The prior change to not enable LRO by default has confused several
people. The configurations where LRO is problematic is not the
typical use case for VirtIO, and due to other issues, this often
requires checksum offloading to be disabled anyways.
PR: 185864
MFC after: 2 weeks
- Support the KDB alt break sequence to enter the debugger,
panic, reboot, etc. [1]
- Provide emergency write feature description. Note that QEMU
does not implement this feature.
- Make the VTCON_FLAG_* defines sequential once again.
- When the multiple port feature is not negotiated, query the
rows and columns of the one console during the device attach
when the size feature is negotiated.
- Report failure to the device if hot plugging a port fails.
- Acknowledge the console port event with an open event. This
is required by the spec, but QEMU doesn't seem to care.
Submitted by: Juniper [1]
MFC after: 1 month
Support for the multiport feature is mostly implemented, but currently
disabled due to some potential races in the hot plug code paths.
Requested by: marcel
MFC after: 1 month
Relnotes: yes
- Do not accumulate statistics on every tick.
- Accumulate statistics in vtnet_setup_stat_sysctl()
and in vtnet_get_counter().
Sponsored by: Netflix
Sponsored by: Nginx, Inc.
Mostly bugfixes or features developed in the past 6 months,
so this is a 10.1 candidate.
Basically no user API changes (some bugfixes in sys/net/netmap_user.h).
In detail:
1. netmap support for virtio-net, including in netmap mode.
Under bhyve and with a netmap backend [2] we reach over 1Mpps
with standard APIs (e.g. libpcap), and 5-8 Mpps in netmap mode.
2. (kernel) add support for multiple memory allocators, so we can
better partition physical and virtual interfaces giving access
to separate users. The most visible effect is one additional
argument to the various kernel functions to compute buffer
addresses. All netmap-supported drivers are affected, but changes
are mechanical and trivial
3. (kernel) simplify the prototype for *txsync() and *rxsync()
driver methods. All netmap drivers affected, changes mostly mechanical.
4. add support for netmap-monitor ports. Think of it as a mirroring
port on a physical switch: a netmap monitor port replicates traffic
present on the main port. Restrictions apply. Drive carefully.
5. if_lem.c: support for various paravirtualization features,
experimental and disabled by default.
Most of these are described in our ANCS'13 paper [1].
Paravirtualized support in netmap mode is new, and beats the
numbers in the paper by a large factor (under qemu-kvm,
we measured gues-host throughput up to 10-12 Mpps).
A lot of refactoring and additional documentation in the files
in sys/dev/netmap, but apart from #2 and #3 above, almost nothing
of this stuff is visible to other kernel parts.
Example programs in tools/tools/netmap have been updated with bugfixes
and to support more of the existing features.
This is meant to go into 10.1 so we plan an MFC before the Aug.22 deadline.
A lot of this code has been contributed by my colleagues at UNIPI,
including Giuseppe Lettieri, Vincenzo Maffione, Stefano Garzarella.
MFC after: 3 days.
The Tx interrupt is now kept disabled in the common case, only
enabled when the number of free descriptors in the queue falls
below a threshold. Transmitted frames are cleared from the VQ
before subsequent transmit, or in the watchdog timer.
This was a very big performance improvement for an experimental
Netmap bhyve backend.
MFC after: 1 month
Prevent the Xen and VirtIO balloon drivers from marking pages as
wired. This prevents them from increasing the system wired page count,
which can lead to mlock failing because of hitting the limit in
vm.max_wired.
In the Xen case make sure pages are zeroed before giving them back to
the hypervisor, or else we might be leaking data. Also remove the
balloon_{append/retrieve} and link pages directly into the
ballooned_pages queue using the plinks.q field in the page struct.
Sponsored by: Citrix Systems R&D
Reviewed by: kib, bryanv
Approved by: gibbs
dev/virtio/balloon/virtio_balloon.c:
- Don't allocate pages with VM_ALLOC_WIRED.
dev/xen/balloon/balloon.c:
- Don't allocate pages with VM_ALLOC_WIRED.
- Make sure pages are zeroed before giving them back to the
hypervisor.
- Remove the balloon_entry struct and the balloon_{append/retrieve}
functions and use the page plinks.q entry to link the pages
directly into the ballooned_pages queue.
the queue where to enqueue pages that are going to be unwired.
- Add stronger checks to the enqueue/dequeue for the pagequeues when
adding and removing pages to them.
Of course, for unmanaged pages the queue parameter of vm_page_unwire() will
be ignored, just as the active parameter today.
