ocs_scsi_recv_cmd() receives the flags after ocs_get_flags_fcp_cmd(),
which translates them from FCP_TASK_ATTR_* to OCS_SCSI_CMD_*. As result
non-SIMPLE requests turned into HEAD or ORDERED depending on direction.
MFC after: 2 weeks
We don't support building the kernel from such old compilers, nor with
the Intel Compiler specifically. Remove support for this old construct
that was copied from stdbool.h and not relevant here.
Make the Ethernet PCP codepoint configurable
for L2 local traffic, to allow lower latency for
iSCSI block IO. This addresses the initiator
side only.
Reviewed by: mav, trasz, bcr
Sponsored by: NetApp, Inc.
Differential Revision: https://reviews.freebsd.org/D26739
o Add iommu_unmap_msi() to release the msi GAS entry.
o Provide default implementations for iommu init/deinit methods.
Reviewed by: kib
Sponsored by: Innovate DSbD
Differential Revision: https://reviews.freebsd.org/D26906
Remove code that supported pre-2011 kernels. CTLTYPE_S64 was defined
in rev 217616. All supported branches have it, so remove its compat
definition as OBE.
platforms.
This allows to not depend on the IOMMU macro in AHCI driver.
Requested by: kib
Suggested by: andrew
Reviewed by: kib
Sponsored by: Innovate DSbD
Differential Revision: https://reviews.freebsd.org/D26887
PCIe allows for MSI-X BAR to be either dedicated, or MSI-X Table may
be co-located in some functional BAR. In the later case xhci(4) is
unable to allocate active resource for the table because BAR is
already activated.
Handle it by checking for this special case, and not try to alloc
resource if MSI-X BAR is IO.
Reported and tested by: emaste
Reviewed by: emaste, hselasky
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D26913
The NTB hardware starting with Skylake has some changes to the register
map and the doorbell interface. Add a new NTB_XEON_GEN3 device type and
use it to conditionalize driver logic that differs from the existing
Xeon code.
Reviewed by: vangyzen
Discussed with: cem, Bret Ketchum <Bret.Ketchum@dell.com>
MFC after: 1 month
Sponsored by: NetApp, Inc.
Sponsored by: Klara, Inc.
Differential Revision: https://reviews.freebsd.org/D26683
- Get the number of classes from chip_params.
- Get the number of ethofld tids from the firmware.
- Do not let tcp_ratelimit allocate all traffic classes.
Sponsored by: Chelsio Communications
In certain edge cases, the NIC might have only received a partial TLS
record which it needs to return to the driver. For example, if the
local socket was closed while data was still in flight, a partial TLS
record might be pending when the connection is closed. Receiving a
RST in the middle of a TLS record is another example. When this
happens, the firmware returns the the partial TLS record as plain TCP
data via CPL_RX_DATA. Handle these requests by returning an error to
OpenSSL (via so_error for KTLS or via an error TLS record header for
the older Chelsio OpenSSL interface).
Reported by: Sony Arpita Das @ Chelsio
Reviewed by: np
MFC after: 2 weeks
Sponsored by: Chelsio Communications
Differential Revision: Revision: https://reviews.freebsd.org/D26800
It does not change anything immediately, but allows further support of
Command Priority, Status Qualifier and new task management functions.
MFC after: 1 month
Sponsored by: iXsystems, Inc.
The firmware can allocate ingress and egress context ids anywhere from
its configured range. Size the iq/eq maps to match the entire range
instead of assuming that the firmware always allocates the first
available context id.
Reported by: Baptiste Wicht @ Verisign
MFC after: 1 week
Sponsored by: Chelsio Communications
ubuf buffer is too small. It should be 18 if a NULL is not needed,
or 19 to hold the NULL terminator for the full 64-BIT value plus
the 0x prefix.
Submitted by: bret_ketchum@dell.com
Reviewed by: markj mav
MFC after: 2 weeks
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D26893
Instead, add arguments to vmapbuf. Since this argument is
always a pointer use a type of void * and cast to vm_offset_t in
vmapbuf. (In CheriBSD we've altered vm_fault_quick_hold_pages to
take a pointer and check its bounds.)
In no other situtation does b_data contain a user pointer and vmapbuf
replaces b_data with the actual mapping.
Suggested by: jhb
Reviewed by: imp, jhb
Obtained from: CheriBSD
MFC after: 1 week
Sponsored by: DARPA
Differential Revision: https://reviews.freebsd.org/D26784
This uses the .incbin directive to pull in the MFS image contents.
Using assembly directly ensures that symbols can be defined with the
name and properties (such as .size) desired without having to rename
symbols, etc. via a second objcopy invocation. Since it is compiled
by the C compiler driver, it also avoids the need for all of the
EMBEDFS* make variables.
Suggested by: jrtc27
Reviewed by: kib, markj
Obtained from: CheriBSD
MFC after: 2 weeks
Sponsored by: DARPA
Differential Revision: https://reviews.freebsd.org/D26781
Some controllers use PCI function 1 as the requester ID for DMA transfers,
but the controllers are not PCI multifunction.
Set the iommu buswide flag for them. This should instruct an IOMMU driver
to use the same translation rule for all the devices and functions of
a bus.
This was discovered on the ARM Neoverse N1 System Development Platform
(ARM N1SDP).
Bug reference: https://bugzilla.kernel.org/show_bug.cgi?id=42679
Reported by: andrew
Reviewed by: kib, mav
Sponsored by: Innovate DSbD
Differential Revision: https://reviews.freebsd.org/D26857
Flow control was disabled during initial TOE TLS development to
workaround a hang (and to match the Linux TOE TLS support for T6).
The rest of the TOE TLS code maintained credits as if flow control was
enabled which was inherited from before the workaround was added with
the exception that the receive window was allowed to go negative.
