call is in progress on the vnode. When vput() or vrele() sees a
1->0 reference count transition, it now return without any further
action if this flag is set. This flag is necessary to avoid recursion
into VOP_INACTIVE if the filesystem inactive routine causes the
reference count to increase and then drop back to zero. It is also
used to guarantee that an unlocked vnode will not be recycled while
blocked in VOP_INACTIVE().
There are at least two cases where the recursion can occur: one is
that the softupdates code called by ufs_inactive() via ffs_truncate()
can call vput() on the vnode. This has been reported by many people
as "lockmgr: draining against myself" panics. The other case is
that nfs_inactive() can call vget() and then vrele() on the vnode
to clean up a sillyrename file.
Reviewed by: mckusick (an older version of the patch)
to treat desiredvnodes much more like a limit than as a vague concept.
On a 2GB RAM machine where desired vnodes is 130k, we run out of
kmem_map space when we hit about 190k vnodes.
If we wake up the vnode washer in getnewvnode(), sleep until it is done,
so that it has a chance to offer us a washed vnode. If we don't sleep
here we'll just race ahead and allocate yet a vnode which will never
get freed.
In the vnodewasher, instead of doing 10 vnodes per mountpoint per
rotation, do 10% of the vnodes distributed evenly across the
mountpoints.
"refreshing" the label on the vnode before use, just get the label
right from inception. For single-label file systems, set the label
in the generic VFS getnewvnode() code; for multi-label file systems,
leave the labeling up to the file system. With UFS1/2, this means
reading the extended attribute during vfs_vget() as the inode is
pulled off disk, rather than hitting the extended attributes
frequently during operations later, improving performance. This
also corrects sematics for shared vnode locks, which were not
previously present in the system. This chances the cache
coherrency properties WRT out-of-band access to label data, but in
an acceptable form. With UFS1, there is a small race condition
during automatic extended attribute start -- this is not present
with UFS2, and occurs because EAs aren't available at vnode
inception. We'll introduce a work around for this shortly.
Approved by: re
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
check for and/or report I/O errors. The result is that a VFS_SYNC
or VOP_FSYNC called with MNT_WAIT could loop infinitely on ufs in
the presence of a hard error writing a disk sector or in a filesystem
full condition. This patch ensures that I/O errors will always be
checked and returned. This patch also ensures that every call to
VFS_SYNC or VOP_FSYNC with MNT_WAIT set checks for and takes
appropriate action when an error is returned.
Sponsored by: DARPA & NAI Labs.
be sure to exit the loop with vp == NULL if no candidates are found.
Formerly, this bug would cause the last vnode inspected to be used,
even if it was not available. The result was a panic "vn_finished_write:
neg cnt".
Sponsored by: DARPA & NAI Labs.
vclean() function (e.g., vp->v_vnlock = &vp->v_lock) rather
than requiring filesystems that use alternate locks to do so
in their vop_reclaim functions. This change is a further cleanup
of the vop_stdlock interface.
Submitted by: Poul-Henning Kamp <phk@critter.freebsd.dk>
Sponsored by: DARPA & NAI Labs.
that use it. Specifically, vop_stdlock uses the lock pointed to by
vp->v_vnlock. By default, getnewvnode sets up vp->v_vnlock to
reference vp->v_lock. Filesystems that wish to use the default
do not need to allocate a lock at the front of their node structure
(as some still did) or do a lockinit. They can simply start using
vn_lock/VOP_UNLOCK. Filesystems that wish to manage their own locks,
but still use the vop_stdlock functions (such as nullfs) can simply
replace vp->v_vnlock with a pointer to the lock that they wish to
have used for the vnode. Such filesystems are responsible for
setting the vp->v_vnlock back to the default in their vop_reclaim
routine (e.g., vp->v_vnlock = &vp->v_lock).
In theory, this set of changes cleans up the existing filesystem
lock interface and should have no function change to the existing
locking scheme.
