The submitter notes that the bcm2835_cpufreq driver really just needs the
rpi4 compat string added to it; powerd subsequently works and the dev.cpu.0
sysctl values look sane and can be successfully manipulated.
Submitted by: James Mintram <me@jamesrm.com>
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D25349
r357614 added CTLFLAG_NEEDGIANT to make it easier to find nodes that are
still not MPSAFE (or already are but aren’t properly marked).
Use it in preparation for a general review of all nodes.
This is non-functional change that adds annotations to SYSCTL_NODE and
SYSCTL_PROC nodes using one of the soon-to-be-required flags.
Mark all obvious cases as MPSAFE. All entries that haven't been marked
as MPSAFE before are by default marked as NEEDGIANT
Approved by: kib (mentor, blanket)
Commented by: kib, gallatin, melifaro
Differential Revision: https://reviews.freebsd.org/D23718
Since r324184 the root node compatible for the original Raspberry Pi
is "brcm,bcm2835", add it to the compatible list of bcm2835_cpufreq.
Tested On: RPi1 Model B
Note that the default Das U-Boot FDT does not include a cpus clause
so actually adding a bcm2835_cpufreq device requires adding a FDT
overlay defining the cpu.
Approved by: grog, jhb (mentors)
MFC after: 3 days
This reduces noise when kernel is compiled by newer GCC versions,
such as one used by external toolchain ports.
Reviewed by: kib, andrew(sys/arm and sys/arm64), emaste(partial), erj(partial)
Reviewed by: jhb (sys/dev/pci/* sys/kern/vfs_aio.c and sys/kern/kern_synch.c)
Differential Revision: https://reviews.freebsd.org/D10385
Since r324184 the root node compatible for rpi2 is "brcm,bcm2836", add
it to the compatible list of bcm2835_cpufreq.
Tested On: RPI2 v1.1 RPI2 v1.2
Reported by: many on freebsd-arm@
RPi3 cpufreq is more like that on RPi2. Setting arm frequency
above min (say, "sysctl hw.cpufreq.arm_freq=600000001") turns on
turbo mode, and the firmware automatically raises voltage, sets
frequency to max 1200MHz, and throttle when overheat, etc.
Swap if/else parts and use SOC_BCM2835 def so RPi3 can share the
same cpufreq logic as RPi2, instead of falling to that for RPi.
Submitted by: Jia-Shiun Li <jiashiun@gmail.com>
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D9640
After r285994, sysctl(8) was fixed to use 273.15 instead of 273.20 as 0C
reference and as result, the temperature read in sysctl(8) now exibits a
+0.1C difference.
This commit fix the kernel references to match the reference value used in
sysctl(8) after r285994.
Sponsored by: Rubicon Communications (Netgate)