freebsd-dev/usr.sbin/bluetooth/ath3kfw/ath3k_hw.c
Adrian Chadd aebdb1e24e [ath3k] add a replacement ath3k firmware loading tool.
This is influenced by the ath3k driver from linux (circa 2013, this is
how long I've been sitting on this.)

It handles loading in firmware using the newer model, where it assembles
the right set of firmware blobs and board configuration based on the
device list and querying the device.

The older utility could only load in a single image - which sometimes
was ath3k-1.fw and sometimes was ath3k-2.fw.  However, the ath3k maintainers
didn't want to keep adding in binaries that were just derivatives with a
separate board config, so they deleted ath3k-2.fw from the Linux firmware
repository and instead, well, did this.

Now, this has been tested against AR3011 and AR3012 NICs from the AR9285+BT
combo up through to the QCA9565+BT combo.  It doesn't yet work with the
QCAFN222 NIC as that is some newer chip.

The firmware can be grabbed from https://github.com/erikarn/ath3kfw/ in
the share/firmware/ath3k directory.  I'll update this utility over time
to support the newer firmware drops (newer than mid-2013) which should
pull in the QCNFA222 and subsequent chips.

Tested:

* AR9285 + BT
* AR9287 + BT
* AR9485 + BT
* AR9462 + BT
* QCA9565 + BT
2016-06-07 04:22:18 +00:00

359 lines
7.7 KiB
C

/*-
* Copyright (c) 2013 Adrian Chadd <adrian@freebsd.org>
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer,
* without modification.
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
* similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
* redistribution must be conditioned upon including a substantially
* similar Disclaimer requirement for further binary redistribution.
*
* NO WARRANTY
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
* AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
* THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
* OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
* IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
* THE POSSIBILITY OF SUCH DAMAGES.
*
* $FreeBSD$
*/
#include <stdio.h>
#include <stdlib.h>
#include <unistd.h>
#include <errno.h>
#include <string.h>
#include <err.h>
#include <fcntl.h>
#include <sys/endian.h>
#include <sys/types.h>
#include <sys/stat.h>
#include <libusb.h>
#include "ath3k_fw.h"
#include "ath3k_hw.h"
#include "ath3k_dbg.h"
#define XMIN(x, y) ((x) < (y) ? (x) : (y))
int
ath3k_load_fwfile(struct libusb_device_handle *hdl,
const struct ath3k_firmware *fw)
{
int size, count, sent = 0;
int ret, r;
count = fw->len;
size = XMIN(count, FW_HDR_SIZE);
ath3k_debug("%s: file=%s, size=%d\n",
__func__, fw->fwname, count);
/*
* Flip the device over to configuration mode.
*/
ret = libusb_control_transfer(hdl,
LIBUSB_REQUEST_TYPE_VENDOR | LIBUSB_ENDPOINT_OUT,
ATH3K_DNLOAD,
0,
0,
fw->buf + sent,
size,
1000); /* XXX timeout */
if (ret != size) {
fprintf(stderr, "Can't switch to config mode; ret=%d\n",
ret);
return (-1);
}
sent += size;
count -= size;
/* Load in the rest of the data */
while (count) {
size = XMIN(count, BULK_SIZE);
ath3k_debug("%s: transferring %d bytes, offset %d\n",
__func__,
sent,
size);
ret = libusb_bulk_transfer(hdl,
0x2,
fw->buf + sent,
size,
&r,
1000);
if (ret < 0 || r != size) {
fprintf(stderr, "Can't load firmware: err=%s, size=%d\n",
libusb_strerror(ret),
size);
return (-1);
}
sent += size;
count -= size;
}
return (0);
}
int
ath3k_get_state(struct libusb_device_handle *hdl, unsigned char *state)
{
int ret;
ret = libusb_control_transfer(hdl,
LIBUSB_REQUEST_TYPE_VENDOR | LIBUSB_ENDPOINT_IN,
ATH3K_GETSTATE,
0,
0,
state,
1,
1000); /* XXX timeout */
if (ret < 0) {
fprintf(stderr,
"%s: libusb_control_transfer() failed: code=%d\n",
__func__,
ret);
return (0);
}
return (ret == 1);
}
int
ath3k_get_version(struct libusb_device_handle *hdl,
struct ath3k_version *version)
{
int ret;
ret = libusb_control_transfer(hdl,
LIBUSB_REQUEST_TYPE_VENDOR | LIBUSB_ENDPOINT_IN,