This negative receive window handling (rcv_over) was because I hadn't
realized the full implications of disabling flow control.
To clean this up, re-enable flow control on TOE TLS sockets. The
existing TPF_FORCE_CREDITS workaround is sufficient for the original
hang. Now that flow control is enabled, remove the rcv_over
workaround and instead assert that the receive window never goes
negative matching plain TCP TOE sockets.
Reviewed by: np
MFC after: 2 weeks
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D26799
This allows the interrupt controller driver only need a small change to
create a map for the page the device will write to raise an interrupt.
Submitted by: andrew
Reviewed by: kib
Sponsored by: Innovate DSbD
Differential Revision: https://reviews.freebsd.org/D26705
another thread has started to send in a CCB and already checked
the queue wasn't frozen, we would end up with iscsi_action()
being called despite the queue is now frozen.
Add a check to make sure this doesn't happen . Perhaps this should
be fixed at the CAM level instead, but given how the send queue and
SIM are governed by two separate mutexes, it is somewhat hard to do.
Reviewed by: imp, mav
MFC after: 2 weeks
Sponsored by: NetApp, Inc.
Sponsored by: Klara, Inc.
Differential Revision: https://reviews.freebsd.org/D26750
Add support for ARC-1886, NVMe/SAS/SATA controller.
Many thanks to Areca for continuing to support FreeBSD.
Submitted by: 黃清隆 <ching2048 areca com tw>
MFC after: 2 weeks
It is reported to fix kernel panics when early unsolicited responses
delivered to the CODEC device not having driver attached yet.
PR: 250248
Reported by: Rajeev Pillai <rajeev_v_pillai@yahoo.com>
Reviewed by: avg
MFC after: 2 weeks
motherboard temperatures. In particular, the U4 northbridge die is very
hard to cool or heat effectively with fans and is not responsive to load.
It generally sits around 64C, where it seems happy, so (like Linux) just
declare that to be its target temperature.
This makes the PowerMac G5 much less loud, with no change in the
temperatures of any system components.
MFC after: 2 weeks
The try lock loop in HN_LOCK put the thread spinning on cpu if the lock
is not available. It is possible to cause deadlock if the thread holding
the lock is sleeping. Relinquish the cpu to work around this problem even
it doesn't completely solve the issue. The priority inversion could cause
the livelock no matter how less likely it could happen. A more complete
solution may be needed in the future.
Reported by: Microsoft, Netapp
MFC after: 2 weeks
Sponsored by: Microsoft
It is possible that the vmbus pcib channel is revoked during attach path.
The attach path could be waiting for response from host and this response will never
arrive since the channel has already been revoked from host point of view. Check
this situation during wait complete and return failed if this happens.
Reported by: Netapp
MFC after: 2 weeks
Sponsored by: Microsoft
Differential Revision: https://reviews.freebsd.org/D26486
This field was not in specs when the driver was written, but now there
are SSDs with the reported latency of 10s, where hardcoded value of 5s
seems to be not enough sometimes, causing shutdown timeout messages.
MFC after: 1 week
Sponsored by: iXsystems, Inc.
hints work on per-channel basis as documented, rather than chip-wide. Also,
when configured via hints, return BUS_PROBE_NOWILDCARD on successful hints
match, so that the hints don't bogusly match other types of i2c chips.
This patch has the driver for 10Gigabit Ethernet controller in AMD
SoC. This driver is written compatible to the Iflib framework. The
existing driver is for the old version of hardware. The submitted
driver here is for the recent versions of the hardware where the Ethernet
controller is PCI-E based.
Submitted by: Rajesh Kumar <rajesh1.kumar@amd.com>
MFC after: 1 month
Relnotes: yes
Differential Revision: https://reviews.freebsd.org/D25793
Push the root seed version to userspace through the VDSO page, if
the RANDOM_FENESTRASX algorithm is enabled. Otherwise, there is no
functional change. The mechanism can be disabled with
debug.fxrng_vdso_enable=0.
arc4random(3) obtains a pointer to the root seed version published by
the kernel in the shared page at allocation time. Like arc4random(9),
it maintains its own per-process copy of the seed version corresponding
to the root seed version at the time it last rekeyed. On read requests,
the process seed version is compared with the version published in the
shared page; if they do not match, arc4random(3) reseeds from the
kernel before providing generated output.
This change does not implement the FenestrasX concept of PCPU userspace
generators seeded from a per-process base generator. That change is
left for future discussion/work.
Reviewed by: kib (previous version)
Approved by: csprng (me -- only touching FXRNG here)
Differential Revision: https://reviews.freebsd.org/D22839
There is no functional change for the existing Fortuna random(4)
implementation, which remains the default in GENERIC.
In the FenestrasX model, when the root CSPRNG is reseeded from pools due to
an (infrequent) timer, child CSPRNGs can cheaply detect this condition and
reseed. To do so, they just need to track an additional 64-bit value in the
associated state, and compare it against the root seed version (generation)
on random reads.
This revision integrates arc4random(9) into that model without substantially
changing the design or implementation of arc4random(9). The motivation is
that arc4random(9) is immediately reseeded when the backing random(4)
implementation has additional entropy. This is arguably most important
during boot, when fenestrasX is reseeding at 1, 3, 9, 27, etc., second
intervals. Today, arc4random(9) has a hardcoded 300 second reseed window.
Without this mechanism, if arc4random(9) gets weak entropy during initial
seed (and arc4random(9) is used early in boot, so this is quite possible),
it may continue to emit poorly seeded output for 5 minutes. The FenestrasX
push-reseed scheme corrects consumers, like arc4random(9), as soon as
possible.
Reviewed by: markm
Approved by: csprng (markm)
Differential Revision: https://reviews.freebsd.org/D22838
