loader(8)
In r193192 loader(8) has grown an ability to pass root mount options
from fstab via vfs.root.mountfrom.options. Unfortunately, some options
that can be present in fstab are for userland only and lead to root
mounting failure when seen by kernel.
Rather than teaching loader about FFS-specific options that should be
filtered out, ffs_mount recognizes those options as valid, but ignores
and deletes[1] them.
[1] is suggested by jh.
PR: kern/141050
Reported by: many
Reviewed by: jh, bde
MFC after: 4 days
on the last iteration. This can lead to a deadlock when we have
worklist items that cannot be immediately satisfied.
Reported by: uqs, Dimitry Andric <dimitry@andric.com>
- Remove some unnecessary debugging code and place some other under
SUJ_DEBUG.
- Examine the journal state in softdep_slowdown().
- Re-format some comments so I may more easily add flag descriptions.
We do not respect rules 3 and 4 in the required list:
1. omit leading zeros
2. "::" used to their maximum extent whenever possible
3. "::" used where shortens address the most
4. "::" used in the former part in case of a tie breaker
5. do not shorten one 16 bit 0 field
6. use lower case
http://tools.ietf.org/html/draft-ietf-6man-text-addr-representation-04.html
Submitted by: Kalluru Abhiram @ Juniper Networks
Obtained from: Juniper Networks
Reviewed by: hrs, dougb
When not defining header split do not allocate mbufs,
this can be a BIG savings in the mbuf memory pool.
Also keep seperate dma maps for the header and
payload pieces when doing header split. The basis
of this code was a patch done a while ago by
yongari, thank you :)
A number of white space changes.
MFC: in a few days
free(9) and it can cause kernel panic when there are multiple graphics
controllers in the system.
Tested by: Brandon Gooch (jamesbrandongooch at gmail dot com)
MFC after: 3 days
eliminate it.
Assert that the object containing the page is locked in
vm_page_test_dirty(). Perform some style clean up while I'm here.
Reviewed by: kib
interface when tearing down a vlan interface. If a trunk interface is
detached, all of its multicast addresses are removed before the ifnet
departure eventhandlers are invoked. This means that all of the multicast
addresses are removed before the vlan interfaces are removed which causes
the if_delmulti() calls in the vlan teardown to fail.
In the VLAN_ARRAY case, this left vlan interfaces referencing a no longer
valid parent interface. In the !VLAN_ARRAY case, the eventhandler gets
stuck in an infinite loop retrying vlan_unconfig_locked() forever. In
general the callers of vlan_unconfig_locked() do not expect nor handle
failure, so I believe it is safer to ignore the errors and tear down as
much of the vlan state as possible.
Silence from: net@
MFC after: 4 days
here, make the style of assertion used by pmap_enter() consistent
across all architectures.
On entry to pmap_remove_write(), assert that the page is neither
unmanaged nor fictitious, since we cannot remove write access to
either kind of page.
With the push down of the page queues lock, pmap_remove_write() cannot
condition its behavior on the state of the PG_WRITEABLE flag if the
page is busy. Assert that the object containing the page is locked.
This allows us to know that the page will neither become busy nor will
PG_WRITEABLE be set on it while pmap_remove_write() is running.
Correct a long-standing bug in vm_page_cowsetup(). We cannot possibly
do copy-on-write-based zero-copy transmit on unmanaged or fictitious
pages, so don't even try. Previously, the call to pmap_remove_write()
would have failed silently.
am now able to run 32 cores ok.. but I still will hang
on buildworld with a NFS problem. I suspect I am missing
a patch for the netlogic rge driver.
JC check and see if I am missing anything except your
core-mask changes
Obtained from: JC
code base. We now properly have ONE thread
that services all VNET's. Also we purge out
the old timer based iterator code which had
multiple LOR's and other issues.
MFC after: 3 days
firmware in order to take over control of the SMU. Without doing this,
the firmware background process doing fan control will run amok as we
take over the system and crash the management chip.
This is limited to these two machines because our kernel is heavily
dependent on firmware accesses, and so quiescing firmware can cause
nasty problems.
Powermac G5 systems. MSI and several other things are not presently
supported.
The U3/U4 internal device support portions of this change were contributed
by Andreas Tobler.
MFC after: 1 week
This eliminates the only place where we can sleep when calling zio_interrupt().
As a side-effect this can actually improve performance a little as we
allocate one less thing for every I/O.
Prodded by: kib
MFC after: 1 week
avoid calling zio_interrupt() from geom_up thread context. It turns out that
when provider is forcibly removed from the system and we kill worker thread
there can still be some ZIOs pending. To complete pending ZIOs when there is
no worker thread anymore we still have to call zio_interrupt() from geom_up
context. To avoid this race just remove use of worker threads altogether.
This should be more or less fine, because I also thought that zio_interrupt()
does more work, but it only makes small UMA allocation with M_WAITOK.
It also saves one context switch per I/O request.
PR: kern/145339
Reported by: Alex Bakhtin <Alex.Bakhtin@gmail.com>
MFC after: 1 week
so ni_txrate returned 0 which is a invalid result.
- The fourth argument of ieee80211_ratectl_tx_complete() could be not
NULL.
Reported by: Gustau P?rez <gperez at entel.upc.edu>
Tested by: Gustau P?rez <gperez at entel.upc.edu>,
Ian FREISLICH <ianf at clue.co.za>
MFC after: 3 days
On a soekris Net5501, if you do a watchdog -t 16, followed by a watchdog
-t 0 to disable the watchdog, and then after some time (16s) re-enable
the watchdog the box reboots immediatly. This prevents also to stop and
restart watchdogd(8).
This is because when you stop the watchdog, the timer is not stoped,
only the hard reset is disabled. So when the timer has elapsed, the C2
event of the timer is set.
But when the hard reset is re-enabled, the event is not cleared and the
box reboots.
The attached patch stops and resets the counter when the watchdog is
disabled and do not disable the hard reset of the timer (if the timer
has elapsed it's too late).
Submitted by: Patrick Lamaizière
- add a moderation value to the Link vector
- allow disabling HW RSC on the 82599 if LRO
is not enabled.
- correct error in the stats code
- change optic type on the 82598 DA device
Thanks to Andrew Boyer for the changes.
We cannot expect that modspace is the last entry in the linker
set and thus that modspace + possible extra space up to PAGE_SIZE
would be contiguous. For the moment do not support more than
*_MODMIN space and ignore the extra space (*).
(*) We know how to get it back but it'll need testing.
Discussed with: jeff, rwatson (briefly)
Reviewed by: jeff
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 4 days
implementation.
- Revert the Sun Fire V890 WAR of r205254. Instead let schizo_pci_bus()
only panic in case of fatal errors as the interrupt triggered by the
error the firmware of these and also Sun Fire 280R with version 7
Schizo caused may happen as late as using the HBA and not only prior
to touching the PCI bus (in the former case the actual error still is
fatal but we clear it before touching the PCI bus).
While at it count and export non-fatal error interrupts via sysctl(9).
- Remove unnecessary locking from schizo_ue().
