freebsd-dev/sys/mips/conf/AP91
Warner Losh d4f95c889d In kernel config files, it is supposed to be 'options<space><tab>' not
'options<tab><tab>', per long standing (but recently not so strictly
enforced) convention.
2014-03-18 14:41:18 +00:00

65 lines
1.5 KiB
Plaintext

#
# Specific board setup for the Atheros AP91 reference board.
#
# The AP91 has the following hardware:
#
# + AR7241 CPU SoC
# + AR9287 Wifi
# + Integrated switch (XXX speed?)
# + 4MB flash
# + 16MB RAM
# + uboot environment
# $FreeBSD$
include "AR724X_BASE"
ident "AP91"
hints "AP91.hints"
options AR71XX_REALMEM=16*1024*1024
options AR71XX_ENV_UBOOT
# Limit inlines
makeoptions INLINE_LIMIT=768
# We bite the performance overhead for now; the kernel won't
# fit if the mutexes are inlined.
options MUTEX_NOINLINE
options RWLOCK_NOINLINE
options SX_NOINLINE
# There's no need to enable swapping on this platform.
options NO_SWAPPING
# For DOS - enable if required
# options MSDOSFS
# uncompress - to boot read-only lzma natively from flash
device geom_uncompress
options GEOM_UNCOMPRESS
options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
# Not enough space for these..
nooptions INVARIANTS
nooptions INVARIANT_SUPPORT
nooptions WITNESS
nooptions WITNESS_SKIPSPIN
nooptions DEBUG_REDZONE
nooptions DEBUG_MEMGUARD
# Used for the static uboot partition map
device geom_map
# Options needed for the EEPROM based calibration/PCI configuration data.
options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
device firmware # Used by the above
# Options required for miiproxy and mdiobus
options ARGE_MDIO # Export an MDIO bus separate from arge
device miiproxy # MDIO bus <-> MII PHY rendezvous
device etherswitch
device arswitch