TCP/IPv6 packets to be forwarded can be laid out with only the Ethernet
header in the first mbuf, and these packets are lost. There was a
previous hack to pullup ICMPv6 packets with such a layout for the
same reason. Generalize, and pullup any IPv6 packets with only the
Ethernet header in the first mbuf. Possibly this should also include
IPv4, but that situation has not been observed to fail.
PR: 254060
Reported by: denis at h3q.com
MFC after: 3 days
Later dtb from the RPI Foundation removed the brcm,genet-v5 compatible
for some unknown reason, add brcm,bcm2711-genet-v5 to the list of compatible
device for if_genet
This chip is used in the Rasperry Pi 4, and is supported by the if_genet
driver. Currently we use the ukphy mii driver, this patch switches over
to the brgphy mii driver instead. To support the rgmii-rxid phy mode,
which is now the default in the Linux dtb, we add support for clock
skewing.
These changes are taken from OpenBSD and NetBSD, except for the bailout
in brgphy_bcm54xx_clock_delay() in rgmii mode, which was found necessary
after testing.
Submitted by: Robert Crowston, crowston at protomail.com
Differential Revision: https://reviews.freebsd.org/D25251
The ICMPv6 echo reply is constructed with the IPv6 header too close to
the beginning of a packet for an Ethernet header to be prepended, so we
end up with an mbuf containing just the Ethernet header. The GENET
controller doesn't seem to handle this, with or without transmit checksum
offload. At least until we have chip documentation, do a pullup to
satisfy the chip. Hopefully this can be fixed properly in the future.
Fix problem with ICMP echo replies: check only deferred data checksum
flags, and not the received checksum status bits, when checking whether
a packet has a deferred checksum; otherwise echo replies are corrupted
because the received checksum status bits are still present.
Fix some unhandled cases in packet shuffling for checksum offload.
Add driver for Broadcom "GENET" version 5, as found in BCM-2711 on
Raspberry Pi 4B. The driver is derived in part from the bcmgenet.c
driver in NetBSD, along with bcmgenetreg.h.
Reviewed by: manu
Obtained from: in part from NetBSD
Relnotes: yes, note addition
Differential Revision: https://reviews.freebsd.org/D24436
- Rename SOC_BCM2837 to SOC_BRCM_BCM2837, put it to opt_soc.h
- do not use files.XXX files, just move required sources to
conf/files.arm64 and make them depend on soc_brcm_bcm2837
Suggested by: andrew
RPI3 kernel config builds kernel compatible with latest upstream device
tree and firmware: https://github.com/raspberrypi/firmware/tree/master/boot
As of today it's 597c662a613df1144a6bc43e5f4505d83bd748ca
Default console is PL01x, so pi3-disable-bt dt overlay should be configured
in config.txt and stock U-Boot should be patched to use proper serial port.
Yet unsupported: SMP, VCHIQ, RNG driver. RNG requires some work due to
upstream device tree incompatibility.
Multiple people contributed to this work over time: db@, loos@, manu@
