freebsd-dev/sys/mips/conf/DIR-655A1
Adrian Chadd 75fa40f89c Add initial D-Link DIR-655 (A1) support.
This is based on the AP135 design - QCA9558 SoC, 3x3 2GHz wifi, but no
5GHz (11n or 11ac) chip is available.

It however still has 128MiB of RAM, 16MiB of NOR flash and the AR8327N
gigabit switch - so it's quite a beefy router device.

Tested:

* Well, a unit, naturally

Obtained from:	Completely messing up an amazon.com order and getting this instead, and asking "hey, wonder if I could.."
2015-03-22 02:15:09 +00:00

57 lines
1.3 KiB
Plaintext

#
# DIR-655A1 - 3x3 2GHz D-Link AP
#
# This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi,
# 128MiB RAM, an AR8327 5-port gigabit ethernet switch.
#
# $FreeBSD$
#
# Include the default QCA955x parameters
include "QCA955X_BASE"
ident DIR-655A1
# Override hints with board values
hints "DIR-655A1.hints"
# Force the board memory - the base AP135 has 128MB RAM
options AR71XX_REALMEM=(128*1024*1024)
# i2c GPIO bus
#device gpioiic
#device iicbb
#device iicbus
#device iic
# Options required for miiproxy and mdiobus
options ARGE_MDIO # Export an MDIO bus separate from arge
device miiproxy # MDIO bus <-> MII PHY rendezvous
device etherswitch
device arswitch
# read MSDOS formatted disks - USB
#options MSDOSFS
# Enable the uboot environment stuff rather then the
# redboot stuff.
options AR71XX_ENV_UBOOT
# uzip - to boot natively from flash
device geom_uncompress
options GEOM_UNCOMPRESS
# Used for the static uboot partition map
device geom_map
options AR71XX_ATH_EEPROM
device firmware # Used by the above
options ATH_EEPROM_FIRMWARE
# Boot off of the rootfs, as defined in the geom_map setup.
options ROOTDEVNAME=\"ufs:map/rootfs.uncompress\"
# Default to accept
options IPFIREWALL_DEFAULT_TO_ACCEPT