programming secret. The PHY would go into sleep state when it
detects no established link and it will re-establish link when the
cable is plugged in. Previously it failed to re-establish link
when the cable is plugged in such that it required to manually down
and up the interface again to make it work. This came from
incorrectly programmed hibernation parameters. According to
Atheros, each PHY chip requires different configuration for
hibernation and different vendor has different settings for the
same chip.
Disabling hibernation may consume more power but establishing link
looks more important than saving power.
Special thanks to Atheros for giving me instructions that disable
hibernation.
MFC after: 1 week
Approved by: re (kib)
that allow a module to use an order other than the default of
SI_ORDER_MIDDLE when registering a driver. This can be useful for drivers
in a kld that contain multiple new-bus drivers as part of one logical device
driver. A typical case would be to use SI_ORDER_LAST for the "main" driver
to ensure that any other "helper" drivers are registered and available
before the "main" driver attempts to attach.
Tested by: kib, Jason Harmening jason harmening / gmail
Approved by: re (kib)
MFC after: 1 week
after the conversion of the swap device size to the page size units,
not before. That lifts the limit on the usable swap partition size
from 32GB to 256GB, that is less depressing for the modern systems.
Submitted by: Alexander V. Chernikov <melifaro ipfw ru>
Reviewed by: alc
Approved by: re (bz)
MFC after: 2 weeks
environment with a core i5-2500K, operation in this mode causes timeouts
from the mpt driver. Switching to the ACPI-fast timer resolves this issue.
Switching the VM back to single CPU mode also works, which is why I have
not disabled the TSC in that mode.
I did not test with KVM or other VM environments, but I am being cautious
and assuming that the TSC is not reliable in SMP mode there as well.
Reviewed by: kib
Approved by: re (kib)
MFC after: Not applicable, the timecounter code is new for 9.x
callout cpu lock (and after having dropped it).
If the newly scheduled thread wants to acquire the old queue it will
just spin forever.
Fix this by disabling preemption and interrupts entirely (because fast
interrupt handlers may incur in the same problem too) while switching
locks.
Reported by: hrs, Mike Tancsa <mike AT sentex DOT net>,
Chip Camden <sterling AT camdensoftware DOT com>
Tested by: hrs, Mike Tancsa <mike AT sentex DOT net>,
Chip Camden <sterling AT camdensoftware DOT com>,
Nicholas Esborn <nick AT desert DOT net>
Approved by: re (kib)
MFC after: 10 days
an attempt to do an Open operation on any type of file other
than VREG is done. A recent discussion on the IETF working group's
mailing list (nfsv4@ietf.org) decided that NFSERR_SYMLINK
should be returned for all non-regular files and not just symlinks,
so that the Linux client would work correctly.
This change does not affect the FreeBSD NFSv4 client and is not
believed to have a negative effect on other NFSv4 clients.
Reviewed by: zkirsch
Approved by: re (kib)
MFC after: 2 weeks
temporary variable and check with if as TUNABLE_*_FETCH do not
alter values unless successfully found the tunable.
Reported by: jhb, bde
MFC after: 3 days
X-MFC with: r224516
Approved by: re (kib)
Distinguish IPv4 and IPv6 addresses and optional port numbers in
user space to set the option for the correct protocol family.
Add support in the kernel for carrying the new IPv6 destination
address and port.
Add support to TCP and UDP for IPv6 and fix UDP IPv4 to not change
the address in the IP header.
Add support for IPv6 forwarding to a non-local destination.
Add a regession test uitilizing VIMAGE to check all 20 possible
combinations I could think of.
Obtained from: David Dolson at Sandvine Incorporated
(original version for ipfw fwd IPv6 support)
Sponsored by: Sandvine Incorporated
PR: bin/117214
MFC after: 4 weeks
Approved by: re (kib)
people think: returning true for an address in any connected subnet, not
necessarily on the local machine.
