freebsd-dev/sys/dev/ath/ath_rate/sample/sample.h
Sam Leffler b032f27c36 Multi-bss (aka vap) support for 802.11 devices.
Note this includes changes to all drivers and moves some device firmware
loading to use firmware(9) and a separate module (e.g. ral).  Also there
no longer are separate wlan_scan* modules; this functionality is now
bundled into the wlan module.

Supported by:	Hobnob and Marvell
Reviewed by:	many
Obtained from:	Atheros (some bits)
2008-04-20 20:35:46 +00:00

252 lines
7.3 KiB
C

/*-
* Copyright (c) 2005 John Bicket
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer,
* without modification.
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
* similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
* redistribution must be conditioned upon including a substantially
* similar Disclaimer requirement for further binary redistribution.
* 3. Neither the names of the above-listed copyright holders nor the names
* of any contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* Alternatively, this software may be distributed under the terms of the
* GNU General Public License ("GPL") version 2 as published by the Free
* Software Foundation.
*
* NO WARRANTY
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
* AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
* THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
* OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
* IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
* THE POSSIBILITY OF SUCH DAMAGES.
*
* $FreeBSD$
*/
/*
* Defintions for the Atheros Wireless LAN controller driver.
*/
#ifndef _DEV_ATH_RATE_SAMPLE_H
#define _DEV_ATH_RATE_SAMPLE_H
/* per-device state */
struct sample_softc {
struct ath_ratectrl arc; /* base state */
int ath_smoothing_rate; /* ewma percentage (out of 100) */
int ath_sample_rate; /* send a different bit-rate 1/X packets */
};
#define ATH_SOFTC_SAMPLE(sc) ((struct sample_softc *)sc->sc_rc)
struct rate_info {
int rate;
int rix;
int rateCode;
int shortPreambleRateCode;
};
struct rate_stats {
unsigned average_tx_time;
int successive_failures;
int tries;
int total_packets;
int packets_acked;
unsigned perfect_tx_time; /* transmit time for 0 retries */
int last_tx;
};
/*
* for now, we track performance for three different packet
* size buckets
*/
#define NUM_PACKET_SIZE_BINS 3
static int packet_size_bins[NUM_PACKET_SIZE_BINS] = {250, 1600, 3000};
/* per-node state */
struct sample_node {
int static_rate_ndx;
int num_rates;
struct rate_info rates[IEEE80211_RATE_MAXSIZE];
struct rate_stats stats[NUM_PACKET_SIZE_BINS][IEEE80211_RATE_MAXSIZE];
int last_sample_ndx[NUM_PACKET_SIZE_BINS];
int current_sample_ndx[NUM_PACKET_SIZE_BINS];
int packets_sent[NUM_PACKET_SIZE_BINS];
int current_rate[NUM_PACKET_SIZE_BINS];
int packets_since_switch[NUM_PACKET_SIZE_BINS];
unsigned ticks_since_switch[NUM_PACKET_SIZE_BINS];
int packets_since_sample[NUM_PACKET_SIZE_BINS];
unsigned sample_tt[NUM_PACKET_SIZE_BINS];
};
#define ATH_NODE_SAMPLE(an) ((struct sample_node *)&an[1])
#ifndef MIN
#define MIN(a,b) ((a) < (b) ? (a) : (b))
#endif
#ifndef MAX
#define MAX(a,b) ((a) > (b) ? (a) : (b))
#endif
#define WIFI_CW_MIN 31
#define WIFI_CW_MAX 1023
/*
* Definitions for pulling the rate and trie counts from
* a 5212 h/w descriptor. These Don't belong here; the
* driver should record this information so the rate control
* code doesn't go groveling around in the descriptor bits.
*/
#define ds_ctl2 ds_hw[0]
