freebsd-dev/sys/mips/conf/AR91XX_BASE.hints
Adrian Chadd 3f9bdcef12 * Add in the gpio/gpioled drivers into AR91XX_BASE.
* Add in a default GPIO section for AR91XX_BASE.hints, which doesn't
  define the GPIO function masks or any GPIO pines.
* Add in the GPIO line definitions for LEDs and GPIO pins for the
  TP-WR1043nd.

I've verified the LEDs work fine using gpioset.
2011-12-15 01:05:38 +00:00

60 lines
1.5 KiB
Plaintext

# This file (and the kernel config file accompanying it) are not designed
# to be used by themselves. Instead, users of this file should create a
# kernel # config file which includes this file (which gets the basic hints),
# then override the default options (adding devices as needed) and adding
# hints as needed (for example, the GPIO and LAN PHY.)
# $FreeBSD$
hint.apb.0.at="nexus0"
hint.apb.0.irq=4
# uart0
hint.uart.0.at="apb0"
# see atheros/uart_cpu_ar71xx.c why +3
hint.uart.0.maddr=0x18020003
hint.uart.0.msize=0x18
hint.uart.0.irq=3
#ehci - note the 0x100 offset for the AR913x/AR724x
hint.ehci.0.at="nexus0"
hint.ehci.0.maddr=0x1b000100
hint.ehci.0.msize=0x00ffff00
hint.ehci.0.irq=1
hint.arge.0.at="nexus0"
hint.arge.0.maddr=0x19000000
hint.arge.0.msize=0x1000
hint.arge.0.irq=2
hint.arge.1.at="nexus0"
hint.arge.1.maddr=0x1a000000
hint.arge.1.msize=0x1000
hint.arge.1.irq=3
# XXX The ath device hangs off of the AHB, rather than the Nexus.
hint.ath.0.at="nexus0"
hint.ath.0.maddr=0x180c0000
hint.ath.0.msize=0x30000
hint.ath.0.irq=0
# Set this to define where the ath calibration data
# should be fetched from in physical memory.
# hint.ath.0.eepromaddr=0x1fff1000
# SPI flash
hint.spi.0.at="nexus0"
hint.spi.0.maddr=0x1f000000
hint.spi.0.msize=0x10
hint.mx25l.0.at="spibus0"
hint.mx25l.0.cs=0
# Watchdog
hint.ar71xx_wdog.0.at="nexus0"
# The GPIO function and pin mask is configured per-board
hint.gpio.0.at="apb0"
hint.gpio.0.maddr=0x18040000
hint.gpio.0.msize=0x1000
hint.gpio.0.irq=2