this is now done on all machines except for some known problematic ones.
Add an additional guard to make sure that the interrupt numbers are
in the correct range before swizzling. This should catch any remaining
models for which the swizzle is inappropriate.
Correct the swizzle calculation to account for the fact that the parent
interrupt numbers to be swizzled are 1-based.
Approved by: re
1. At least some Netra t1 models have PCI buses with no associated
interrupt map, but obviously expect the PCI swizzle to be done with
the interrupt number from the higher level as intpin. In this case,
the mapping also needs to continue at parent bus nodes.
To handle that, add a quirk table based on the "name" property of
the root node to avoid breaking other boxen. This property is now
retrieved and printed at boot.
2. On SPARCengine Ultra AX machines, interrupt numbers are not mapped
at all, and full interrupt numbers (not just INOs) are given in
the interrupt properties. This is more or less cosmetical; the
PCI interrupt numbers would be wrong, but the psycho resource
allocation method would pass the right numbers on anyway.
Tested by: mux (1), Maxim Mazurok <maxim@km.ua> (2)
code. Both tasks are not always performed completely by the firmware.
The former is required to get some e450 models to boot; the latter fixes
the repeated fifo underruns with hme(4)s and gem(4)s observed on some
machines (and probably performance problems with other peripherals as
well).
the bus-dependent code and to be able to support more systems. The core
of the new code is mostly obtained from NetBSD.
Kluge the interrupt routing methods of the psycho and apb drivers so
that an intline of 0 can be handled for now; real routing is still not
possible (all intline registers are preinitialized instead); this will
require a sparc64-specific adaption of the driver for generic PCI-PCI
bridges with a custom routing method to work right.
