freebsd-dev/sys/dev/ath/ath_hal/ar5416
Adrian Chadd d10f1cdc8c Mark the PHY as inactive before the chip is reset.
It's also marked inactive by the initvals, and enabled after
the baseband/PLL has been configured, but before the RF
registers have been programmed.

The origin and reason for this particular change is currently unknown.

Obtained from:	Linux ath9k
2011-04-17 13:46:13 +00:00
..
ar2133.c Add some more debugging 2011-04-02 00:24:13 +00:00
ar5416_ani.c The AR5416+ chips all have MIB counters (which the AR5416 ANI code assumes) 2011-03-23 03:58:55 +00:00
ar5416_attach.c Add a HAL capability bit for supporting self-linked RX descriptors and disable it for the 11n chipsets. 2011-04-04 14:52:31 +00:00
ar5416_beacon.c
ar5416_cal_adcdc.c
ar5416_cal_adcgain.c
ar5416_cal_iq.c Fix the calibration logic to correctly clamp the calculated coefficient. 2010-08-14 15:28:15 +00:00
ar5416_cal.c Export the per-chain ctl/ext noise floor values, raw and uncut, to the 2011-04-08 06:58:01 +00:00
ar5416_cal.h Introduce methods for the initial calibration and the new PA calibration 2011-03-11 11:35:36 +00:00
ar5416_eeprom.c
ar5416_gpio.c
ar5416_interrupts.c Introduce AH_AR5416_INTERRUPT_MITIGATION which enables interrupt mitigation for 2011-03-31 08:48:05 +00:00
ar5416_keycache.c
ar5416_misc.c Disable classic-style fast diversity on the AR5416 and later. 2011-04-16 12:46:46 +00:00
ar5416_phy.c Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic, 2011-02-21 05:10:34 +00:00
ar5416_power.c
ar5416_recv.c Add a HAL capability bit for supporting self-linked RX descriptors and disable it for the 11n chipsets. 2011-04-04 14:52:31 +00:00
ar5416_reset.c Mark the PHY as inactive before the chip is reset. 2011-04-17 13:46:13 +00:00
ar5416_xmit.c Bring over a few queue changes from ath9k: 2011-03-22 00:14:17 +00:00
ar5416.h Remove some duplicate code from the AR9285 TX power configuration path. 2011-04-16 11:59:37 +00:00
ar5416.ini Bring over ar5416 inivals from Linux-2.6.34. 2010-08-10 07:48:13 +00:00
ar5416desc.h
ar5416phy.h Add in some AR9280 specific board configuration options. 2011-02-07 22:00:31 +00:00
ar5416reg.h The right commit - add a couple more AR_PCU_MISC_MODE2 register bits - 2011-03-25 00:06:58 +00:00