Sponsored by: Sandvine Incorporated
MFC after: 2 weeks
Approved by: re (kib)
effectively negative. Often seen as upstream fastcgi connection timeouts
in nginx when using sendfile over unix domain sockets for communication.
Sendfile(2) may send more bytes then currently allowed by the
hiwatermark of the socket, e.g. because the so_snd sockbuf lock is
dropped after sbspace() call in the kern_sendfile() loop. In this case,
recalculated hiwatermark will overflow. Since lowatermark is renewed
as half of the hiwatermark by sendfile code, and both are unsigned,
the send buffer never reaches the free space requested by lowatermark,
causing indefinite wait in sendfile.
Reviewed by: rwatson
Approved by: re (bz)
MFC after: 2 weeks
more fragments flag off so that offset == 0 checks work properly.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
X-MFC with: r225032
Approved by: re (kib)
then terminate the loop as we will not find any further headers and
for short fragments this could otherwise lead to a pullup error
discarding the fragment.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
Approved by: re (kib)
packet is a/the first fragment or not. For IPv6 we have added the
"more fragments" flag as well to be able to determine on whether
there will be more as we do not have the fragment header avaialble
for logging, while for IPv4 this information can be derived directly
from the IPv4 header. This allowed fragmented packets to bypass
normal rules as proper masking was not done when checking offset.
Split variables to not need masking for IPv6 to avoid further errors.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
Approved by: re (kib)
translation technology involved (and that section is suggested to
be removed by Errata 2843), single packet fragments do not harm.
There is another errata under discussion to clarify and allow this.
Meanwhile add a sysctl to allow disabling this behaviour again.
We will treat single packet fragment (a fragment header added
when not needed) as if there was no fragment header.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz) (original version)
Tested by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
Approved by: re (kib)
isolated but also powered down after a reset and while they just work fine
[sic] when both is the case they don't if they are only deisolate but still
powered down. So in order to put PHYs in an overall normal operation mode
for the common case, ensure in mii_phy_reset() that they are not powered
down after a reset. Unfortunately, this only helps in case of BCM5421,
while BCM5709S apparently only work when they remain isolated and powered
down after a reset. So don't call mii_phy_reset() in brgphy_reset() and
implement the reset locally leaving the problematic bits alone. Effectively
this bypasses r221812 for brgphy(4).
Thanks to Justin Hibbits for doing a binary search in order to identify
the problematic commit.
PR: 157405, 158156
Reviewed by: yongari (mii_phy_reset() part)
Approved by: re (kib)
MFC after: 3 days
On a TX failure, ic_raw_xmit will still call ieee80211_node_free().
There's no need to call it here.
Submitted by: moonlightakkiy@yahoo.ca
Approved by: re (kib)
cores with temp in the range 101-105 have been found in the past.
Sponsored by: Sandvine Incorporated
Reviewed by: delphij, emaste
Approved by: re (kib)
MFC after: 3 days
buffer is greater than 1. This triggered panics in at least one spot in
the kernel (the MAC Framework) which passes non-negative, rather than >1
buffer sizes based on the size of a user buffer passed into a system
call. While 0-size buffers aren't particularly useful, they also aren't
strictly incorrect, so loosen the assertion.
Discussed with: phk (fears I might be EDOOFUS but willing to go along)
Spotted by: pho + stress2
Approved by: re (kib)
A "process descriptor" file descriptor is used to manage processes
without using the PID namespace. This is required for Capsicum's
Capability Mode, where the PID namespace is unavailable.
New system calls pdfork(2) and pdkill(2) offer the functional equivalents
of fork(2) and kill(2). pdgetpid(2) allows querying the PID of the remote
process for debugging purposes. The currently-unimplemented pdwait(2) will,
in the future, allow querying rusage/exit status. In the interim, poll(2)
may be used to check (and wait for) process termination.
When a process is referenced by a process descriptor, it does not issue
SIGCHLD to the parent, making it suitable for use in libraries---a common
scenario when using library compartmentalisation from within large
applications (such as web browsers). Some observers may note a similarity
to Mach task ports; process descriptors provide a subset of this behaviour,
but in a UNIX style.
