and that can drive someone crazy. While m_get2() is young and not
documented yet, change its order of arguments to match m_getm2().
Sorry for churn, but better now than later.
processors, either on reboot or after power down with battery backup.
However, the AT91RM9200 RTC always resets on reboot making it just
about useless at the moment (if we support a low-power mode or an
extended sleep mode, it might become useful).
Submitted by: Ian Lepore
On single core devices set_stackptrs is only ever called with cpu = 0 in
initarm and will be identical to the existing function. On SMP this needs
to be implemented for sys/arm/mp_machdep.c, but the implementations are
identical for each SoC.
o Disable multi-block operations: they sometimes fail.
o Don't use the PROOF bits yet: they hang the system hard.
o Disable the the multi-block operations for !rm9200, but it
still doesn't help.
o Fix writing < 12 bytes errata to actually work.
o Enable, for the moment, reporting extra bytes soaked up.
restructuring of the driver. I've tried to preserve the other silicon
workarounds that we've added over the years, but haven't had a chance
to extensively test on other hardware. On my AT91RM9200 with 30MHz/1
wire/64 block transfers, I've been able to go from ~.66MB/s to
2.25MB/s in the simple tests I performed, almost a 3.5x improvement.
This cuts the boot time almost in half when everything else goes
right (timed from rtc message to login: prompt).
PR: 155214
Submitted by: Ian Lapore
explicltly enable that. The driver chose to use 60MHz / 2 (30MHz)
most of the time rather than 60MHz / 4 (15MHz) based on the Linux
driver of the time. This pushes the spec a little in order to not
suffer the penalty of running at 15MHz. However, when other bus
masters are active in the system, and the user tries 4-wire mode, the
internal bus arbitration would fail with data loss as a result.
# Comments from PR were reworked to reflect my historical perspective
PR: 155214 (partial)
Submitted by: Ian Lepore
Cummulative patch of changes that are not vendor-specific:
- ARMv6 and ARMv7 architecture support
- ARM SMP support
- VFP/Neon support
- ARM Generic Interrupt Controller driver
- Simplification of startup code for all platforms
FDT-enabled targets were broken after r238043 that relies
on device up the hierarchy to properly setup interrupt.
nexus device for ARM platforms did job only partially:
setting handler but not unmasking interrupt. Unmasking
was performed by platform code.
Reviewed by: andrew@
