sysctls to MI code; this reduces code duplication and makes all of them
available on sparc64, and the latter two on powerpc.
The semantics by the i386 and pc98 hw.availpages is slightly changed:
previously, holes between ranges of available pages would be included,
while they are excluded now. The new behaviour should be more correct
and brings i386 in line with the other architectures.
Move physmem to vm/vm_init.c, where this variable is used in MI code.
take advantage of the fact that the vm object's list of pages is
now ordered to reduce the overhead of finding the desired set of
pages to be mapped. (See revision 1.215 of vm/vm_page.c.)
remove global variable in_vm86call, set vm86 calling flag in PCB flags.
2.Fix vm86 BIOS calling preempted problem by changing vm86_lock mutex type
from MTX_DEF to MTX_SPIN. vm86pcb is not remembered in thread struct,
when the thread calling vm86 BIOS is preempted by interrupt thread,
and later switching back to the thread would cause incorrect context be
loaded into CPU registers, this leads to kernel crash.
not look like the prerequisites to fill it in properly will be in the tree
for the upcoming release, but it's mostly done, so there is no need for these
to stay around to remind us.
o It turns out that we always need to try to route the interrupts for
the case where the $PIR tells us there can be only one. Some machines
require this, while others fail when we try to do this (bogusly, imho).
Since we have no apriori way of knowing which is which, we always try to
do the routing and hope for the best if things fail.
o Add some additional comments that state the obvious, but amplify it in
non-obvious ways (judging from the questions I've gotten).
This should un-break older laptops that still have to use PCIBIOS to route
interrupts.
Tested by: sam
Use exact width types, since this is a MD file and won't be used elsewhere.
Fix a couple of resulting printf breakages
Bug found by: phk using Flexlint
handling clean and functional as 5.x evolves. This allows some of the
nasty bandaids in the 5.x codepaths to be unwound.
Encapsulate 4.x signal handling under COMPAT_FREEBSD4 (there is an
anti-foot-shooting measure in place, 5.x folks need this for a while) and
finish encapsulating the older stuff under COMPAT_43. Since the ancient
stuff is required on alpha (longjmp(3) passes a 'struct osigcontext *'
to the current sigreturn(2), instead of the 'ucontext_t *' that sigreturn
is supposed to take), add a compile time check to prevent foot shooting
there too. Add uniform COMPAT_43 stubs for ia64/sparc64/powerpc.
Tested on: i386, alpha, ia64. Compiled on sparc64 (a few days ago).
Approved by: re
Try INT 15H/E820H first, then fall back to the old compatibility
method (INT 12H).
This is a workaround for newer machines which have broken INT 12H BIOS
service implementation.
Reviewed by: -current ML
MFC after: 3 days
long doubles at the moment (printf truncates them to doubles).
However, long doubles to appear to work to the ranges listed in this
commit on both -stable (4.5) and -current. There may be some slight
rounding issues with long doubles, but that's an orthogonal issue to
these constants.
I've had this in my local tree for 3 months, and in my company's local
tree for 15 months with no ill effects.
Obtained from: NetBSD
Not likely to like it: bde
so that there is ony one copy of it. Fix that one copy
so that KSEs with no mailbox in a KSE program are not a cause
of page faults (this can legitmatly happen).
Submitted by: (parts) davidxu
This is for the not-quite-ready signal/fpu abi stuff. It may not see
the light of day, but I'm certainly not going to be able to validate it
when getting shot in the foot due to syscall number conflicts.
execve_secure() system call, which permits a process to pass in a label
for a label change during exec. This permits SELinux to change the
label for the resulting exec without a race following a manual label
change on the process. Because this interface uses our general purpose
MAC label abstraction, we call it execve_mac(), and wrap our port of
SELinux's execve_secure() around it with appropriate sid mappings.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
The primary reason for this is to allow MD code to process machine
specific attributes, segments or sections in the ELF file and
update machine specific state accordingly. An immediate use of this
is in the ia64 port where unwind information is updated to allow
debugging and tracing in/across modules. Note that this commit
does not add the functionality to the ia64 port. See revision 1.9
of ia64/ia64/elf_machdep.c.
Validated on: alpha, i386, ia64
ACL configuration changes, this shouldn't result in different code paths
for file systems not explicitly configured for ACLs by the system
administrator. For UFS1, administrators must still recompile their
kernel to add support for extended attributes; for UFS2, it's sufficient
to enable ACLs using tunefs or at mount-time (tunefs preferred for
reliability reasons). UFS2, for a variety of reasons, including
performance and reliability, is the preferred file system for use with
ACLs.
Approved by: re
2. Update a comment. We now restore much more than RTC updates and
interrupts.
3. Order change. Stop interrupts by writing to RTC_STATUSB,
restore rate bits for the interrupts by writing to RTC_STATUSA,
then enable interrupts again.
This seems to be done perfectly backwards in startrtclock().
Otherwise, the idea for this change was obtained from
startrtclock().
4. Don't stop the clock (RTCB_HALT). We only program some control bits
and don't want to stop the clock.
5. (Not really related.) Add caveats to the comment about timer_restore().
The update is non-atomic since locking is not done.
On locking:
6. rtcin() and writertc() are locked() adequately by splhigh() in RELENG_4,
but this locking is null in -current.
7. Doing things in the correct order in (3) combined with (6) is probably
enough locking for rtcrestore() in RELENG_4. In -current, the
writertc()'s race with rtcintr() unless the BIOS disables RTC interrupts.
Submitted by: bde (including commit message)
MFC after: 1 week
This is most beneficial for vmware client os installs.
Reviewed by: jmallet, iedowse, tlambert2@mindspring.com
MFC After: never, -STABLE does not currently use this instruction
- Begin moving scheduler specific functionality into sched_4bsd.c
- Replace direct manipulation of scheduler data with hooks provided by the
new api.
- Remove KSE specific state modifications and single runq assumptions from
kern_switch.c
Reviewed by: -arch
that add an instance of themselves. The npx(4) driver doesn't even check
the npx 'port' hint but hardcodes IO_NPX instead. The npx(4) driver also
will use isa IRQ 13 (on x86, 8 on pc98) by default if no 'irq' hint is
specified, so we don't need that hint either.
in specific situations. The owner thread must be blocked, and the
borrower can not proceed back to user space with the borrowed KSE.
The borrower will return the KSE on the next context switch where
teh owner wants it back. This removes a lot of possible
race conditions and deadlocks. It is consceivable that the
borrower should inherit the priority of the owner too.
that's another discussion and would be simple to do.
Also, as part of this, the "preallocatd spare thread" is attached to the
thread doing a syscall rather than the KSE. This removes the need to lock
the scheduler when we want to access it, as it's now "at hand".
DDB now shows a lot mor info for threaded proceses though it may need
some optimisation to squeeze it all back into 80 chars again.
(possible JKH project)
Upcalls are now "bound" threads, but "KSE Lending" now means that
other completing syscalls can be completed using that KSE before the upcall
finally makes it back to the UTS. (getting threads OUT OF THE KERNEL is
one of the highest priorities in the KSE system.) The upcall when it happens
will present all the completed syscalls to the KSE for selection.
there are some strange machines that seem to need this.
o delete bogus comment.
o don't use the the bios for read/writing config space. They interact badly
with SMP and being called from ISR. This brings -current in line with
-stable.
# make the latter #ifdef on USE_PCI_BIOS_FOR_READ_WRITE in case we
# need to go back in a hurry.