Sponsored by: DARPA & NAI Labs.
vcanrecycle to check a free vnode's availability. If it is
available, vcanrecycle returns an error code of zero and the
vnode in question locked. The getnewvnode routine then used
to call vn_start_write with the V_NOWAIT flag. If the filesystem
was suspended while taking a snapshot, the vn_start_write would
fail but getnewvnode would fail to unlock the vnode, instead
leaving it locked on the freelist. The result would be that the
vnode would be locked forever and would eventually hang the
system with a race to the root when it was attempted to recycle
it. This fix moves the vn_start_write check into vcanrecycle
where it will properly unlock the vnode if it is unavailable
for recycling due to filesystem suspension.
Sponsored by: DARPA & NAI Labs.
interlock in getnewvnode() to avoid possible sleeps while holding
the mutex. Note that the warning from Witness is a slight false
positive since we know there will be no contention on the interlock
since we haven't made the vnode available for use yet, but the theory
is not a bad one.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, Network Associates Laboratories
- Make the VI asserts more orthogonal to the rest of the asserts by using a
new, common vfs_badlock() function and adding a 'str' arg.
- Adjust generated ASSERTS to match the new prototype.
- Adjust explicit ASSERTS to match the new prototype.
- Enable vfs_badlock_mutex by default.
- Assert that the vp is locked in VOP_UNLOCK.
- Use standard interlock macros in remaining code.
- Correct a race in getnewvnode().
- Lock access to v_numoutput with interlock.
- Lock access to buf lists and splay tree with interlock.
- Add VOP and VI asserts.
- Lock b_vnbufs with the vnode interlock.
- Add vrefcnt() for callers who want to retreive the vnode ref without
holding a lock. Add a comment that describes when this is safe.
- Add vholdl() and vdropl() so that callers who already own the interlock
can avoid race conditions and unnecessary unlocking.
- Move the VOP_GETATTR() in vflush() into the WRITECLOSE conditional case.
- Hold the interlock before droping the mntlist_mtx in vflush() to avoid
a race.
- Fix locking in vfs_msync().
v_tag is now const char * and should only be used for debugging.
Additionally:
1. All users of VT_NTS now check vfsconf->vf_type VFCF_NETWORK
2. The user of VT_PROCFS now checks for the new flag VV_PROCDEP, which
is propagated by pseudofs to all child vnodes if the fs sets PFS_PROCDEP.
Suggested by: phk
Reviewed by: bde, rwatson (earlier version)
LK_INTERLOCK. The interlock will never be held on return from these
functions even when there is an error. Errors typically only occur when
the XLOCK is held which means this isn't the vnode we want anyway. Almost
all users of these interfaces expected this behavior even though it was
not provided before.
with interlock held in error conditions when the caller did not specify
LK_INTERLOCK.
- Add several comments to vn_lock() describing the rational behind the code
flow since it was not immediately obvious.
released. vcanrecycle() failed to unlock interlock under this condition.
- Remove an extra VOP_UNLOCK from a failure case in vcanrecycle().
Pointed out by: rwatson
- Use the new VI asserts in place of the old mtx_assert checks.
- Add the VI asserts to the automated lock checking in the VOP calls. The
interlock should not be held across vops with a few exceptions.
- Add the vop_(un)lock_{pre,post} functions to assert that interlock is held
when LK_INTERLOCK is set.
- Make getvfsbyname() take a struct xvfsconf *.
- Convert several consumers of getvfsbyname() to use struct xvfsconf.
- Correct the getvfsbyname.3 manpage.
- Create a new vfs.conflist sysctl to dump all the struct xvfsconf in the
kernel, and rewrite getvfsbyname() to use this instead of the weird
existing API.
- Convert some {set,get,end}vfsent() consumers to use the new vfs.conflist
sysctl.
- Convert a vfsload() call in nfsiod.c to kldload() and remove the useless
vfsisloadable() and endvfsent() calls.
- Add a warning printf() in vfs_sysctl() to tell people they are using
an old userland.
After these changes, it's possible to modify struct vfsconf without
breaking the binary compatibility. Please note that these changes don't
break this compatibility either.
When bp will have updated mount_smbfs(8) with the patch I sent him, there
will be no more consumers of the {set,get,end}vfsent(), vfsisloadable()
and vfsload() API, and I will promptly delete it.
- v_vflag is protected by the vnode lock and is used when synchronization
with VOP calls is needed.
