introduced in amd64 revision 1.540 and i386 revision 1.547. However, it
had no harmful effects until after a recent change, r189698, on amd64.
(In other words, the error is harmless in RELENG_7.)
The error is triggered by the failure to allocate a pv entry for the one
and only mapping in a page table page. I am addressing the error by
changing pmap_copy() to abort if either pv entry allocation or page
table page allocation fails. This is appropriate because the creation of
mappings by pmap_copy() is optional. They are a (possible) optimization,
and not a requirement.
Correct a nearby whitespace error in the i386 pmap_copy().
Crash reported by: jeff@
MFC after: 6 weeks
to 2.4.0, as it has appeared in the 2.4.0-rc7 first time.
Being exported, AT_CLKTCK is returned by sysconf(_SC_CLK_TCK),
glibc falls back to the hard-coded CLK_TCK value when aux entry
is not present.
Glibc versions prior to 2.2.1 always use hard-coded CLK_TCK value.
For older applications/libc's which depends on hard-coded CLK_TCK
value user should set compat.linux.osrelease less than 2.4.0.
Approved by: kib (mentor)
The frequency of the statistics clock is given by stathz.
Use stathz if it is available, otherwise use hz.
Pointed out by: bde
Approved by: kib (mentor)
OSD-based jail extensions. This allows the Linux MIB to accessed via
jail_set and jail_get, and serves as a demonstration of adding jail support
to a module.
Reviewed by: dchagin, kib
Approved by: bz (mentor)
fix SMP topology detection. On i386, we extend it to cover Core, Core 2,
and Core i7 processors, not just Pentium 4 family, and move it to better
place. On amd64, all supported Intel CPUs should have this MSR.
and hide it inside of atrtc driver. Add new tunable hint.atrtc.0.clock
controlling it. Setting it to 0 disables using RTC clock as stat-/
profclock sources.
Teach i386 and amd64 SMP platforms to emulate stat-/profclocks using i8254
hardclock, when LAPIC and RTC clocks are disabled.
This allows to reduce global interrupt rate of idle system down to about
100 interrupts per core, permitting C3 and deeper C-states provide maximum
CPU power efficiency.
Restore previous behaviour for the case of unknown interrupt. Invocation
of IRQ -1 crashes my system on resume. Returning 0, as it was, is not
perfect also, but at least not so dangerous.
IRQ0 routing on LAPIC-enabled systems.
Add hint.apic.0.clock tunable. Setting it 0 disables using LAPIC timers
as hard-/stat-/profclock sources falling back to using i8254 and rtc timers.
On modern CPUs LAPIC is a part of CPU core which is shutting down when CPU
enters C3 or deeper power state. It makes no problems for interrupt
processing, as chipset wakes up CPU on interrupt triggering. But entering
C3 state kills LAPIC timer and freezes system time, making C3 and deeper
states practically unusable. Using i8254 timer allows to avoid this
problem.
By using i8254 timer my T7700 C2D CPU with UP kernel successfully enters
C3 state, saving more then a Watt of total idle power (>10%) in addition to
all other power-saving techniques.
This technique is not working for SMP yet, as only one CPU receives
timer interrupts. But I think that problem could be fixed by forwarding
interrupts to other CPUs with IPI.
Old implemention used Giant to protect the kernel data structures,
but at the same time called malloc(M_WAITOK), that could cause the
calling thread to sleep and lost Giant protection. User-visible
result was the missed wakeup.
New implementation uses one sx lock per futex. The sx protects
the futex structures and allows to sleep while copyin or copyout
are performed.
Unlike linux, we return EINVAL when FUTEX_CMP_REQUEUE operation
is requested and either caller specified futexes are equial or
second futex already exists. This is acceptable since the situation
can only occur from the application error, and glibc falls back to
old FUTEX_WAKE operation when FUTEX_CMP_REQUEUE returns an error.
Approved by: kib (mentor)
MFC after: 1 month
- Avoid possible divide-by-zero panic on SMP system when the CPUID is
disabled, unsupported, or buggy.
Submitted by: pluknet (pluknet at gmail dot com)[1]
topology of nehalem/corei7 based systems.
- Remove the cpu_cores/cpu_logical detection from identcpu.
- Describe the layout of the system in cpu_mp_announce().
Sponsored by: Nokia
used in some cases):
- Ignore DMA tag boundaries when allocating bounce pages. The boundaries
don't determine whether or not parts of a DMA request bounce. Instead,
they are just used to carve up segments.
- Allow tags with sub-page alignment to share bounce pages since bounce
pages are always page aligned.
Reviewed by: scottl (amd64)
MFC after: 1 month
logical CPUs in a package. We do this by numbering the non-boot CPUs
by starting with the first CPU whose APIC ID is after the boot CPU and
wrapping back around to APIC ID 0 if needed rather than always starting
at APIC ID 0. While here, adjust the cpu_mp_announce() routine to list
CPUs based on the mapping established by assign_cpu_ids() rather than
making assumptions about the algorithm assign_cpu_ids() uses.
MFC after: 1 month
a fair number of static data structures, making this an unlikely
option to try to change without also changing source code. [1]
Change default cache line size on ia64, sparc64, and sun4v to 128
bytes, as this was what rtld-elf was already using on those
platforms. [2]
Suggested by: bde [1], jhb [2]
MFC after: 2 weeks
CACHE_LINE_SIZE constant. These constants are intended to
over-estimate the cache line size, and be used at compile-time
when a run-time tuning alternative isn't appropriate or
available.