#define ds_ctl3 ds_hw[1]
/* TX ds_ctl2 */
#define AR_XmitDataTries0 0x000f0000 /* series 0 max attempts */
#define AR_XmitDataTries0_S 16
#define AR_XmitDataTries1 0x00f00000 /* series 1 max attempts */
#define AR_XmitDataTries1_S 20
#define AR_XmitDataTries2 0x0f000000 /* series 2 max attempts */
#define AR_XmitDataTries2_S 24
#define AR_XmitDataTries3 0xf0000000 /* series 3 max attempts */
#define AR_XmitDataTries3_S 28
/* TX ds_ctl3 */
#define AR_XmitRate0 0x0000001f /* series 0 tx rate */
#define AR_XmitRate0_S 0
#define AR_XmitRate1 0x000003e0 /* series 1 tx rate */
#define AR_XmitRate1_S 5
#define AR_XmitRate2 0x00007c00 /* series 2 tx rate */
#define AR_XmitRate2_S 10
#define AR_XmitRate3 0x000f8000 /* series 3 tx rate */
#define AR_XmitRate3_S 15
/* TX ds_ctl3 for 5416 */
#define AR5416_XmitRate0 0x000000ff /* series 0 tx rate */
#define AR5416_XmitRate0_S 0
#define AR5416_XmitRate1 0x0000ff00 /* series 1 tx rate */
#define AR5416_XmitRate1_S 8
#define AR5416_XmitRate2 0x00ff0000 /* series 2 tx rate */
#define AR5416_XmitRate2_S 16
#define AR5416_XmitRate3 0xff000000 /* series 3 tx rate */
#define AR5416_XmitRate3_S 24
#define MS(_v, _f) (((_v) & (_f)) >> _f##_S)
/*
* Calculate the transmit duration of a frame.
*/
static unsigned calc_usecs_unicast_packet(struct ath_softc *sc,
int length,
int rix, int short_retries, int long_retries) {
const HAL_RATE_TABLE *rt = sc->sc_currates;
struct ifnet *ifp = sc->sc_ifp;
struct ieee80211com *ic = ifp->if_l2com;
int rts, cts;
unsigned t_slot = 20;
unsigned t_difs = 50;
unsigned t_sifs = 10;
int tt = 0;
int x = 0;
int cw = WIFI_CW_MIN;
int cix;
KASSERT(rt != NULL, ("no rate table, mode %u", sc->sc_curmode));
if (rix >= rt->rateCount) {
printf("bogus rix %d, max %u, mode %u\n",
rix, rt->rateCount, sc->sc_curmode);
return 0;
}
cix = rt->info[rix].controlRate;
/*
* XXX getting mac/phy level timings should be fixed for turbo
* rates, and there is probably a way to get this from the
* hal...
*/
switch (rt->info[rix].phy) {
case IEEE80211_T_OFDM:
t_slot = 9;
t_sifs = 16;
t_difs = 28;
/* fall through */
case IEEE80211_T_TURBO:
t_slot = 9;
t_sifs = 8;
t_difs = 28;
break;
case IEEE80211_T_DS:
/* fall through to default */
default:
/* pg 205 ieee.802.11.pdf */
t_slot = 20;
t_difs = 50;
t_sifs = 10;
}
rts = cts = 0;
if ((ic->ic_flags & IEEE80211_F_USEPROT) &&
rt->info[rix].phy == IEEE80211_T_OFDM) {
if (ic->ic_protmode == IEEE80211_PROT_RTSCTS)
rts = 1;
else if (ic->ic_protmode == IEEE80211_PROT_CTSONLY)
cts = 1;
cix = rt->info[sc->sc_protrix].controlRate;
}
if (0 /*length > ic->ic_rtsthreshold */) {
rts = 1;
}
if (rts || cts) {
int ctsrate;
int ctsduration = 0;
/* NB: this is intentionally not a runtime check */
KASSERT(cix < rt->rateCount,
("bogus cix %d, max %u, mode %u\n", cix, rt->rateCount,
sc->sc_curmode));
ctsrate = rt->info[cix].rateCode | rt->info[cix].shortPreamble;
if (rts) /* SIFS + CTS */
ctsduration += rt->info[cix].spAckDuration;
ctsduration += ath_hal_computetxtime(sc->sc_ah,
rt, length, rix, AH_TRUE);
if (cts) /* SIFS + ACK */
ctsduration += rt->info[cix].spAckDuration;
tt += (short_retries + 1) * ctsduration;
}
tt += t_difs;
tt += (long_retries+1)*(t_sifs + rt->info[rix].spAckDuration);
tt += (long_retries+1)*ath_hal_computetxtime(sc->sc_ah, rt, length,
rix, AH_TRUE);
for (x = 0; x <= short_retries + long_retries; x++) {
cw = MIN(WIFI_CW_MAX, (cw + 1) * 2);
tt += (t_slot * cw/2);
}
return tt;
}
#endif /* _DEV_ATH_RATE_SAMPLE_H */