- v_iflag is protected by interlock and is used for dealing with vnode
management issues. These flags include X/O LOCK, FREE, DOOMED, etc.
- All accesses to v_iflag and v_vflag have either been locked or marked with
mp_fixme's.
- Many ASSERT_VOP_LOCKED calls have been added where the locking was not
clear.
- Many functions in vfs_subr.c were restructured to provide for stronger
locking.
Idea stolen from: BSD/OS
kernel access control.
Invoke the necessary MAC entry points to maintain labels on vnodes.
In particular, initialize the label when the vnode is allocated or
reused, and destroy the label when the vnode is going to be released,
or reused. Wow, an object where there really is exactly one place
where it's allocated, and one other where it's freed. Amazing.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
SYSCTL_OUT() from blocking while locks are held. This should
only be done when it would be inconvenient to make a temporary copy of
the data and defer calling SYSCTL_OUT() until after the locks are
released.
As this code is not actually used by any of the existing
interfaces, it seems unlikely to break anything (famous
last words).
The internal kernel interface to manipulate these attributes
is invoked using two new IO_ flags: IO_NORMAL and IO_EXT.
These flags may be specified in the ioflags word of VOP_READ,
VOP_WRITE, and VOP_TRUNCATE. Specifying IO_NORMAL means that
you want to do I/O to the normal data part of the file and
IO_EXT means that you want to do I/O to the extended attributes
part of the file. IO_NORMAL and IO_EXT are mutually exclusive
for VOP_READ and VOP_WRITE, but may be specified individually
or together in the case of VOP_TRUNCATE. For example, when
removing a file, VOP_TRUNCATE is called with both IO_NORMAL
and IO_EXT set. For backward compatibility, if neither IO_NORMAL
nor IO_EXT is set, then IO_NORMAL is assumed.
Note that the BA_ and IO_ flags have been `merged' so that they
may both be used in the same flags word. This merger is possible
by assigning the IO_ flags to the low sixteen bits and the BA_
flags the high sixteen bits. This works because the high sixteen
bits of the IO_ word is reserved for read-ahead and help with
write clustering so will never be used for flags. This merge
lets us get away from code of the form:
if (ioflags & IO_SYNC)
flags |= BA_SYNC;
For the future, I have considered adding a new field to the
vattr structure, va_extsize. This addition could then be
exported through the stat structure to allow applications to
find out the size of the extended attribute storage and also
would provide a more standard interface for truncating them
(via VOP_SETATTR rather than VOP_TRUNCATE).
I am also contemplating adding a pathconf parameter (for
concreteness, lets call it _PC_MAX_EXTSIZE) which would
let an application determine the maximum size of the extended
atribute storage.
Sponsored by: DARPA & NAI Labs.
support creation times such as UFS2) to the value of the
modification time if the value of the modification time is older
than the current creation time. See utimes(2) for further details.
Sponsored by: DARPA & NAI Labs.
methodology similar to the vm_map_entry splay and the VM splay that Alan
Cox is working on. Extensive testing has appeared to have shown no
increase in overhead.
Disadvantages
Dirties more cache lines during lookups.
Not as fast as a hash table lookup (but still N log N and optimal
when there is locality of reference).
Advantages
vnode->v_dirtyblkhd is now perfectly sorted, making fsync/sync/filesystem
syncer operate more efficiently.
I get to rip out all the old hacks (some of which were mine) that tried
to keep the v_dirtyblkhd tailq sorted.
The per-vnode splay tree should be easier to lock / SMPng pushdown on
vnodes will be easier.
This commit along with another that Alan is working on for the VM page
global hash table will allow me to implement ranged fsync(), optimize
server-side nfs commit rpcs, and implement partial syncs by the
filesystem syncer (aka filesystem syncer would detect that someone is
trying to get the vnode lock, remembers its place, and skip to the
next vnode).
Note that the buffer cache splay is somewhat more complex then other splays
due to special handling of background bitmap writes (multiple buffers with
the same lblkno in the same vnode), and B_INVAL discontinuities between the
old hash table and the existence of the buffer on the v_cleanblkhd list.
Suggested by: alc