ATH3K_GETVERSION,
0,
0,
(unsigned char *) version,
sizeof(struct ath3k_version),
1000); /* XXX timeout */
if (ret < 0) {
fprintf(stderr,
"%s: libusb_control_transfer() failed: code=%d\n",
__func__,
ret);
return (0);
}
/* XXX endian fix! */
return (ret == sizeof(struct ath3k_version));
}
int
ath3k_load_patch(libusb_device_handle *hdl, const char *fw_path)
{
int ret;
unsigned char fw_state;
struct ath3k_version fw_ver, pt_ver;
char fwname[FILENAME_MAX];
struct ath3k_firmware fw;
uint32_t tmp;
ret = ath3k_get_state(hdl, &fw_state);
if (ret < 0) {
ath3k_err("%s: Can't get state\n", __func__);
return (ret);
}
if (fw_state & ATH3K_PATCH_UPDATE) {
ath3k_info("%s: Patch already downloaded\n",
__func__);
return (0);
}
ret = ath3k_get_version(hdl, &fw_ver);
if (ret < 0) {
ath3k_debug("%s: Can't get version\n", __func__);
return (ret);
}
/* XXX path info? */
snprintf(fwname, FILENAME_MAX, "%s/ar3k/AthrBT_0x%08x.dfu",
fw_path,
fw_ver.rom_version);
/* Read in the firmware */
if (ath3k_fw_read(&fw, fwname) <= 0) {
ath3k_debug("%s: ath3k_fw_read() failed\n",
__func__);
return (-1);
}
/*
* Extract the ROM/build version from the patch file.
*/
memcpy(&tmp, fw.buf + fw.len - 8, sizeof(tmp));
pt_ver.rom_version = le32toh(tmp);
memcpy(&tmp, fw.buf + fw.len - 4, sizeof(tmp));
pt_ver.build_version = le32toh(tmp);
ath3k_info("%s: file %s: rom_ver=%d, build_ver=%d\n",
__func__,
fwname,
(int) pt_ver.rom_version,
(int) pt_ver.build_version);
/* Check the ROM/build version against the firmware */
if ((pt_ver.rom_version != fw_ver.rom_version) ||
(pt_ver.build_version <= fw_ver.build_version)) {
ath3k_debug("Patch file version mismatch!\n");
ath3k_fw_free(&fw);
return (-1);
}
/* Load in the firmware */
ret = ath3k_load_fwfile(hdl, &fw);
/* free it */
ath3k_fw_free(&fw);
return (ret);
}
int
ath3k_load_syscfg(libusb_device_handle *hdl, const char *fw_path)
{
unsigned char fw_state;
char filename[FILENAME_MAX];
struct ath3k_firmware fw;
struct ath3k_version fw_ver;
int clk_value, ret;
ret = ath3k_get_state(hdl, &fw_state);
if (ret < 0) {
ath3k_err("Can't get state to change to load configuration err");
return (-EBUSY);
}
ret = ath3k_get_version(hdl, &fw_ver);
if (ret < 0) {
ath3k_err("Can't get version to change to load ram patch err");
return (ret);
}
switch (fw_ver.ref_clock) {
case ATH3K_XTAL_FREQ_26M:
clk_value = 26;
break;
case ATH3K_XTAL_FREQ_40M:
clk_value = 40;
break;
case ATH3K_XTAL_FREQ_19P2:
clk_value = 19;
break;
default:
clk_value = 0;
break;
}
snprintf(filename, FILENAME_MAX, "%s/ar3k/ramps_0x%08x_%d%s",
fw_path,
fw_ver.rom_version,
clk_value,
".dfu");
ath3k_info("%s: syscfg file = %s\n",
__func__,
filename);
/* Read in the firmware */
if (ath3k_fw_read(&fw, filename) <= 0) {
ath3k_err("%s: ath3k_fw_read() failed\n",
__func__);
return (-1);
}
ret = ath3k_load_fwfile(hdl, &fw);
ath3k_fw_free(&fw);
return (ret);
}
int
ath3k_set_normal_mode(libusb_device_handle *hdl)
{
int ret;
unsigned char fw_state;
ret = ath3k_get_state(hdl, &fw_state);
if (ret < 0) {
ath3k_err("%s: can't get state\n", __func__);
return (ret);
}
/*
* This isn't a fatal error - the device may have detached
* already.
*/
if ((fw_state & ATH3K_MODE_MASK) == ATH3K_NORMAL_MODE) {
ath3k_debug("%s: firmware is already in normal mode\n",
__func__);
return (0);
}
ret = libusb_control_transfer(hdl,
LIBUSB_REQUEST_TYPE_VENDOR, /* XXX out direction? */
ATH3K_SET_NORMAL_MODE,
0,
0,
NULL,
0,
1000); /* XXX timeout */
if (ret < 0) {
ath3k_err("%s: libusb_control_transfer() failed: code=%d\n",
__func__,
ret);
return (0);
}
return (ret == 0);
}
int
ath3k_switch_pid(libusb_device_handle *hdl)
{
int ret;
ret = libusb_control_transfer(hdl,
LIBUSB_REQUEST_TYPE_VENDOR, /* XXX set an out flag? */
USB_REG_SWITCH_VID_PID,
0,
0,
NULL,
0,
1000); /* XXX timeout */
if (ret < 0) {
ath3k_debug("%s: libusb_control_transfer() failed: code=%d\n",
__func__,
ret);
return (0);
}
return (ret == 0);
}