Defaults for all architectures are 64 bytes, except powerpc
where it is 128 bytes (used on G5 systems).
MFC after: 2 weeks
Discussed on: arch@
as well as providing stateful load balancing when used with RADIX_MPATH.
- Currently compiled in to i386 and amd64 but disabled by default, it can be enabled at
runtime with 'sysctl net.inet.flowtable.enable=1'.
- Embedded users can remove it entirely from the kernel by adding 'nooption FLOWTABLE' to
their kernel config files.
- A minimal hookup will be added to ip_output in a subsequent commit. I would like to see
more review before bringing in changes that require more churn.
Supported by: Bitgravity Inc.
a tag that has BUS_DMA_KEEP_PG_OFFSET set. Otherwise the page could be
reused with a non-zero offset by a tag that doesn't have
BUS_DMA_KEEP_PG_OFFSET leading to data corruption.
Sleuthing by: avg
Reviewed by: scottl
naming of the partitions (GEOM_PART_EBR_COMPAT). When
compatibility is enabled, changes to the partitioning are
disallowed.
Remove the device name aliasing added previously to provide
backward compatibility, but which in practice doesn't give
us anything.
Enable compatibility on amd64 and i386.
- Do not iterate int 15h, function e820h twice. Instead, we use STAILQ to
store each return buffer and copy all at once.
- Export optional extended attributes defined in ACPI 3.0 as separate
metadata. Currently, there are only two bits defined in the specification.
For example, if the descriptor has extended attributes and it is not
enabled, it has to be ignored by OS. We may implement it in the kernel
later if it is necessary and proven correct in reality.
- Check return buffer size strictly as suggested in ACPI 3.0.
Reviewed by: jhb
Remove a hack to generate more efficient code for port numbers below
0x100, which has been obsolete for at least ten years, because GCC has
an asm constraint to specify that.
Submitted by: Christoph Mallon <christoph mallon gmx de>
Most compilers nowadays (including GCC) are smart enough to know what's
going on and generate more efficient code anyway.
Submitted by: Christoph Mallon <christoph.mallon@gmx.de>
Because the "c" input constaint is used, the compiler will already place
the MSR_FSBASE/MSR_GSBASE constants in ecx. Using __asm("ecx") makes
LLVM crash. Even though this is also an LLVM bug, we'd better remove the
unnecessary GCCism as well.
Submitted by: Christoph Mallon <christoph.mallon@gmx.de>
1) Move the new field (brand_note) to the end of the Brandinfo structure.
2) Add a new flag BI_BRAND_NOTE that indicates that the brand_note pointer
is valid.
3) Use the brand_note field if the flag BI_BRAND_NOTE is set and as old
modules won't have the flag set, so the new field brand_note would be
ignored.
Suggested by: jhb
Reviewed by: jhb
Approved by: kib (mentor)
MFC after: 6 days
the kernel on amd64. Fill and read segment registers for mcontext and
signals. Handle traps caused by restoration of the
invalidated selectors.
Implement user-mode creation and manipulation of the process-specific
LDT descriptors for amd64, see sysarch(2).
Implement support for TSS i/o port access permission bitmap for amd64.
Context-switch LDT and TSS. Do not save and restore segment registers on
the context switch, that is handled by kernel enter/leave trampolines
now. Remove segment restore code from the signal trampolines for
freebsd/amd64, freebsd/ia32 and linux/i386 for the same reason.
Implement amd64-specific compat shims for sysarch.
Linuxolator (temporary ?) switched to use gsbase for thread_area pointer.
TODO:
Currently, gdb is not adapted to show segment registers from struct reg.
Also, no machine-depended ptrace command is added to set segment
registers for debugged process.
In collaboration with: pho
Discussed with: peter
Reviewed by: jhb
Linuxolator tested by: dchagin
Reorder amd64 gdt descriptors so that user-accessible selectors are the
same as on i386. At least Wine hard-codes this into the binary.
In collaboration with: pho
Reviewed by: jhb
Provides i386/freebsd API-compatible definitions for the argument
structures of the above sysarch commands. struct i386_ioperm_args
definition is ABI-compatible.
In collaboration with: pho
Reviewed by: jhb
To keep these structures ABI-compatible, half the size of r_trapno,
r_err, mc_trapno, mc_flags.
Add fsbase and gsbase to mcontext on both amd64 and i386.
Add flags to amd64 mcontext to indicate that it contains valid segments
or bases.
In collaboration with: pho
Discussed with: peter
Reviewed by: jhb
as 'real memory' instead of Maxmem if the value is available.
Note amd64 displayed physmem as 'usable memory' since machdep.c r1.640
to unconfuse users. Now it is consistent across amd64 and i386 again.
While I am here, clean up smbios.c a bit and update copyright date.
Reviewed by: jhb
typedef l_long l_off_t;
Change l_mmap_argv's to l_ulong for pgoff. This restores prior behaviour
to consumers of l_off_t but allows mmap to mmap a 32bit position which a
Linux application requires to access SMBIOS data via /dev/mem.
Reviewed by: dchagin
Prompted by: rdivacky
