cvs-committers
Obtained from: KAME project
for IPv6 yet)
With this patch, you can assigne IPv6 addr automatically, and can reply to
IPv6 ping.
Reviewed by: freebsd-arch, cvs-committers
Obtained from: KAME project
