This is defined as Device-nGnRnE in the UEFI spec (UEFI 2.4, section
2.3.6.1). This is the VM_MEMATTR_DEVICE type in FreeBSD.
Reported by: tuexen
Sponsored by: DARPA, AFRL
We should only call pmap_fault in the kernel when accessing a userspace
address. As this should always happen through specific functions that set
a fault handler we can use this to limit calls to pmap_fault to when this
is set.
This should help with NULL pointer dereferences when we are unable to sleep
so we fall into the correct case.
Sponsored by: DARPA, AFRL
lists in the EFI memory map. As such we need to reduce the mappings to
restrict them to not be the full 1G block. For now reduce this to a 2M
block, however this may be further restricted to be 4k page aligned as
other SoCs may require.
This allows ThunderX2 to boot reliably to userspace without performing
any speculative memory accesses to invalid physical memory.
This is a recommit of r334035 now that we can access the EFI Runtime data
through the DMAP region.
Tested by: tuexen
Sponsored by: DARPA, AFRL
the DMAP region on arm64.
We already have the needed information to build these tables, we just need
to extract it. This significantly simplifies the code.
Obtained from: ABT Systems Ltd
Sponsored by: Turing Robotic Industries
set. This memory must not be mapped by the operating system other than
under control of the device driver.
Obtained from: ABT Systems Ltd
Sponsored by: Turing Robotic Industries
The core clock (armclk) on RockChip SoC is special.
It can derive it's clock from many PLLs but RockChip recommand to do it
from "apll" on old SoC and "npll" on new SoC. The reason for choosing npll
is that it's have less jitter and is more close to the arm core on the SoC.
r333314 added the core clock as a composite clock but due to it's specials
property we need to deal with it differently.
A new rk_clk_armclk type is added for this and it supports only the "npll"
as we don't run on old RockChip SoC that only have the "apll".
It will always reparent to "npll" and set the frequency according to a rate
table that is known to be good.
For now we set the "npll" to the desired frequency and just set the core clk
divider to 1 as its parent it just used for the core clk.
Its absence meant that GEOM direct dispatch was disabled (the service
routines check the current thread's stack usage to determine whether
to hand off the request to a dedicated thread), and this change is
sufficient to enable direct dispatch by default.
Reviewed by: allanjude
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D15527
lists in the EFI memory map. As such we need to reduce the mappings to
restrict them to not be the full 1G block. For now reduce this to a 2M
block, however this may be further restricted to be 4k page aligned as
other SoCs may require.
This allows ThunderX2 to boot reliably to userspace without performing
any speculative memory accesses to invalid physical memory.
Sponsored by: DARPA, AFRL
On some arm64 boards we need to access memory in ACPI tables that is not
mapped in the DMAP region. To handle this create the needed mappings in
pmap_mapbios in the KVA space.
Submitted by: Michal Stanek (mst@semihalf.com)
Sponsored by: Cavium
Differential Revision: https://reviews.freebsd.org/D15059
The main advantage of this is to allow us to exclude memory from being
used by the kernel. This may be from the memreserve property, or ranges
marked as no-map under the reserved-memory node.
More work is still needed to remove the physmap array. This is still used
for creating the DMAP region, however other patches need to be committed
before we can remove this.
Obtained from: ABT Systems Ltd
Sponsored by: Turing Robotic Industries
This turns on support for kernel dump encryption and compression, and
netdump. arm and mips platforms are omitted for now, since they are more
constrained and don't benefit as much from these features.
Reviewed by: cem, manu, rgrimes
Tested by: manu (arm64)
Relnotes: yes
Differential Revision: https://reviews.freebsd.org/D15465
This change updates arm, arm64 and mips achitectures. Additionally, it
removes redundant checks for kdb_active where it already results in
kdb_reenter() and adds kdb_reenter() calls where they were missing.
Some architectures check the return value of kdb_trap(), but some don't.
I haven't changed any of that.
Some trap handling routines have a return code. I am not sure if I
provided correct ones for returns after kdb_reenter(). kdb_reenter
should never return unless kdb_jmpbufp is NULL for some reason.
