Hewlett Packard 58503A GPS Receiver
Synopsis
Address: 127.127.26.u
Reference ID: GPS
Driver ID: GPS_HP
Serial Port: /dev/hpgpsu; 9600 baud, 8-bits, no parity
Description
This driver supports the HP 58503A Time and Frequency Reference Receiver.
It uses HP SmartClock (TM) to implement an Enhanced GPS receiver. The receiver
accuracy when locked to GPS in normal operation is better than 1 usec.
The accuracy when operating in holdover is typically better than 10 us
per day. It receiver should be operated with factory default settings.
Initial driver operation: expects the receiver to be already locked to
GPS, configured and able to output timecode format 2 messages.
The driver uses the poll sequence :PTIME:TCODE? to get a response
from the receiver. The receiver responds with a timecode string of ASCII
printing characters, followed by a <cr><lf>, followed by a prompt
string issued by the receiver, in the following format:
T#yyyymmddhhmmssMFLRVcc<cr><lf>
The driver processes the response at the <cr> and <lf><cr> and
<lf>, so what the driver sees is the prompt from the previous poll,
followed by this timecode. The prompt from the current poll is (usually)
left unread until the next poll. So (except on the very first poll) the
driver sees this:
T#yyyymmddhhmmssMFLRVcc<cr><lf>
The T is the on-time character, at 980 msec. before the next 1PPS edge.
The # is the timecode format type. We look for format 2. Without any of
the CLK or PPS stuff, then, the receiver buffer timestamp at the <cr>y
is 24 characters later, which is about 25 msec. at 9600 bps, so the first
approximation for fudge time1 is nominally -0.955 seconds. This number
probably needs adjusting for each machine / OS type, so far: -0.955000
on an HP 9000 Model 712/80 HP-UX 9.05 -0.953175 on an HP 9000 Model 370
HP-UX 9.10
Fudge Factors
-
time1 time
-
Specifies the time offset calibration factor, in seconds and fraction,
with default 0.0.
-
time2 time
-
Not used by this driver.
-
stratum number
-
Specifies the driver stratum, in decimal from 0 to 15, with default 0.
-
refid string
-
Specifies the driver reference identifier, an ASCII string from one to
four characters, with default GPS.
-
flag1 0 | 1
-
Not used by this driver.
-
flag2 0 | 1
-
Not used by this driver.
-
flag3 0 | 1
-
Not used by this driver.
-
flag4 0 | 1
-
Not used by this driver.
David L. Mills (mills@udel.edu)