This feature is enabled by "options PROCDESC", but as with several other
Capsicum kernel features, is not enabled by default in GENERIC 9.0.
Reviewed by: jhb, kib
Approved by: re (kib), mentor (rwatson)
Sponsored by: Google Inc
query the needed size for a sysctl result by passing in a NULL old
pointer and a valid oldsize. The kern.proc.args sysctl handler broke
this assumption by not calling SYSCTL_OUT() if the old pointer was
NULL.
Approved by: re (kib)
MFC after: 3 days
avoid lost timer interrupts. Previous optimization attempt doing it only
for intervals less then 5000 ticks (~300us) reported to be unreliable by
some people. Probably because of some heavy SMI code on their boards.
Introduce additional safety interval of 128 counter ticks (~9us) between
programmed comparator and counter values to cover different cases of
delayed write found on some chipsets.
Approved by: re (kib)
While there:
* Fix a locking issue in setsockopt() of SCTP_CMT_ON_OFF.
* Fix a bug in setsockopt() of SCTP_DEFAULT_PRINFO, where the pr_value
was ignored.
Approved by: re@
MFC after: 2 months.
to resolve the path of the text vnode of the process. The behaviour is
very confusing for any consumer of the procfs, in particular, java.
Reported and tested by: bf
MFC after: 2 weeks
Approved by: re (bz)
to implement fchown(2) and fchmod(2) support for several file types
that previously lacked it. Add MAC entries for chown/chmod done on
posix shared memory and (old) in-kernel posix semaphores.
Based on the submission by: glebius
Reviewed by: rwatson
Approved by: re (bz)
r224086 added "goto out"-style error handling to nfssvc_nfsd(), in order
to reliably call NFSEXITCODE() before returning. Our Capsicum changes,
based on the old "return (error)" model, did not merge nicely.
Approved by: re (kib), mentor (rwatson)
Sponsored by: Google Inc
When calling poll(2) on a capability, unwrap first and then poll the
underlying object.
Approved by: re (kib), mentor (rwatson)
Sponsored by: Google Inc
mutex, which would lead to a deadlock.
Many thanks to Areca for their continued support of FreeBSD.
Submitted by: Ching Huang <ching2048 areca com tw>
Tested by: Willem Jan Withagen <wjw digiware nl>
MFC after: 3 days
Approved by: re (kib)
bug that could cause intermittent memory corruption on PowerPC SMP
systems using non-debug kernels. This is a temporary change until the
real problem is fixed.
Approved by: re (kib)
(1) opt_capsicum.h is no longer required in ffs_alloc.c, so remove the
#include.
(2) portalfs depends on opt_capsicum.h, so have the Makefile generate one
if required.
These affect only modules built without a kernel (i.e, not buildkernel,
but yes buildworld if the dubious MODULES_WITH_WORLD is used).
Approved by: re (bz)
Sponsored by: Google Inc
We also revive loop down freezes. We also externaliz within isp
isp_prt_endcmd so something outside the core module can print
something about a command completing. Also some work in progress to
assist in handling timed out commands better.
Partially Sponsored by: Panasas
Approved by: re (kib)
MFC after: 1 month
zvol.c: fix calling of dmu_objset_prefetch() in zvol_create_minors()
by passing full instead of relative dataset name and prefetching all
visible datasets to be processed later instead of just the pool name
Reviewed by: pjd
Approved by: re (kib)
MFC after: 1 week
> Reviewed by: If someone else reviewed your modification.
> Approved by: If you needed approval for this commit.
> Obtained from: If the change is from a third party.
> MFC after: N [day[s]|week[s]|month[s]]. Request a reminder email.
> Security: Vulnerability reference (one per line) or description.
> Empty fields above will be automatically removed.
M opensolaris/uts/common/fs/zfs/zfs_ioctl.c
M opensolaris/uts/common/fs/zfs/zvol.c