This makes adding new pagequeues quicker.
This change effectively modifies the KPI. __FreeBSD_version will be,
however, bumped just when the full cache of free pages will be
evicted.
Sponsored by: EMC / Isilon storage division
Reviewed by: alc
Tested by: pho
The header structure consists of two 1-byte elements, but it must always
be describable by a single SG entry. Note for consistency, specify the
alignment everywhere, even if the structure has the appropriate natural
alignment since it contains a uint16_t.
Obtained from: DragonFlyBSD
MFC after: 1 week
These defines are applicable to userland too, but virtqueue.h contains
the kernel virtqueue interface, and is therefore not usable in userland.
Note that Linux places these defines in virtio_ring.h, but I don't want
the drivers including this header file to keep the VirtIO ring opaque to
everything but the virtqueue.
MFC after: 1 week
The eventual goal is to share this file with userland, so
remove the macro that is only specific for virtio_pci(4).
Instead, add the VIRTIO_PCI_CONFIG_OFF macro from Linux to
get the config size whether MSIX is enabled or not.
MFC after: 1 week
A similar fix should be applied to vmxnet, ixgbe, igb, i40e.
(some of them previously reported by Michael Tuexen)
Drivers using if_transmit are correct, and so are most of the
other drivers that reassing if_transmit.
Among other things, this bug causes panics when using netmap emulation
on top of generic drivers.
Approved by: bryanv
MFC after: 3 days
Reorganize the previous contexts of the file as it is in Linux. The
eventual goal is to install the header files and share them between
the kernel and bhyve.
MFC after: 1 week
interface, in the r241616 a crutch was provided. It didn't work well, and
finally we decided that it is time to break ABI and simply make if_baudrate
a 64-bit value. Meanwhile, the entire struct if_data was reviewed.
o Remove the if_baudrate_pf crutch.
o Make all fields of struct if_data fixed machine independent size. The
notion of data (packet counters, etc) are by no means MD. And it is a
bug that on amd64 we've got a 64-bit counters, while on i386 32-bit,
which at modern speeds overflow within a second.
This also removes quite a lot of COMPAT_FREEBSD32 code.
o Give 16 bit for the ifi_datalen field. This field was provided to
make future changes to if_data less ABI breaking. Unfortunately the
8 bit size of it had effectively limited sizeof if_data to 256 bytes.
o Give 32 bits to ifi_mtu and ifi_metric.
o Give 64 bits to the rest of fields, since they are counters.
__FreeBSD_version bumped.
Discussed with: emax
Sponsored by: Netflix
Sponsored by: Nginx, Inc.
The sglist segment array has grown to a bit over 512 bytes (on
64-bit system) which is more than ideally should be put on the
stack. Instead allocate an appropriately sized sglist and hang
it off each Rx/Tx queue structure.
Bump the maximum number of Tx segments to 64 to make it unlikely
we'll have defragment an mbuf chain. Our previous count was
rounded up to this value since it is the next power of two, so
effective memory usage should not change.
Also only allocate the maximum number of Tx segments if TSO was
negotiated.
to this event, adding if_var.h to files that do need it. Also, include
all includes that now are included due to implicit pollution via if_var.h
Sponsored by: Netflix
Sponsored by: Nginx, Inc.
This is a significant rewrite of much of the previous driver; lots of
misc. cleanup was also performed, and support for a few other minor
features was also added.
Partial support for the EVENT_IDX feature was added a while ago,
but this commit adds an interface for the device driver to hint
how long (in terms of descriptors) the next interrupt should be
delayed.
The first user of this will be used to reduce VirtIO net's Tx
completion interrupts.
additional information, when the page is guaranteed to not belong to a
paging queue. Usually, this results in a lot of type casts which make
reasoning about the code correctness harder.
Sometimes m->object is used instead of pageq, which could cause real
and confusing bugs if non-NULL m->object is leaked. See r141955 and
r253140 for examples.
Change the pageq member into a union containing explicitly-typed
members. Use them instead of type-punning or abusing m->object in x86
pmaps, uma and vm_page_alloc_contig().
Requested and reviewed by: alc
Sponsored by: The FreeBSD Foundation
r252680:
Fix SIM lock not owned panic
The CAM locking requirements of registering an async
callback has changed so the SIM lock must be held. Remove
code that explicitly dropped the lock around the register.
Also return CAM_SEL_TIMEOUT instead of CAM_TID_INVALID
for bad targets to avoid a lot console spam during bus
scans.
MFC after: 1 month