Only compile tested for all affected architectures. There can be bugs
resulting from my poor understanding of architecture specific details.
Reported by: jhb
Reviewed by: jhb, eadler
MFC after: 4 weeks
Differential Revision: https://reviews.freebsd.org/D15431
already close to the limit so increasing the kernel size may cause it to
fail to boot when it runs past the end of allocated memory.
Reported by: manu
Sponsored by: DARPA, AFRL
It is useful to enter kdb with an escape sequence.
While here move the USB_DEBUG with the others debug options and define
nooptions USB_DEBUG for GENERIC-NODEBUG
Add support for setting pll rate. On RockChip SoC two kind of plls are
supported, integer mode and fractional mode.
The two modes are intended to support more frequencies for the core plls.
While here change the recalc method as it appears that the datasheet is
wrong on the calculation method.
Add the clock definition for the arm clock.
While here remove the indexes in the clock table as we will need clock
with a 0 index (non-exported clocks).
Dumpers may wish to print messages from an initialization hook; this
change ensures that such messages aren't mixed with output from the
generic dump code.
MFC after: 1 week
Add a driver that match on 'rockchip,gpio-bank', this compatible
string is found on almost all RockChip SoC so this driver is compatible
with almost all of the RockChip SoCs.
The only features missing for this driver are :
- Interrupts support
- Debouncing
Add pinctrl driver for RockChip SoCs. This device manage which function
to set on which pin and some other properties like pull up/down, drive
strength etc ...
For now the driver only support RK3328 but it is versatile enough to
add support for other RockChip SoC in the future.
RockChip GRF (General Register Files) is present on almost all RockChip
SoC and is used to control some area of the system like iomuxing, gpio
or usb phy.
We need it to be probed and attached early in the boot process so
subclass syscon_generic and set the pass to BUS_PASS_BUS + BUS_PASS_ORDER_MIDDLE.
This is the first step (after the recent refactoring of some common
code) to supporting the Linuxulator on arm64.
Reviewed by: andrew
Sponsored by: Turing Robotic Industries Inc.
Differential Revision: https://reviews.freebsd.org/D15187
Half of implementations always failed (returned (-1)) and they were
previously used in only one place.
Reviewed by: kib, andrew
Obtained from: CheriBSD
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D15102
opt_compat.h is mentioned in nearly 180 files. In-progress network
driver compabibility improvements may add over 100 more so this is
closer to "just about everywhere" than "only some files" per the
guidance in sys/conf/options.
Keep COMPAT_LINUX32 in opt_compat.h as it is confined to a subset of
sys/compat/linux/*.c. A fake _COMPAT_LINUX option ensure opt_compat.h
is created on all architectures.
Move COMPAT_LINUXKPI to opt_dontuse.h as it is only used to control the
set of compiled files.
Reviewed by: kib, cem, jhb, jtl
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D14941
ARM Coresight is a solution for debug and trace of complex SoC designs.
This includes a collection of drivers for ARM Coresight interconnect
devices within a small Coresight framework.
Supported devices are:
o Embedded Trace Macrocell v4 (ETMv4)
o Funnel
o Dynamic Replicator
o Trace Memory Controller (TMC)
o CPU debug module
Devices are connected to each other internally in SoC and the
configuration of each device endpoints is described in FDT.
Typical trace flow (as found on Qualcomm Snapdragon 410e):
CPU0 -> ETM0 -> funnel1 -> funnel0 -> ETF -> replicator -> ETR -> DRAM
CPU1 -> ETM1 -^
CPU2 -> ETM2 -^
CPU3 -> ETM3 -^
Note that both Embedded Trace FIFO (ETF) and Embedded Trace Router (ETR)
are hardware configurations of TMC.
This is required for upcoming HWPMC tracing support.
This is tested on single-core system only.
Reviewed by: andrew (partially)
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D14618
Make kdb_trap in breakpoint exception handler conditional. If "options KDB"
is not present just panic with message that debugger is not enabled.
PR: 224653
