- so_pcb is now guaranteed to be non-NULL and valid if a valid socket
reference is held.
- Need to check INP_TIMEWAIT and INP_DROPPED before assuming inp_ppcb is a
tcpcb, as it might be a tcptw or NULL otherwise.
- tp can never be NULL by the end of the function, so only check
TCPS_ESTABLISHED before extracting tcpcb fields.
The NFS server arguably incorporates too many assumptions about TCP
internals, but fixing that is left for nother day.
MFC after: 1 week
Reviewed by: bz
Reviewed and tested by: rmacklem
Sponsored by: Juniper Networks
Also disable relaxed ordering as recommended by data sheet for
PCI-X devices. For PCI-X BCM5704, set maximum outstanding split
transactions to 0 as indicated by data sheet.
For BCM5703 in PCI-X mode, DMA read watermark should be less than
or equal to maximum read byte count configuration. Enforce this
limitation in DMA read watermark configuration.
chip revision often found in the blades and resulting in interfaces
not sensing carrier signal. Looking at all problem reports it
appears that it only affects some very specific silicon revision
(ASIC (0x57081021); Rev (B2)) and version of the PHY that
supports 1000baseSX-FDX media only. Therefore, narrow the scope of
workaround to combination of that revision and media type. Given
that the first report on this issue is dated back to 2007, there is
not much hope that this issue will ever be properly resolved.
Among affected systems are IBM HS21, Intel SBXD132 and HP BL460c.
PR: 118238, 122551, 140970
MFC after: 1 month
These header files only provide functionality that can be used in
combination with libcompat. In order to prevent people from including
them without any actual use (which happens a lot with <sys/timeb.h>),
put a warning here to make people more aware.
This means we have to lower WARNS for libcompat, which is no big deal.
are referenced directly from ivar pointer. It's to do like what other
buses do. [1]
o changes exported prototypes. It doesn't use struct siba_* structures
anymore that instead of it it uses only device_t.
o removes duplicate code and debug messages.
o style(9)
Pointed out by: imp [1]
Setting the new sysctl MIB "debug.acpi.enable_debug_objects" to a non-zero
value enables us to print Debug object when something is written to it.
- Allow users to disable interpreter slack mode. Setting the new tunable
"debug.acpi.interpreter_slack" to zero disables some workarounds for common
BIOS mistakes and enables strict ACPI implementations by the specification.
processors. With this workaround, superpage promotion can be re-enabled
under virtualization. Moreover, machine check exceptions can safely be
enabled when FreeBSD is running natively on Family 10h processors.
Most of the credit should go to Andriy Gapon for diagnosing the error and
working with Borislav Petkov at AMD to document it. Andriy also reviewed
and tested my patches.
Discussed with: jhb
MFC after: 3 weeks
counting in incrementing the interrupt nesting level. This fixes a number
of bugs in which the interrupt thread could be preempted by an IPI,
indefinitely delaying acknowledgement of the interrupt to the PIC, causing
interrupt starvation and hangs.
Reported by: linimon
Reviewed by: marcel, jhb
MFC after: 1 week
allow for connection load balancing across interfaces. Currently
the address alias handling method is colliding with the ECMP code.
For example, when two interfaces are configured on the same prefix,
only one prefix route is installed. So connection load balancing
among the available interfaces is not possible.
The other advantage of ECMP is for failover. The issue with the
current code, is that the interface link-state is not reflected
in the route entry. For example, if there are two interfaces on
the same prefix, the cable on one interface is unplugged, new and
existing connections should switch over to the other interface.
This is not done today and packets go into a black hole.
Also, there is a small bug in the kernel where deleting ECMP routes
in the userland will always return an error even though the command
is successfully executed.
MFC after: 5 days
pmc_flush_logfile is now non-blocking and just ask the kernel
to shutdown the file. From that point, no more data is
accepted by the log thread and when the last buffer is flushed
the file is closed.
This will remove a deadlock between pmcstat asking for
flush while it cannot flush the pipe itself.
MFC after: 3 days
to not leak them, otherwise making UMA/vmstat unhappy with every stoped vnet.
We will still leak pages (especially for zones marked NOFREE).
Reshuffle cleanup order in tcp_destroy() to get rid of what we can
easily free first.
Sponsored by: ISPsystem
Reviewed by: rwatson
MFC after: 5 days
